How do I calculate the ST50 from my raw data to give me time at which 50% sedation has occurred graphically of all of my replicates? Using excel do I use linear graphs? scatterplot? what kind of trendline? with what setting? Raw data includes time from 0-24 hours + # of flies sedated at different intervals. En

How do I calculate the ST50 from my raw data to give me time at which 50% sedation has occurred graphically of all of my replicates? Using excel do I use linear graphs? scatterplot? what kind of trendline? with what setting? Raw data includes time from 0-24 hours + # of flies sedated at different intervals. En

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 33SST

See similar textbooks

Similar questions

Design a simple, manipulative experiment to test the hypothesis that synthetic fertilizers in the environment influence the population density of the salamander, Ambystoma tigrinum. Your experiment can have no fewer than two treatments and no more than four. State your hypothesis. Briefly describe your experiment. Address the following: Is it a field or lab experiment? What are the treatments, how are they set up, and what differentiates them? How many replicates of each treatment will there be? What are the standardized conditions of your experiment? C. Identify the independent variable, including units, in your experiment. D. Identify the dependent variable, including units, in your experiment. E. Identify at least one control treatment and explain its specific role in the experiment.
The results of a bacterial population study done with plate dilutions were as follows: 297 colonies on the 1/1000 (10-3) plate 33 colonies on the 1/10,000 (10-4) plate What is the average titer (or original cell density)? Note: Your answer should be presented to the nearest whole number (not including decimal).
Suppose we have the following table in our goodness of fit test results: Variable/Condition Value p-value 0.077 Significance level 0.05 Conclusion then what do we write in the cell corresponding to "Conclusion"? Suppose we have the following table in our goodness of fit test results: Variable/Condition Value p-value 0.077 Significance level 0.05 Conclusion then what do we write in the cell corresponding to "Conclusion"? We change the significance level to 0.95. We accept the null hypothesis that the disease possibly follows the specified mode of inheritance at the given gene. We reject the null hypothesis that the disease possibly follows the specified mode of inheritance at the given gene. We accept the null hypothesis that the disease almost certainly follows the specified mode of inheritance at the given gene. We collect more data.
The abdomen length (in millimeters) was measured in 15 maleDrosophila, and the following data were obtained: 1.9, 2.4, 2.1,2.0, 2.2, 2.4, 1.7, 1.8, 2.0, 2.0, 2.3, 2.1, 1.6, 2.3, and 2.2. Calculatethe mean, standard deviation, and variance for this population ofmale fruit flies.
Vaccinating 65% of a population will provide herd immunity for a disease with which of the following reproductive rates? Pc= 1-(1/R0) Group of answer choices 2.2 Herd immunity will not be achieved for any of these reproductive rates. 4.5 3.1 5.0 Herd immunity will be achieved for all of these reproductive rates.
What type of event causes founder effect? what type of event causes bottleneck effect?
APOE Allelic frequency Control EOAD LOAD Vascular disease e4 0.07 0.28 0.35 0.12 e3 0.88 0.70 0.63 0.87 What group is used as a control here? Based on this data, do you think APOE e4 allele increases one’s chance to develop EOAD or LOAD? Defend your answer. Your answer has to refer to the specific data in the table. Suppose that you want to improve this case control study by controlling one more variable that is a known risk factor for Alzheimer’s disease, how will you design your groups? Specify the risk factor you want to control and how you plan to control it.
for clarification which is shown in the graph, the darker blue on the bar graph shows the mass(size) of the eggs and the striped blue represents the number of eggs which is also depicted in the graph. as far as the host plants, its just showing 3 different plants the butterflies were on which is represented by the a, b, and c, also located on the graph. The right side of the graph (mass) represents blue and the left side (number of eggs) represents the striped blue. part a: Describe the relationship between egg size and clutch size shown in Figure 1. (This is not asking about host plants, just about the butterfly eggs.) part b: Describe one possible reason for the relationship between egg size and clutch size observed. (This is not asking about the host plants, just about the butterfly eggs.) part c:Describe one realistic difference between host plants that might be affecting the numbers and sizes of eggs that a female lays on these plants.
Which of the following best describes the control group for this experiment? a) mating between male flies raised on maltose medium and female flies on starch medium.b) mating between male and female flies raised on starch medium in different populations.c)mating between female flies raised on maltose medium and male flies raised on starch medium.
What are specific slave making ants, what slave making ants do to capture other ants, what are the different capaturing levels and methods?
In pine tree it was found three genotypes (R2R2, R2R3, R3R3) at a locus encoding the enzyme peroxidase. The observed numbers of trees of these genotypes were genotypes number observed R2R2 135 R2R3 44 R3R3 11 Are the pine trees population in Hardy-weinberg equillibrium at the peroxidase locus? use chi square test
An inter-strand grouping of students is working on a study about the Copper-infused materials utilization for real environment viruses and bacteria to address good health and well-being of the target beneficiaries. They want to compare the utilization and non-utilization of copper infused materials if it will yield the same results when introduced to reduce bacterial contamination. QUESTION: Will the choice of sampling technique affect the statistical test to be used? Also, what is the appropriate statistical test to use and why?