Heavy machine tool lubricating oil (ref. Appendix C applied fluid mechanics) is pumped through six rectangular slots in a heat exchanger (oil flows in the white rectangles in section view a-a) as shown below. You may assume that the oil flows through the heat exchanger with a constant temperature of 40°C. If the flow rate from A to B is 3 cm³/sec determine the Reynolds number for the oil flow. Is the flow laminar or turbulent

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A:

Q: Calculate the average velocity of water in the pipe?   2. Determine the Reynolds number in the…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: Reynolds number of the flow.

A: Given; Water flows through a pipe having an inner radius;…

Q: A fertilizer delivery system is shown in the figure. The hose is made of a material whose…

A: Solution: Given Data: CR=0.12d=25 mmD=30 mmR=1.3 mV=5.4 m/sη=75%SG=1.1h=10 m - 1.2 m = 8.8 m

Q: Water is discharged form a reservoir into the atmosphere through a pipe 80 m long. There is a sharp…

A:

Q: It requires a specific displacement before the flow become fully developed. Entry length a. depends…

A: In fluid mechanics, the hydrodynamic entry length boundary layer is a thin layer of a moving gas…

Q: A vertical cylindrical tank of height h and radius R has a narrow crack of width w running…

A:

Q: Problem 2.) An intercooler discharges heat of 50 KW from the system. Determine the temperature of…

A: Given data: The specific heat of water is

Q: Water at 20°C flows through the piping junction, entering section (1) at 0.1 m3/min. The average…

A: Given figure:

Q: Problem 1: Fresh water at a temperature of 10°C flows at a rate of 0.10 m3/sec through the piping…

A: Since you have asked a multi-part question which contain more than 3 sub-parts, thus we can provide…

Q: 1. Why we use Reynolds number instead of mean velocity as the criteria to judge the flow state…

A: The Reynolds number is a dimensionless number that judges the flow property that is either the flow…

Q: A large tank open to the atmosphere is filled with water to a height of 4 m from the outlet tap. A…

A:

Q: I Review A solar water heater mounted on the roof consists of two flat plates. Water enters at A and…

A:

Q: It is desired to have a laminar flow for the piping svstem shown below. The fluid flowing in the…

A: Given that, Temperature of air, T=70 °C,Dia of pipe 1, d1=2 in,Dia of pipe 2, d2=3 in,Dia of pipe 3,…

Q: (a) A storage tank is connected to a piping system as illustrated in Figure P1. Water at temperature…

A: The friction losses in a system are a complex function of the system shape, fluid characteristics,…

Q: The piping arrangement shown delivers a jet of water at location C. Water enters the pipe from ne…

A: given minor coefficient bwtween A and B , KAB=7minor coefficient bwtween B and C , KBC=3Diameter of…

Q: (a) A storage tank is connected to a piping system as illustrated in Figure P1. Water at temperature…

A: Major and minor losses are the most common types of energy losses in fluid flow across a pipe…

Q: Water in an enclosed tank is subjected to a gauge pressure of 2.902 psi, applied by a compressed air…

A: given; gause pressure (P)=2.902psi=20008.5857Pahole below the level of water…

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A: Given:Bulk velocity of water through the pipe, V=0.4 m/sInternal diameter of the pipe, d=250…

Q: Calculate the velocity at the end of the pipes of diameter 150 mm and 220 mm connected in series…

A: We must compute the velocity at the end of a set of pipes with diameters of 150 mm and 220 mm and a…

Q: Medium lubricating oil (sg=0.85) is pumped through 360m of horizontal 75mm pipe  at the rate of…

A:

Q: There is an upward flow from the vertical pipe shown in the figure. If the flow rate is 0.05 m3 / s,…

A: Given data: The flow rate is, Q̇ = 0.05 m3/s. Write the expression to calculate the velocity at…

Q: When is no-slip condition possible? A. If the flow is external and the velocity is determined near…

A: The fluid property of viscosity is responsible for the no-slip condition and the formation of the…

Q: Whole milk flows into the centrifuge through a pipe with a diameter of 7 cm at a speed of 0.22 ms-1,…

A:

Q: 3. Determine the Reynolds number and type of flow occurring when heavy fuel oil at 30 C flows at a…

A:

Q: reservoir A is at elevation 90 m above datum, furnishes water to a 600 mm pipe which leads to a…

A:

Q: Oil is discharging out of an orifice under a constant pressure of 24 kPa. The vessel is an upright…

A: Given: The pressure inside the tank, P = 24 Kpa The height of oil inside the tank, h = 3 m The SG of…

Q: Consider the steady laminar flow of water at 25°C through the piping system shown below. (a) Derive…

A:

Q: 4. Determine the Reynolds number and type of flow occurring when medium fuel oil at 32 C flows at a…

A: ONLY ONE QUESTION CAN BE SOLVED AT A TIME. FOR SOLUTION OF OTHER QUESTIONS, KINDLY UPLOAD THE…

Q: 2) V2 = 0 water tank B Z2 - Z1 (1) Z1 D water tank A pump valve 72

A:

Q: Freshwater at a temperature of 10°C flows at a rate of 0.10 m3/sec through the piping system…

A: Determine the value of the absolute roughness of the galvanized iron pipe.

Q: Heavy fuel oil flows from A and B through a 1000 m horizontal 150mm diameter steel pipe. The…

A: The pressure change is given as,   The dynamic viscosity of the oil is written as,

Q: 1. A given pipe first carries water and then carries air at 15°C and atmospheric pressure. What…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: The water is siphoned out of the tank shown in Figure 4 (b). Determine the flow rate from the tank…

A: According to the problem, the water is siphoned out of the tank so the pressure at the end where the…

Q: Question 4: Consider laminar flow through a very long straight section of round pipe. It is shown…

A:

Q: Water with a constant density 62.4 lb/ft^3 is flowing at a rate of 50gal/min through a horizontal…

A:

Q: - A fluid of constant density flows at the rate of 15 litres/sec along a pipe AB of 100 mm diameter.…

A: Given: To determine the flow through

Q: 23 Apple juice at 20°C is siphoned from a large tank using a constant-diameter hose. The end of the…

A: 2.3) Given: The apple juice is at 20°C  is siphoned from a large tank using a constant-diameter…

Q: Hot oil is pumped through a heat exchanger (see figure below) at a flow rate of 0.5 L/s. An inlet…

A: The calculation for friction factor for Laminar flow:

Q: Whole milk is flowing into a centrifuge through a full 6.5 cm diameter pipe at a velocity of 0.19…

A:

Q: Hot oil is pumped through a heat exchanger (see figure below) at a flow rate of 0.5 L/s. An inlet…

A:

Q: Given water at 25 degrees C flowing in an inclined plate with angle 35 degrees with the horizontal,…

A: given data water at 25 degrees C inclined plate with angle 35 degrees with the horizontal film…

Q: Water is flowing inside a horizontal pipe with diameter of 0.25 ft which reduces to a pipe with…

A: Given: d1=0.25 ftd2=0.1 ftdtube= 14 inhtube=4 ft

Q: Calculate the liquid rates of flow in both sections. Calculate the ratio of the rates of flow.…

A: Flow = Q = A v A = area of cross section V = velocity

Q: Air at a temperature of 80°F flows through the duct at A with a velocity of 32 ft/s. (Figure 1)

A: Given  Data, DB= Diameter of section B = 18 in = 18/12 = 1.5 ft DA = Diameter of section A = 6 in =…

Q: with density ρ=900 kg / m3 and kinematic viscosity ν=0.0002 m2 / s as shown in the figure, through a…

A:

Q: Water is discharged from a reservoir into the atmosphere through a. 80 m long pipe. There is a sharp…

A:

Q: The cylindrical tank shown in (Figure 1) is filled with glycerin at 68° F. When the valve at A is…

A: