he diameter of cylindrical conductor A is 6mm, and its length is 2m. The diameter and length of cylindrical conductor B is 0.02. Determine resistance of conductor A, its temperature being the same as that of B.

he diameter of cylindrical conductor A is 6mm, and its length is 2m. The diameter and length of cylindrical conductor B is 0.02. Determine resistance of conductor A, its temperature being the same as that of B.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.11MCQ

See similar textbooks

Related questions

Q: 3.By applying karnaugh map method, design a different circuit of full binary adder ucing more than 2...

Q: A silver bar, with 20x20cm dimension, has a length of 100 inches. What is the resistance of the bar ...

Q: -2et + 2e-2t V.(t) + 1.5 e=t = dV.(t) + 0.5- dt? d?V.(t) dt 2 O a. -2t O b. -2e-t + 2te-t c. C. -2e-...

Q: resistance R to maintain a voltage of 7.2 V across the voltage is constant at 12V and the minimum ze...

Q: 1. Find the transfer G(s) 0,(s) for the rotational mechanical T(s) system shown below 1000 N-m-s/rad...

A: Transfer function: It is the ratio of the output to the input in the s domain.

Q: How I can open file txt in my computer

A: This is a basic question which should know every engineer that's why i am answering this question.

Q: Modulation is the process of modifying a base signal with a carrier signal, and it is used mostly in...

A: Given, In frequency modulation Carrier frequency (fc) = 570 kHz Amplitude of carrier signal (Ac) =...

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v 1 0.5 0.06 0.3

Q: dentify the machines/equipment that requires electricity for specific rice farm production/postprodu...

A: FIND: The machines/equipment that requires electricity for specific rice farm production/postproduct...

Q: 3. Implement y = ABCD using only two-input NOR gates.

Q: A 50 and 100 microfarad capacitors are connected in series and across 100sin(w+30) voltage. Write th...

Q: 1/ Calculate the average and r.m.s values of the following waveform v(t) 80 50 20 O(rad) 27 Ans [50V...

A: The amplitude of the given sinusoidal waveform is half of the Vpp value. The Vpeak to peak value is ...

Q: Practice Problem 4.17 A Wheatstone bridge has R1 = R3 = 1 kN. R, is adjusted until no cur- rent flow...

A: In this question , wheatstone bridge is given...We have to find out unknown resistance in balanced c...

Q: Problem 3 What should be the value of R such that maximum power transfer can take place from the res...

A: According to guidelines we are allowed to do only first question. Post again for remaining one

Q: Find the Norton equivalent circuit of the circuit in Fig. 4.45 at terminals a-b.

Q: What is the simple interest on 12,500 at 8% for 9 months? John borrowed 15,000 for 2 years and 6 m...

A: 1. Principle amount is given, P = 12500. Rate of interest r = 8% Time is given, t=9 months =912=0.75...

Q: 13.) Given the star connection, convert into equivalent delta connection 1 p and solve for resistanc...

A: The solution is given below

Q: load current is to vary from 12 to 100 mA. Find the value of series resistance R to maintain a volta...

Q: Given A= (3x +y')a, + (x-y')a,, find V. A.

Q: What is the output voltage(R1) on the 1st half cycle? *

A: The circuit comprises of the diode connected in series with the battery. Consider the diode is an id...

Q: Find the Nyquist rates for the following signals: X(t)= sin (20t) X(t) =4sin (30nt) + 3cos (70rtt) X...

A: In this question, Find the Nyquist rate of the given signal. We know Nyquist rate = 1/fs Where fs...

Q: Using mesh analysis, determine the current through each resistor.

Q: A transmitter supplies 50 W to a load through a line with an SWR of 2:1. Find the power absorbed by ...

Q: Explain the design of renewable and non-renewable energy system principle (Other than water)

A: Solar power plant(Renewable energy): Photovoltaic power plants are another name for solar power plan...

Q: Q3. Draw the output waveform for the circuit shown below.

A: The provided circuit comprises of the diode, whose negative terminal is connected to the output side...

Q: 1. In the circuit of Fig., calculate the average power absorbed by the resistor and inductor. Find t...

A: The solution is given below

Q: Yo 2-to-4 4 4-to-1 Decoder So MUX Y2 1/2 So C-

A: Multiplexer: It has many input and one output terminal so this is also called many to one.

Q: A synchronous generator is rated 645 MVA, 24 kV, 0.9 pf iagging. It has a synchronous reactance 1.2 ...

A: The detailed solution is provided below.

Q: What is the output voltage(R1) on the 1st half cycle? C1 D1 R1 12V

A: The Clamper circuit consists of a diode, capacitor, and resistance, a Capacitor connected in series ...

Q: Example: Suppose that an analog signal is given as x(t) = 5cos (2n x 10t) and is sampled at the rate...

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v O 1 0.5 0.06 0.3

Q: Given the Boolean expression: A= WXYZ + W'XYZ' + W'X'YZ + WYX'Z', identify the incorrect part of the...

Q: b) The analogue signal is defined as: v (t )= 5sin(2x 5001) + Ssin(2x 750r) is sampled as shown in F...

Q: There is a constant current source whose value is 8 A now there are three resistors connected to it ...

A: Draw the circuit and than using nodal analysis find the voltage across the parallel connected resist...

Q: Solve the following system by any method 211 - 2 + 313 + 514 = 21 h - 213 + I4 = -1 5/ - 512 + 13 + ...

A: This question belongs to basic electrical . It is about solving equations and calculate unknown vari...

Q: pioblemi Find the equivalont vesistance. between A cand B in the fallowing circuits. A B 303 多几多61 ...

Q: Summing Amplifier R1 R2 V1 R3 Vo V2 (R21 2V,+ R3 R2V2 R, Basic Differential Amplifier Circuit R1 V1 ...

Q: 0,(s) for the rotational system T(s) 2. Find the transfer function G(s) below

A: The given circuit is shown below:

Q: problem (13) Write the state variable formulation of the parallel R network. i A ig ic C i(t) = Io s...

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode current...

A: This question belongs to analog electronics . It is based on the working of zener diode. Zener diod...

Q: 3/ Calculate the form factor of the triangular voltage waveform shown below v(t)4 10- t(sec) Ans [1....

A: Given Form factor:It is the ratio of rms value to the average valueForm factor=RMS valueAverage va...

Q: A2 3:2 220V 1k V2 V3 АЗ 6. What is A3 reading? 4. What is A1 reading? 5. What is A2 reading? 132mA 2...

Q: Solve for the current on the resistor.

A: The diode D1 and D2 are connected in series The supply voltage = 12 V Resistance = 10 ohm

Q: Given A=e"a, +2 cos ya, +2 sin za,, find V A at the origin.

Q: A coil RL is connected in series with a capacitor across the 220 V, 60 hz, AC supply. If this circui...

A: Source voltage is phasor sum of voltage across the coil and voltage across the resistor. Use phasor...

Q: Derive the response of second-order instrument for step input and identify the characteristic for di...

A: Response of Unit step unit The response of the system with zero initial condition to a unit step in...

Q: Find the inverse laplace of -32*((4-s^2)/(s^2+4)^3)

Q: A capactance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

A: This problem comes under basic electrical. It is related to capacitance . Rating of capacitor depend...

Q: The charge q2 is now replaced by two charges q3 and q4 which each have a magnitude of -1.65 µC, half...

A: It is given that: q3=q4=-1.65μCa=2.3 cm

Q: Solve the following system by any method 211 - 12 + 313 + 514 = 21 1 - 213 + I4 = -1 51 - 512 + 13 +...

A: This problem comes under basic electrical. It is about calculation of unknown variable by using give...

Concept explainers

Electric field

A physical field present around an electrically charged particle that exerts a force on all other charged particles is called an electric field. The charged particles present in the field either repel or attract. From electric charges or time-varying magnetic fields, the electric field originates. One of the manifestations of electromagnetic force which is one of the four fundamental forces present in nature are the electric fields and magnetic fields.

Question

The diameter of cylindrical conductor A is 6mm, and its length is 2m. The diameter and length of cylindrical conductor B is 0.02. Determine resistance of conductor A, its temperature being the same as that of B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C and a 60-Hz resistance of 0.0956 ohm per mile at 50C for the all-aluminum Marigold conductor, which has 61 strands and whose size is 1113 kcmil. Assuming an increase in resistance of 2 for spiraling, calculate and verify the dc resistance. Then calculate the dc resistance at 50C, and determine the percentage increase due to skin effect.
One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for commercial bare-aluminum electrical conductors lists a 60 Hz resistance of 0.0080 ohm per kilometer at for a 793-MCM AAC conductor. Determine the cross-sectional conducting area of this conductor in square meters. Find the 60 Hz resistance of this conductor in ohms per kilometer at 50C.
Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of 104F (40C). Use the NEC to determine the ampacity of the following conductors.
The resistance of a cylindrical brass conductor, 0,5 cm diameter and 3 m long, is 0.0108 ohm. Determine resistance of a cylindrical conductor of the same material at the same temperature, and having a diameter of 0.25 cm and a length of 8 m.
The diameter of a cylindrical conductor A is 6.0 mm, and its length is 2.0m. The diameter and length of a cylindrical conductor B of the same material as A are 3.0 mm and 1.0 m. The resistance of conductor B is 0.02 ohm. Determine resistance of conductor A, its temperature being the same as that of B.
The resistance of a cylindrical brass conductor has a resistance of 0.00108 ohm with 0.5 cm diameter and 3 m long. Determine the resistance of a cylindrical conductor of the same material at the same temperature, and having a diameter of 0.25 cm and a length of 8 m
The diameter of a cylindrical conductor A is 6 mm, and its length is 2 m. The diameter and length of a cylindrical conductor B of the same material as A arel3 mm and 1 m. The resistance of conductor B is 0.02 Determine resistance of conductor A, its temperature being the same as that of B.
The inner conductor of a long coaxial cable has radius a. The inner radius of the outer conductor is b. Inner conductor V0, outer conductor at 0 potential. Determine the electric potential and electric field strength in the insulating material.
A lead conductor is 5cm in length and 8 sq. cm in cross-sectioned area. The terminals to be joined by this conductor are 8 cm apart. Hence, the conductor was pounded and reshaped until it is 8 cm long. If the resulting conductor has uniform cross-sectional area, determine the resistance. Resistivity of lead is 22x10^-8 Ω-m.
A 415 single core cable has a conductor diameter of 0.5 cm and a sheath of inside diameter 3 cm. In cable insulation, find: (i) minimum stress (in V/cm); (ii) maximum stress in (V/cm); (iii) Describe where these minimum and maximum stress will occur in cable insulation?; (iv) Suggest what should be the minimum dielectric strength (in V/mm) of the cable insulation to avoid any breakdown of the given cable
A coaxial cable of consists of two concentric cylindrical conductors. The region between the conductors is completely filled with polyethylene plastic. The radius of the inner conductor is 0.50 cm, the radius of the outer conductor is 1.75 cm, and the length of the cable is 15 cm. The resistivity of the plastic is 1013 Ω • m. Calculate the resistance of the plastic if the electric field is applied across the ends of the conductor.
A lead conductor is 5cm in length and 8 sq. cm in cross-sectional area. The terminals to be joined by this conductor are 8 cm apart. Hence, the conductor was pounded and reshaped until it is 8 cm long. If the resulting conductor has uniform cross-sectional area, determine the resistance. Resistivity of leads is 22x10^-8 Ω-m.