How does shear rivet works? How does this item helpful in the control surface?

Q: A counter flow double pipe heat exchanger using super heated steam is used to heat water at the rate…

A:

Q: Pressure drop and heat transfer in suction line Decrease compression ratio & discharge temperature…

A: Let Pa be the suction pressure before pressure drops. Let Pb be the suction pressure after pressure…

Q: /Aircraft Cessna Cj-1 in climb stage, Climbing with angle of attack equal to 8º. Cj-1 has the…

A: The thrust loading and wing loading are important parameters for the aircraft design. As the fuel…

Q: 44. Draw a free-body diagram of member AC in Figure P4-4. -2 m 3 m A T 1 12 50 kN FIGURE P4-4

A: Draw free body diagram of member AC.

Q: Water flows through a horizontal tapered pipe with a diameter of 300 mm at one end and 200 mm at…

A: Water flows through a horizontal tapered pipe with a diameter of 300 mm on one end and 200 mm on the…

Q: vr is calculated and is equal to

A:

Q: Multiple Evaporator Systems it may be required to have different temperature maintained at single…

A: Option ( B) is correct Have different temperature maintained at various zones.    Because multiple…

Q: The rigid beam shown in Fig. Q3 is supported by a pin at A and a horizontal short link BD. Calculate…

A:

Q: 110% I DOP systems V. 1.1 Unsolved examples with answers Example 2.6 Calculate the torsional viscous…

A:

Q: • Part A The 23 ky slander red is allachod to a spring, which hs an unatretchec length ot 2 m.…

A: Given Datam=23kgl=2mθ=30°

Q: Q2: Full journal bearing of 50 mm diameter and 100 mm long has a bearing pressure of 1.4 N/mm'. The…

A:

Q: In one cycle, a freezer uses 785 J of electrical energy in order to remove 1950 J of heat from its…

A: given data electrical energy required = 785 J heat removed from freezer = 1950J temperature of…

Q: Find the equivalent translational mass at location A of the system shown in the figure. Please also…

A:

Q: 25 20 Beam Deflection Data of Steel Distance between fulcrum (mm) 400 500 600 Load (N) Beam…

A: (A) With the increases in load the beam deflection increases for steel , brass and aluminum.  The…

Q: A 3500-lb automobile travels down a 10° inclined road at a speed of 20 ft/s. If the driver jams on…

A:

Q: g Ø20 60 50 85 30 80 020 위 R30 100 이 20 230 50 0301 R25 40 20 30 35 38 500 100 20 요 55 19

A: According to the details provided in the question, we need to calculate the section view.

Q: a. What is the mass of the gas in kg b. What is the mass of the piston in kg c. Calculate the volume…

A: PV=mRT m =PV/(RT) = (200 *1000*0.5)/(488.21* 408) = 0.502034 kg

Q: 1:25:31 > A cantilever beam is subjected to an inclined force (P) as shown in Figure 1, the…

A: Given data:- P= 400 kN find the normal component of force at point A.

Q: single-cylinder recipr rpm 0: and the stroke is 32 mm the mass of the revolving parts at 16 mm…

A:

Q: Pressure drop and heat transfer in suction line Decrease compression ratio & discharge temperature…

A: Answer - Option -B [ Increase compression ratio and discharge temperature ]

Q: The 10-lb block A travels to the right at va = 3.1ft/s at the instant shown. I the coefficient of…

A:

Q: In one cycle, a freezer uses 785 J of electrical energy in order to remove 1950 J of heat from its…

A:

Q: 2) Design the fillet weld for direct shear connection for the angle loaded as shown in the figure.…

A: INTRODUCTION: The fillet weld and the butt weld are two different types of weld joints, according to…

Q: what is the unit of the medium resistance and the specific cake resistance

A: Given Resistance To find Unit of Cake resistance Unit of Medium resistance

Q: Derive the dynamics of a geometric brownian motion with zero drift and constant diffusion term.

A: Given Geometric brownian motion To find Dynamics equation

Q: Ex/ A Carnot engine is operating at temperature 200 k and 800 k, if 13500 J of heat energy in…

A: GivenT1=200 KT2=800 KQa=13500 J

Q: Q1 A Carnot refrigeration cycle absorbs heat at -8°C and rejects heat at 55°C. (a) If the heat…

A:

Q: Multiple Evaporator Systems it may be required to have different temperature maintained at single…

A: Correct answer: (B)

Q: How does superfinishing differ from honing?

A:

Q: Q3/A (60 lb) weight is suspended from a spring of modulus (10 lb/in). When the system is vibrating…

A:

Q: 30° 1000 mm A Area 30 mm 20 mm In Figure 1, the normal stress on the cross- sectional area is (in…

A:

Q: Q.3 A Carnot cycle heat pump operates with R134a as the refrigerant. The condenser and evaporator…

A:

Q: Four pounds of air gain 0.491 Btu/R of entropy during a nonflow isothermal process. If p1=120 psia…

A:

Q: Write the relationship between the SI and CGS unit of moment. Of force.

A: Moment of force= Force × Perpendicular distance.   SI unit CGS unit Force N dyne…

Q: Calculate the rise of a liquid of density p = 0.8 g cm-3 inside a square straw, with the cross…

A: Given; Density of the liquid, ρ=0.8 g/cm3=800kg/m3 Side of the square cross L=2 mm Surface tension…

Q: QUESTION 2 an endless rope haulage must convey 6000 tons per 5-hour shift. If 2-tor sed on a…

A:

Q: QUESTION 2 An endless rope haulage must convey 6000 tons per 5-hour shift. If 2-ton used on a…

A: INTRODUCTION: In this issue, we will determine the needed space between the trucks while the truck…

Q: Q1 If your roll number is 12L3456, 12 represents your batch and 3 is the first digit of your roll…

A:

Q: Q2/ For the beam shown, Draw (S.F.D)and (B.M.D). 10 KN B TH ▬▬▬▬ 2m 722 5 KN/m HI D

A: Given

Q: 4. A soccer ball with a mass of 0.510kg is initially moving with a speed of 2m/s. A soccer player…

A:

Q: Q.3 A Carnot cycle heat pump operates with R134a as the refrigerant. The condenser and evaporator…

A: GivenHeat pump working on carnot cyclerefrigerent R134aTc=50oC=323KTe=10oC=283Km=0.3kg/s

Q: Choose the correct answer The suction pressure of a refrigerant should be as low as possible The…

A: suction pressure of refrigerant  The suction pressure of refrigerant is defined as the pressure…

Q: What is the force needed to mechanically deform an aluminum bar with 50mm diameter? The yield and…

A: given data diameter = 50 mm yield strength = 150 Mpa tensile strength = 250 Mpa find the force…

Q: A 40-kg packing crate is pulled by a rope as shown with a force P = 200 N. The coefficient of…

A:

Q: Find The SECTION VIEW?

A: Note: As per the policy, we can solve the first question from the multiple questions. Please…

Q: A meeting hall is to be maintained at 25°C, 18Cwb. The space heat gains dropped to 20kW of which…

A: Td4=25oCTwb4=18oC Room Sensible heat Qs=16kWTd1=35oCRelative humidity of outdoor…

Q: .Mexico's metro requires the implementation of an air conditioning system for each of its cars. On…

A: Given:Ti=45°CTf=25°CV=17 m x 2.5 x 2n=130v=0.06 m3/personQ=30 KJt=1 min

Q: What is the size of the stiffness matrix of a 4-node quadrilateral element?

A: Size is 8×8 matrix

Q: Fig. 3.19 shows a hammer of mass 6 kg and pivoted at A. It falls against a wedge of mass 1 kg which…

A:

Q: Area 30 mm 20 mm In Figure 1, if the Young modulus is 200 Gpa, the strain percentage in the…

A: Given data  force P=400kN find the strain percentage in the direction of normal force .