Homework Question: The pipe bend as in the figure below has D1 = 29 cm and D2 = 12 cm. When water at 20°C flows through the pipe at 4000 gal/ min, p1 = 215 kPa (gage). Compute the torque (magnitude and direction) required at point B to hold the bend stationary? HINT

Q: A 3.3-in.-diameter pipe carries 338 gal/min of water at a pressure of 27.7 psi. Determine a) the…

A: The Diameter of the pipe, D=3.3 in OR D=0.275ft Discharge, Q=338 gal/min OR Q=0.753067 ft3/sec…

Q: A pump delivers 10 L/min with a pressure rise of 80 bar. The shaft speed is 1420 rev/min and the…

A:

Q: 3.1) Sketch the Hydraulic Grade Line (HGL) and the Energy Grade Line (EGL) considering all losses…

A: Given Datad1=0.12mL1=12md2=0.32mL2=13mf=0.017H1=10mQ=0.02m3/sk1A=0.7vw=10-6m2/sρ=1000kg/m3

Q: through a horizontal duct of diameter 0.5 m  with a velocity of 0.4 m/s.  If the friction factor is…

A:

Q: Water at 10°C is flowing from point A to point B through the fabricated section shown below at the…

A: Given that: Volume flow rate = 0.37 m3/s Diameter at A = 300 mm = 0.3 m Diameter at B = 600 mm = 0.6…

Q: Problem 3. A siphon, filled with water, is discharging that water. The discharge rate is 2.8 cfs. a)…

A: we have given

Q: A turbine develops 240 kW at 275 rimin under a pressure head of 18 m. A similar machine must be…

A: GIVEN DATA - FOR TURBINE-1  POWER P =240kW                             SPEED N = 275 rpm…

Q: The cylinder bore diameter of a single-acting reciprocating pump is 150 mm and its stroke is 300 mm.…

A: Write the expression of theoretical discharge of the pump. Qth=ALN60

Q: .Compute the lost pressure for a diverging fitting. The flow rate in the 20 cm upstream section is…

A: Given: Q1=0.24 m3/s    D1=20 cmQ2=0.24 m3/s    D2=20 cmQ1=A1*V10.24=π4*0.22*V1V1=7.639…

Q: Q4, bend. When the gauge pressure is E psi, F = 2000 lb to hold the bend in place. Determine a) the…

A:

Q: Oil (SG=0.82) entering a pump through an 8-inch diameter pipe at 4 psi has a flow rate of 3.5 cfs.…

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A:

Q: Water of density 1000 kg/ m³ and kinematic viscosity 1.022 X 106 m²/s, is pumped between two…

A:

Q: Figure below shows a siphon that is used to draw water from a tank. The siphon tube has an inside…

A:

Q: For the pipe system shown. Assume n = 0.013 for all pipes. Neglect minor losses. 1. Compute the…

A: Head loss in a pipe is given by the formula hf = flv22gd = 8 f l Q2π2 g d5Where f= n = 0.013…

Q: Please find the question attached.

A: Given data as per question velocity at section 2 = 1 m/s h2 = 0.2 m velocity at section 3 = 5 m/s h3…

Q: Q2/ A pipe with a radius of 15 mm is attached to a garden hose with a nozzle. If the velocity of…

A:

Q: (Problem 3) A horizontal water pipe is reduced in size from 18 inches in diameter from point A to 6…

A:

Q: The flow is opened to the atmosphere at point 2 and 3. Find the magnitude and the direction of the…

A:

Q: Completely solve and box the final answers. Write legibly. 2. A centrifugal water pump operating at…

A:

Q: For the wye fitting below, which lies in a horizontal plane, the cross-sectional areas at sections…

A: Given Data The area of the section 1 is: A1=1 ft2 The area of the section 2 is: A2=1 ft2 The area…

Q: Read the question carefully and give me right solution according to the question.  Two pipes with…

A:

Q: Water at 50 °F flows through a horizontal bend and discharges into the atmosphere as shown in the…

A:

Q: A fan has a static head of 100m at 1kg/cm2 and 70F. If air velocity is 17m/s, find the total…

A: Given data as per question Static head =100 m velocity =17 m/s Temperature =700 F =294.261 K…

Q: The scoops of the Pelton turbine deflect the water jet by 25°. Geometric head 500m, absolute…

A: Turbines are hydraulic machines which converts hydraulic energy into mechanical energy. In pelton…

Q: A vessel is being filled with water through an inlet at section 1 having a diameter of 40 mm and a…

A: The dynamics of fluid flow is the study of fluid motion with the forces causing flow. The dynamic…

Q: In Fig. X6.5.3, both nozzles discharge water horizontally into the atmosphere at 30 fps. Find 0 so…

A: Continuity equation is based on the conservation of mass. If a pipe having area at one section is…

Q: A six-centrifugal pumps delivers 0.1 m3 /s against a total head of 480 m. What is its specific speed…

A: Given: The value of discharge is, Q=0.1 m3. The value of the head is, H=480 m. The value of speed…

Q: A horizontal water pipe is reduced in size from 18 inches in diameter from point A to 6 inches in…

A: Diameter at A, DA=18 in=1812ft=1.5 ftDiameter at B, DB=6 in=612ft=0.5 ftWater flow rate, Q=10…

Q: A horizontal pipe 2.0 mm in radius at one end gradually increases in size so that it is 5.0 mm in…

A: Given: R1 = 2 mm R2 = 5 mm L = 4 m V1 = 8 m/s P1 = 2 bar

Q: Problem-4 A liquid (S.G. = 0.9) flows downward through a vertical pipe as shown. Determine a) the…

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A:

Q: 5.3 Water flows upward through the pipe reducer shown. The elevation difference berwoen points / and…

A: Bernoulli's equation Bernoulli's equation states that, an increase in the speed of a fluid occurs…

Q: Problem 3: Water issues from a hole in a large tank, as shown in the attached figure.Assuming…

A: Given data,Height h1= 3 mHeight h2= 5 m

Q: A pipe line AB of diameter 300 mm and of length 400 m carries water at the rate of 50 liters/s. The…

A: As per given question A pipe line AB of diameter 300 mm and of length 400 m carries water at the…

Q: Problem 6.7 A pipe of diameter 400 mm carries water at a velocity of 25 m/s. The pressures o points…

A: Solution:

Q: The figure below shows a gasoline storage tank with cross-sectional area Asub1, filled to a depth h.…

A:

Q: Need asap A horizontal pipe of cross section 1.5 in2 has a constriction of cross section of 2 cm2 .…

A: Given data,  Horizontal pipe area a1=1.5 in2  Or a1= (1.5/144) ft2 Constriction area a2 = 2 cm2  Or…

Q: The pipe bend of Fig.  has D 1 = 27 cm and D 2 =13 cm. When water at 20 ° C fl ows through the pipe…

A: Given, Q = 4000 gal/min D1 = 27 cm D2 = 13 cm p1 (gauge) = 194 kPa p2 = pa

Q: Water of density p flows steadily through a smooth contraction of width w, as shown in Figure P3.61,…

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A: The equation based on the principle of conservation of mass is called the continuity equation. thus…

Q: Water flows through a horizontal pipe with a cross section area of 4 m2 at a speed of 5 m/s with a…

A:

Q: Referring to the image of the dam, assume that the resulting flow through the pipe is 1000 ft/min…

A:

Q: In the hydroelectric power plant whose cross-section is given, the flow rate of Q=33.045 m^3/sec is…

A: Given data: Discharge of water in the penstock, Q=33.045 m3/s. Diameter of the penstock pipe, D=1.6…

Q: From a very large tank with an absolute pressure of 3 bar, the water is discharged to the atmosphere…

A:

Q: Water flows steadily through a pipe with ID 35 mm. This pipe expands suddenly to an inner diameter…

A: