he real effects of electricity and what would happen if we lost it?

Q: determine the output voltage

A:

Q: A-Design a two-stage BJT amplifier as shown in the figure with coupling capacitors such that the 3…

A:

Q: Q.5 For a unity feedback system, the open loop transfer function is G(s) = 50/s(s+ 2). With unit…

A: Given: For a unity feedback system, the open-loop transfer function is G(s) = 50s(s + 2) To find:…

Q: A servomotor for position control of a rotatable mass is stabilized by viscous friction damping…

A: Given f= 12 Hz ωn =2πf =2π×12=75.4 rad/sec To determine i) expression for output of the system ii)…

Q: 38) The output of a gate has an internal short. A current tracer will OA be able to identify the…

A: The output of a gate has an internal short. A current tracker will .....

Q: The voltage at the sending side (source) of a transmission line is 1 KV (Vs = 1 KV). The voltage at…

A:

Q: C Fill in the following blanks with appropriate answers (Choose Five Only) 1. A data communication…

A: 1) wan A data communication system that spans states, countries, or the entire globe is called wan.…

Q: Example: Find Thévenin's equivalent circuit between a &b for the network in Fig. 2.32. Then find the…

A:

Q: for the cct. as shown + in fig. U 3 Jc a) 1 = 4 (0, w = 10 w = 10 red/sec find cif V = 80+√200 b)…

A: Given circuit

Q: Mark the WRONG statement. In induction type kWh meters

A: The induction type energy meter consists of an aluminium disc and it is placed between two…

Q: What is the theorem that can be used to solve the differential equation in laplace transform ?

A: First consider the following property of the Laplace transform: One can prove by induction that

Q: Q31-Determine the output voltage (V.) waveform for the clamper network of figure below.… 20V CeluF 北…

A:

Q: Write the expression for the output voltage of a balanced modulator

A: A balanced modulator circuit is an electronic circuit which is used to produce double sideband…

Q: 3. For the dual oscilloscope displays shown in the figure with H, of 500 µs/div and V, of 20 mV/div…

A:

Q: Q.3: A 18kVA, 200/600V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

A: Given data is shown below. O.C test : 200V,3.5A,600W S.C test : 15V,30A,400W i.…

Q: Question: Two wattmeters in a 3 phase, 3-wire system with a effective line voltage of 120V read…

A: Wattmeter is measure the electric power to given developed by an electrical circuit. wattmeter…

Q: Q.4: Two 11000/400 V, transformers are operated in parallel to share a load of 250 kVA at 0.85 power…

A: It is given that: A:100 KVA; 0.9 % resistance and 10 % reactanceB:200 KVA;  1 % resistance and 5 %…

Q: A 200-V single-phase synchronous motor takes a current of 10 A at unity power factor from the…

A:

Q: 5. What is the unit step response of a continuous system whose transfer function has a zero at - 1,…

A:

Q: 4. For the oscilloscope display of a pulse waveform shown the 'time/div' or H, switch is on 0.50…

A: As per Bartleby policy we can answer three subparts. As you have not mentioned anything, so I am…

Q: Q1) For the emitter-bias configuration of Fig. below, determine: Rc, RB and RE if Icq= (1/2)Isat =…

A:

Q: 10. Assume the input frequency (fin) is 256 Hz. The output frequency (fout) will be

A: Given,fin= 256 Hz To calculate fout

Q: Q.3: A 18kVA, 200/600V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 230 V d.c series motor has armature and field resistances of 0.5 Ω and 5.0 Ω, respectively. It…

A:

Q: Maximum flux density in the core of a 250 V/3000 V, 50 Hz single phase transformer is 0.6 Wb/m². RMS…

A:

Q: Calculate in the given circuit. Assume R = 90. R lo 10 V 6Ω The value of lois www 3Ω A.

A: Given circuit: R=9 Ω

Q: Q3. Write if the shown statements are TRUE or FALSE. 1- In DC machine the induced e.m.f is…

A: As per the honor code I will solve only first three questions. Kindly repost the other questions…

Q: Obtain the equivalent resistance Rab for the circuit in Fig. and use it to find current i. 1302 24…

A:

Q: Q.4: A) Two 1-phase transformers with equal turn ratio have impedances of (0.5 + j3) N and (0.6…

A:

Q: 3 w = 10 w = 10 red/sec Jc V = 80+ √200 b) find c if w = 100₁ |VI = 100 volt > I=4 <0 =a) 1 = 4 (0,…

A:

Q: Q.4: Two 11000/400 V, transformers are operated in parallel to share a load of 250 kVA at 0.85 power…

A: The  Standard parallel operation of transformer can be done if the following conditions are…

Q: о to holdd the piv pivot in position to control the pointer movement

A:

Q: A) what is the advantage and disadvantage of closed loop system? is the advantage and dis advantage…

A: Note : In the question it is mentioned that choose only one question. So i answered second question

Q: Q3: A 3-phase half wave-controlled rectifier is fed from 3-phase 400V, 50Hz source and is connected…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: 4. Op-Amp has (a)Single (b) Similar (c)Multiple (d)Differential 5. Write the formula for closed-loop…

A: (4) Answer is (a) Single An operational amplifier is an integrated circuit that can amplify weak…

Q: 4. In the following op-amp circuit; R=2.2 k2, R-22 kN, C₁ = C₁ 30 nF, R₁ R₂ =20 k and. The amplitude…

A: Solution- C1=C2=CR1=R2=Rfc =12πR1R2C1C2=12πRC KCL at node X,Vx-VCSC+VXR+VX-V+1SC…

Q: Find the state and output equations for the electrical network shown in The below figure if the…

A: Solution- At node 1, -it+iR1t+iLt+ict = 0CVc˙t+iLt+iR1t = itR1iR1t=VL=LiLtiR1t =…

Q: A three-phase, star-connected synchronous motor is connected across a 400-V supply. The stator…

A:

Q: Consider an LTI system with frequency response H(e^jw). The input to this system is x[n]= ∑n=-∞ to…

A: Given that input to LTI system xn=∑k=-∞∞δn-3k Output is yn=cos2π3n+π6 We know that…

Q: For the control system shown below the input signal is X(t) and the output s 10s +50 X-G ►Y 4 s +12s…

A: Given control system with block diagram, Forward path, Gs=10s+50s2+12s+100

Q: Question 5 A 200 HP, 440 V, 1440 rpm, 50 Hz induction motor has a power factor of 0.85 lagging and…

A: Starters : Starters are used to limit the starting inrush current DOL Starter or direct online…

Q: Create a logic circuit of a buzzer, Explain it's functionality and create the truth table.

A: A Buzzer is a Electronic circuit component which contains 2 terminals. The electronics circuit…

Q: Niagara Falls, Ontario has attracted tourists from all over the world since even the early 19th…

A: Given data, Output power P0=2000 MW Average energy used by per household = 11 MWh

Q: answer with solution C(s) Find the transfer function R(s) d²C d 2#*C(Đ) +2&°C(Đ) dt² ¹+2+C(t)=r(t)…

A: Given here a differential equation and asked to find the transfer function.we know that L c  t   = C…

Q: State the advantages and disadvantages of the block diagram reductio technique.

A: Block diagram reduction techniques are used to find transfer function in control system. Transfer…

Q: WYE TO (ZAB Given: ZA= 11-j10.22 ZB 13+j12_2 2 Zc : 15 tj 142 : VL 360 + Phase sequence VAB - 360…

A: Given: Consider the following figure: ZA=11-j10 ΩZB=13+j12 ΩZC=15+j14 Ω  Line voltage: VL=360 V…

Q: Q3] find the current of the resistance 2492 if the value of the source is:V1= 2.6sin(100rt- 58) volt…

A:

Q: A three-phase half wave rectifier is operated from a 3-phase, 230 V, 50 Hz supply with load…

A: Given: A three-phase half-wave rectifier is operated from a 3-phase, 230 V, 50 Hz supply with load…

Q: Use source transformation to find Vo in the circuit of Fig 252 392 ww www 492 3 A Vo 6.2V 10V O 892…

A: I have checked the solution . Correct answer is not there in choices .  This question belongs to…

Q: 81 What is the function of the zero-adjust control in a multimeter. it serves to conduct the current…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.