Hang a weight at rest at position B. Then raise it to position A and release. The lowest position it reaches is C. (During this vibration, the spring has only been stretched, never compressed.) Then sketch a force diagram for the block at positions A, B, C, B, and then A again, as it moves through a complete vibration cycle. Your arrow sizes should reflect which force is the largest. Check with your group members and make some adjustment.

Hang a weight at rest at position B. Then raise it to position A and release. The lowest position it reaches is C. (During this vibration, the spring has only been stretched, never compressed.) Then sketch a force diagram for the block at positions A, B, C, B, and then A again, as it moves through a complete vibration cycle. Your arrow sizes should reflect which force is the largest. Check with your group members and make some adjustment.

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter3: Oscillations

Section: Chapter Questions

Problem 3.31P

See similar textbooks

Related questions

Q: A horizontal block spring oscillator of mass 10 kg on a frictionless table and spring constant…

A: Let m be the mass of the block, and k be the spring constant of the spring. Assume x to be the…

Q: Two springs of force constants k1 and k2 are attached to a block of mass m and to fixed supports as…

Q: On the picture that is shown below, what is the maximum angle that can be formed by the pendulum…

A: Given: The mass of the bullet is 20 g = 0.02 kg. { 1 g = 0.001 kg The initial…

Q: What is the leg stiffness if the center of mass displacement is 10 cm and the peak vertical force is…

Q: A glider attached to one end of a string oscillates given by the displacement function *(1)…

A: Given: The euqation of the displacement of the object. xt=0.03cos4t…

Q: A mass is hanging from the ceiling on a spring and oscillating (forever, and without friction). At…

A: Given: At highest point, y = 12 cm At lowest point, y = 6 cm Time period = 0.5 sec at t=0, mass is…

Q: Determine the smallest stiffness k which is required to shoot the ball a maximum distance of 31 in.…

Q: For each of the images, note where the oscillating system has the greatest kinetic energy, and where…

A: The pendulum has highest kinetic energy at the middle of the oscillation and highest potential at…

Q: A 4.020-gram bullet is projected horizontally to a block of timber that rest on a horizontal floor.…

A: Given: The mass of the bullet is 4.020 g. The maximum displacement is 0.05 m. The spring constant is…

Q: A mass attached to a spring is pulled downward and released. The displacement of the mass from its…

Q: How are the amplitude, frequency, and phase of a steady-state vibration related to those of the…

A: Undamped motion: The oscillatory motion of a body in case of zero external or internal resistance is…

Q: Since the speed is not 0 when the block is pushed away from the spring, how can we know if the block…

Q: For the following forcing inputs, assume u(0) = 0 and u(0)=0. Use Duhamel's Integral to find the…

A: For the given question, it is suggested we use principle of superposition. This states that The…

Q: Mass is attached to a spring and set to oscillate horizontally on a frictionless surface. At what…

A: As per our guidelines, we are supposed to answer only first three subparts in case of multiple…

Q: In the case of a damped pendulum, how would the dyanmics change as a fixed point varied from being a…

A: In this question we will talk about the phenomena of damping of pendulum.

Q: A measure of how fast the block shown below will oscillate when the system is set in motion is given…

Q: Consider a plot of the spring's compression ) as a function of the magnitude of the applied force…

A: The amount of force required to compress a spring whose spring constant is 'k' by a distance 'x' is…

Q: A 4.020-gram bullet is projected horizontally to a block of timber that rest on a horizontal floor.…

A: The maximum displacement of the block is when the kinetic energy of bullet was completely…

Q: The mass on the end of a pendulum is 0.04 kg and hangs from a string of length 1.2 m. The pendulum…

Q: Problems 5 & 6 refer to the mass-spring oscillator depicted in the figure on the right. The block…

A: Mass of the block, m = 0.35 kg Spring constant, k = 45 N/m Initial position at time t = 0 is -20 cm…

Q: A jumper with a leg stiffness of 38000 N/m exerts a peak force of 4360 N. What was the center of…

Q: If left to freely oscillate, a system will vibrate at a natural frequency that depends on the system…

A: Assume that the atoms in the beam are connected by a massless spring. The spring connects the ends…

Q: The mass on the end of a pendulum is 0.04 kg and hangs from a string of length 1.2 m. The pendulum…

Q: When the 0.1-kg body is in the position shown, the linear spring is stretched 10 mm. Determine the…

Q: (e) À mass m hangs on a string of length / from a rigid support. The mass is pulled aside, so that…

Q: uppose the spring constant of a simple harmonic oscillator of mass 145 g is increased by a factor of…

Q: When you stand on a trampoline, the surface depresses below equilibrium, and the surface pushes up…

A: Write the variable with the given values. The restoring force is given as, Here, k denotes the…

Q: Calculate the velocity of a simple harmonic oscillator with amplitude of 11.8 cm and frequency of 5…

A: We need to calculate the velocity of the simple harmonic oscillator at a distance of 5 cm from the…

Q: As seen in the first part of the diagram above, a 0.50kg thin rod of 2.0m in length is suspended…

A: Given, mass of the rod=0.5 kg mass of the clay=0.2 kg velocity of the ball=3.75 m/s g=9.8m/s2 length…

Q: Consider the following perfectly aligned two-spring system. It is restrained from motion at point 1,…

A: Given the system is a two spring a three degree of freedom system. For the given system let’s write…

Q: In the figure below is a simple pendulum with the mass of the bob is M, the length of the pendulum…

Q: When the system shown in the diagram is in equilibrium, the rigth spring is stretched by 1 cm. The…

A: In a system, if we consider a force that is applied from external sources, then if that system does…

Q: k1 Con si der the sy stem shown in the diagram, which consi st s of two springs with constants k and…

A: If a mass m is attached to a spring with spring constant k and is displaced from the equilibrium…

Q: The figure shows a bar suspended from a pivot ? with a calibrated spring attaching the bar to the…

A: Write an expression using equilibrium condition of force in the x-direction

Q: A 0.32 kg harmonic oscillator has a total mechanical energy of 4.1 J. If the oscillation amplitude…

Q: For a simple harmonic oscillator with x = A sin ot write down an expression for the velocity. Please…

A: Given Expression for position of oscillator x = A sin ωt Velocity ; V = dx/dt = d ( A sin…

Q: For a simple harmonic oscillator with x=Asinωtx=Asin⁡ωt write down an expression for the velocity.…

A: We have a harmonic oscillator which is described by a solution x=Asinwt where A represents the…

Q: In the depicted system in fig1 a uniform disk with moment of inertia J which is attached to a damper…

Q: A particle of mass m slides without friction inside a hemispherical bowl of radius R. Show that if…

Q: The system in the figure below is in equilibrium, and its free body diagram drawn on the right. The…

A: The relaxed length of springs, l0 = 0.57 m The mass attached at point P, m = 0.86 kg The distance…

Q: The distance of a swinging pendulum from its resting position is given by the function d(t) =…

Concept explainers

Spring Potential Energy

The potential energy is the energy possessed by a body by virtue of its position or the energy held by the object due to its position relative to other objects, its force like stresses, charge, and other factors affecting the particles of the body. The potential energy is the measure of the net work done by or on the body. The spring potential energy is the potential energy stored due to the deformation of an elastic spring and this elasticity is due to the stretched spring. The elasticity is the ability of a solid-state matter to come back to its equilibrium position or original position after any kind of external force is acted on it. It is also known as Elastic potential energy. The potential energy here is caused due to the displacement of the spring from its equilibrium position to another position and this potential energy is equal to the net work done due to the stretching of the spring. It also resembles the same mechanics of the oscillation of a simple pendulum, where due to the external force, the object moves from its equilibrium position to its maximum ends and the periodic motion continues till it comes back to the equilibrium position to rest. 

Question

100%

Hang a weight at rest at position B. Then raise it to position A and release. The lowest position it reaches is C. (During this vibration, the spring has only been stretched, never compressed.)

Then sketch a force diagram for the block at positions A, B, C, B, and then A again, as it moves through a complete vibration cycle. Your arrow sizes should reflect which force is the largest. Check with your group members and make some adjustment.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Trending now

This is a popular solution!

Step by step

Solved in 8 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Allow the motion in the preceding problem to take place in a resisting medium. After oscillating for 10 s, the maximum amplitude decreases to half the initial value. Calculate (a) the damping parameter β, (b) the frequency υ1 (compare with the undamped frequency υ0), and (c) the decrement of the motion.
Obtain the response of a linear oscillator to a step function and to an impulse function (in the limit τ → 0) for overdamping. Sketch the response functions.
In the case of a damped pendulum, how would the dyanmics change as a fixed point varied from being a stable spiral, to a stable degenerate node, to a stable node? I know that all the trajectories continue to lose altitude, and that the pendulum goes from whirling clockwise over the top, loses energy, settles to a small oscillation, and eventually comes to rest at the bottom, but wasn't sure if this general description changes based on the variation of fixed points.
Since the speed is not 0 when the block is pushed away from the spring, how can we know if the block stops in the section CD, or if it passes this section and go in the ramp and then back again in direction to the spring? could the block go back and forward a few times before a complete stop somewhere in the CD section?
If left to freely oscillate, a system will vibrate at a natural frequency that depends on the system itself, not on the initial push or stimulus that we impart. Based on this reasoning, consider a beam made out of iron and an otherwise identical beam made out of aluminum. How should the natural frequency of vibration of these two beams compare? (Hint: look at the relative mass of these two elements on the periodic table and imagine that the atoms are connected by springs.)
The system in the figure below is in equilibrium, and its free body diagram drawn on the right. The distance, d is 1.14 m and each of the identical spring's relaxed length is l0 = 0.57 m. The mass, m of 0.86 kg brings the point P down to a height h = 15 cm. The mass of the springs are negligible. Calculate the following quantities: (a) The angle ? (b) The force exerted on P by the right spring (c) The force exerted on P by the left spring (d) The total spring length (e) The stretch length (f) The stiffness constant of the springs
Two springs of force constants k1 and k2 are attached to a block of mass m and to fixed supports as shown in Fig. 2. The table surface is frictionless. (a) If the block is displaced from its equilibrium position and is then released, show that its motion will be simple harmonic with angular frequency w = √(k1 + k2)/m. (b) Suppose the system is now submersed in a liquid with damping coefficient b , what is the condition that the block will return to itsequilibrium position without oscillation?Sketch a graph to show the behavior of the system in this case.
The equation of motion for a damped harmonic oscillator is s(t) = Ae^(−kt) sin(ωt + δ),where A, k, ω, δ are constants. (This represents, for example, the position of springrelative to its rest position if it is restricted from freely oscillating as it normally would).(a) Find the velocity of the oscillator at any time t.(b) At what time(s) is the oscillator stopped?
What is the leg stiffness if the center of mass displacement is 10 cm and the peak vertical force is 2500 N (remember units for stiffness are N/m)? What is the strain energy of the energy absorption portion of contact? What is the approximate change in velocity, if the mass is 80 kg?
In the figure below is a simple pendulum with the mass of the bob is M, the length of the pendulum is L. The motion of the system takes place in a vertical plane when the mass Mis released from an initial angle Өwith respect to the vertical. What is the component of the weight of Mthat is directed along the arc (Farc) of the motion of M? Label clearly and resolve the x-ycomponents in the Figure.
A body of mass m is suspended by a rod of length L that pivots without friction (as shown). The mass is slowly lifted along a circular arc to a height h. a. Assuming the only force acting on the mass is the gravitational force, show that the component of this force acting along the arc of motion is F = mg sin u. b. Noting that an element of length along the path of the pendulum is ds = L du, evaluate an integral in u to show that the work done in lifting the mass to a height h is mgh.
The figure shows a bar suspended from a pivot ? with a calibrated spring attaching the bar to the wall. The length of the bar is 0.970 ?, its mass is 0.775 ??, and the tension measured by the calibrated spring is 3.25 ?. Use the standard coordinate system with +? to the right and +? up the page. (a) Write the symbolic equation that represents equilibrium for the forces in the ? − ?????????. (b) Write the symbolic equation that represents equilibrium for the forces in the ? − ?????????. (c) Write the symbolic equation that represents equilibrium for the torques around point ?. Please use ? = 45.0 degrees, ? = 63.0 degrees, ? = 9.80 ?/? 2 , and calculate the horizontal and vertical components of the force the pivot exerts on the bar and the location of the center of mass of the bar, measured from the pivoted end.