Given following phantom loads identified in a house, find the energy can be saw annually if the phantom loads can be shut off completely. 2 laptop computers 15W/hour each 10W/hour each 3TVS 5 cell phone chargers 1W/hour each 1 Stereo 3W/hour

Given following phantom loads identified in a house, find the energy can be saw annually if the phantom loads can be shut off completely. 2 laptop computers 15W/hour each 10W/hour each 3TVS 5 cell phone chargers 1W/hour each 1 Stereo 3W/hour

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 34RQ: What is the Btu/hour output of an electric heater rated at 15 kilowatts? a. 51.15 Btu/hour b. 51,150...

See similar textbooks

Related questions

Q: HOME WORK For the simple distribution system shown in Figure below, use the probabilistic approach t...

A: The given figure is shown below:

Q: The rms value of a half - wave rectified sine wave is 100 amp. The value for full wave rectification...

Q: Does the motor armature current(Im) change when the speed (n) is increase?

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: 7. In figure shown below, i= 42 mA sin (377t – 40). The capacitance is 1 µF. Find the sinusoidal exp...

Q: A circuit has a total resistance of 473,332 Ω and draws 4.4 mA. The best expression for the voltage ...

A: Total resistance RT = 473,332 ohms Current drawn I = 4.4 mA Expression for the voltage of the sourc...

Q: Grounding methods in Power systems

A: Grounding is necessary in power system to avoid the risk of electrical shock. It also helps in volta...

Q: 1 + 0.3z-1 + 0.5z-2 X(z) = 1+ 0.8z-1 + 0.15z-2

Q: Two identical devices are connected in the circuit shown in Fig.1. Note the configuration of A and B...

A: We have to find the D element values and then solve the given circuit to find power delivered by dep...

Q: 3.Draw the logic diagram of a 5-bit parallel binary adder using a combinationof half adders and full...

A: There are two inputs A and B. The five bit of A input a4,a3,a2,a1,a0 and b4,b3,b2,b1,b0.The five bit...

Q: The rotor of an 8-pole, 50-Hz, 3-phase induction motor has a resistance of 0.2 Q/phase and runs at 7...

Q: wer factor. Find the KVAR size of paralleled with this motor to brin

Q: We want to design a battery pack, for lack of a better description, that is big enough to supply cur...

A: Battery Pack- The term battery pack define as a set of batteries connected in series or in parallel....

Q: 46-50) Use the BJT network below: (Use Exact Analysis) Vcc = 24V VBE1 = VBE2 = 0.7V B, = 80 B2 = 100...

Q: Forward Blas Condition: (injected minority current - due to holes crossing the junction and entering...

A: Diode is an uncontrolled Device in which their ON and OFF state can't be controlled by us. When the ...

Q: ohms. Find the resistance

Q: Q For the circuit shown calculate (a) the current drawn from the source, (b) the p.d. across each re...

A: This question belongs to circuit theory . It is based on the concept of calculation of current and v...

Q: A coil of 100 turns is linked by a flux of 10 mWb. If the flux is reversed in 2 ms, find the average...

Q: The three charged particles in the figure below are at the vertices of an isosceles triangle (where ...

A: We need to find out electric potential at given point due to given charge distribution.

Q: which type of overload relays connect a coil in series with the conductors supplying power to the mo...

A: "Thermal overload relays" connect a coil in series with the conductors supplying power to the motor....

Q: Discuss the difference between resonant and nonresonant circuits

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. Current flows i...

Q: The net cross section of a transformer is 20 square inches. The maximum flux density is 1.1 Wb/m2.Th...

Q: 5. Determine whether the points of equilibrium P, and P, in Fig. 2.21(a) and Pg and P, in Fig. 2.21(...

A: Stability means even though there is change in motor speed , motor tries to come to stable point wit...

Q: Take a graph sheet and divide it into 4 equal parts. Mark origin at the center of the graph sheet. N...

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for ...

Q: Solve for the electric network 120 12V 200 10V 150 find the values of each current across each resis...

Q: Determine developed torque and shaft torque of 300-V, 4-pole series motor with 680 conductors wave- ...

A: It is given that: V=300 VP=4 polesZ=680 conductorsWave-connected=A=2Pout=8 KW=8×103 WIa=40 Aϕ=25 mWb...

Q: which section of the overload relay is typically connected to voltages that range from 120 to 600 vo...

A: "CURRENT SENSING SECTION" of the overload relay is typically connected to the voltages that range fr...

Q: SOLVE THE FOLLOWING PROBLEMS COMPLETELY Draw a circuit that will produce a total resistance of 1...

A: Explanation is given in step -2

Q: How can a bus architecture manage multiple computers transmitting at once?

A: The real world demands the analysis and design of complex systems. It is possible with the clear und...

Q: H2 RCS) G2 G3 Gy -YCS) Simplify the following using Suitable Rules. block diagram

Q: Determine ID (in mA) for the network. + 8 V 1.2 k2 4.7 k2 Si -6 V

Q: Given that a 60W incandescent light bulb is on for 10 hours per day, find the following: a. What is ...

A: A bulb is similar to a resistive load which absorb active power from the input and dissipates heat i...

Q: The type of digital filter that implements filtering using placement of pole and zero of the functio...

A: IIR filter ( infinite impulse response filter ), can give impulse response for an infinite duration....

Q: Use superposition theorem to find Vx in the circuit

A: In this question, We need to determine the voltage Vx using the super position theorems. Here 2 in...

Q: Let A = 4ax + 2ay - az and B = ax + ay + 3az If A and B are parallel, find and If A and B are pe...

Q: ) Determine the all-day efficiency of a 50 kVA distribution transformer having a full load efficienc...

Q: What will be the Magnetic field value at the center of a current-carrying coil?

A: Please refer the attached images for the complete answer..

Q: Question 1: The parameters of the transistor are Is =5 x 10-16 A, nVT = 26 mV VC= 1.8 V and B = 90. ...

A: In this question, We need to calculate the all unknown parameters? If dc current gain = 90 Collect...

Q: b.) For the network shown below: a. Determine Zi and Zo b. Find Av c. Repeat parts (a) and (b) with ...

A: We need to find out input, output impedance and gain for given circuit

Q: Find the coefficient of coupling between two coils whose mutual inductance is 1 H and self-inductanc...

Q: Let vectors A=10ax-6ay+8az and B=ax+2az, Find: (a) A • B (b) A x B (c) 2A - 3B

A: Use basic vector algebra rules to find the unknown values .

Q: Table 4.1 1. 2. 3 4. 6. 7. 10 Vz (V) V (V) z (mA) 2010 0.003. O61.2 8e 0.4u131 235 3.3 4.33

Q: D

Q: H.W. (1) The current through a 5 2 resistor is i = 40 sin(377t +30°). Find the sinusoidal expression...

Q: 9 Fund veH. 4. 4A

Q: (3) Determine the minimum transmission bandwidth required to transmit the following signals: 9,(t) 2...

Q: For an op-amp having a slew rate of SR = 4 V/us, what is the maximum closed-loop voltage gain that c...

Q: Consider a family of logic gates that operate under the static disci

A: given values VI=1.5V ,VOL=0.5V, VIH =3.5V, and VOH=4.4V then the ouput voltage as

Q: 3) The losses in a 20 kVA, 2000/250 V transformer are as follows: Iron loss = 300 W, Full load coppe...

Q: Problem 3: + V, , - V, + 80 20 3 A 60 V2 5A In the circuit above, solve for the parameters defined. ...

Q: The following are connected in parallel across a 300 V, 50 hz source: 80 A at 0.82 pf inductive; 65 ...

A: The circuit arrangement can be drawn as I→ext=I→1+I→2+I→3+I→4+I→aI→ext=80∠-cos-10.83+65∠cos-10.75+4...

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Given following phantom loads identified in a house, find the energy can be saved
annually if the phantom loads can be shut off completely.
2 laptop computers
3TVS
15W/hour each
10W/hour each
5 cell phone chargers
1W/hour each
1 Stereo
3W/hour

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An 80-gallon electric water heater has 60F (15.56C) incoming water. How many minutes can a 3-gallon/minute showerhead be used to draw 105F (40.56C) water if the water heater thermostat is set at 120F (48.89C)?
The lightbulbs used in your car headlights each have an average power output of 55-watts. You are driving at night from Columbus to Birmingham, which takes you 2.75 hours to complete. If you have your headlights on during the entire trip, how much work do each of the headlights produce?
Q: Suppose that a fork lifter has a total energy consumption of 150 W.Hr. The total trips of the vehicle are 375. How the battery duty cycle may be calculated in this case?
A 30 x 30 x 30 m room is installed with a fan designed to supplyair every second. If the losses due to ducting is measured at0.15 m, determine the required power of the fan in Watts.
Calculate the average load on a steam power station which spends (47x10°) IDQ (Iraqi Dinar) per year for fuel used in the station. The calorific value of 5000 kcal/kg and its price is (4700) IDQ per ton. The thermal efficiency of the station is 35% while electrical efficiency is 85%.
4. Calculate the monthly power consumption of a classroom with ten bulbs at 100W/bulb?Assumptions: all bulbs will turn on and off at the same timeThe bulbs will light up for 4 hours a day for 30 days a month.5. What is the total heat loss through a triple glazing (U-value: 1.3) window with an area of 2m2 on a day when the outdoor and indoor temperatures are 5 C and 20 C, respectively? 6. If solar radiation intensity is 700 W/m2 in NJ, how much solar energy arrives at a solarcollector with an area of 2 m2 in 12 hours? If the solar collector can convert 33% of solarenergy collected to electricity, how much electricity (kWh) will be generated?
Question 5 A natural gas plant with a 50MW operates at an average loading of 75% year round. How many kWh does the plant to supply to the grid? Question 6 For Question 5, the natural gas power plant costs $175,000,000 to build and costs $20M a year to operate. What is the average cost per kWh or MWh for the power produced if the estimated plant life is 20 years? Assume a discount rate of 5%.
A room 20 ft. by 30 ft. is illuminated by five 200 watt, 3700 lumen incandescent lamps. The average illumination intensity at the working plane as measured by a footcandle meter is 10 lumen per sq. ft.. Calculate the utilization factor of the lamps. a. 0.23 b. 0.56 c. 0.45 d. 0.23
A colliery workshop 20mx10m requires an averageillumination of 135 lm/m 2 on the working plane. Allow acoefficient of utilization of 0.45 and a depreciation factor of1.4. The supply is 230-V at 50Hz and the efficiency of each ofthe lamps is 12 lm/W.16. Calculate the electrical power required for thepurpose.A. 8 kW B. 4 kW C. 3 kW D. 7 kW17. Calculate the current required for the purpose.A. 34.3 A B. 21.2 A C. 26.9 A D. 30.4 A
A hydro-electric station has an average available head of 100 meters and reservoir capacityof 50 million cubic meters. Calculate the total energy in kWh that can be generated, assuminghydraulic efficiency of 85% and electrical efficiency of 90%.
A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. determine the load current. Answer = 108 A
A hydro-electric generating station is supplied from a reservoir of capacity 5x10^7 cubic metres at a head of 250 metres. Find the total energy available in kWh if the overall efficiency is 70% note: please solve that clear answer.