How many Faraday is needed to deposit 1.9 g ofAluminium (AI) from AICI3 solution usingelectrolysis process.Answer:

We have , AlCl3------>Al3+ +3Cl- And, Al3+ + 3e------> Al which means that 3 mole e- is…

Answered: How many Faraday is needed to deposit…

Science

Chemistry

How many Faraday is needed to deposit 1.9 g of Aluminium (Al) from AICI3 solution using electrolysis process.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter23: Voltammetry

Section: Chapter Questions

Problem 23.8QAP

See similar textbooks

Related questions

Q: What minimum amount of voltage would you need to apply to successfully run the electrolysis of…

A: anode: 2H2O(l) ⟶ O2(g) + 4H+(aq) + 4e− E∘anode = +1.229 V cathode: 2H+(aq) + 2e− ⟶ H2(g)…

Q: The Specific Charge of Copper lons Experiment: The rate of deposition of copper (mass deposited per…

Q: Write a balanced equation to represent the overall reaction you would expect to occur in the…

A: In the molten KCl water vapour is not present. So it have only K+ and Cl- ion.

Q: Determine the oxidation number

A: As per gudielines , if multiple questions posted , first question is allowed to answer, please post…

Q: Balance the redox reaction in basic solution using the half reaction method.

Q: A solution of silver nitrate containing 12.14 g of silver in 50 ml of soluti on was electrolysed…

A: Initial mass of Ag in silver nitrate = 12.14 g Volume of solution = 50 ml After electrolysis, mass…

Q: How many Faraday is needed to deposit 1.6 g of Calcium (Ca) from CaCl2 solution using electrolysis…

Q: What current must be used to plate 1.75 moles of copper on an electrode in 6.25 minutes?

A: ∙Given:- no. of moles of copper =1.75 moles Time =6.25 minutes or 375s

Q: What products are obtained in the electrolysis of molten NaI?

A: In an electrolytic cell, electrical current is used to drive a non-spontaneous redox reaction…

Q: Water is electrolysed at a current of 3 amps for 4 hours. He and O gases are liberated at the…

A: Given: Electrolysis of H2O, H2 and O2 gases liberated at cathode and anode. Current I = 3amp Time =…

Q: The rate of deposition of copper (mass deposited per unit time) on the cathode depends on: a) The…

Q: For the cell below, label the following on the diagram provided: Cu|0.10M Cu(NO3)2 || Cu|0.0010…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: How many Faraday is needed to deposit 2.1 g of Calcium (Ca) from CaCl, solution using electrolysis…

Q: What amount of Cu (in grams) is deposited at the cathode when a current intained for 15 minutes in a…

A: Faraday's second law of electrolysis explains that when a certain amount of charge is passed, the…

Q: How many Faraday is needed to deposit 5 moles of Aluminium (Al) from AICI3 solution using…

A: Given that, Moles of Al = 5 mol No. Of Faraday = ?

Q: How many Faraday is needed to deposit 2.0 g of Aluminium (AI) from AICI3 solution using electrolysis…

A: 1 mole = 6.022×1023 [ Avogadro's number] The charge of 1 mole of electrons is called one Faraday.

Q: How much charge in Faraday is required for the reduction of 1 mol of Ag+ to Ag?

A: The relation between electrical energy and chemical change is given by electrochemistry. In this…

Q: How much silver was in the solution if all the silver was removed as Ag metal by electrolysis for…

A: Applying Faraday law W= Zit

Q: (7.12) A technician plates a faucet with 0.86 g Cr metal by electrolysis of aqueous Cr2(SO4)3. If…

A: Electrolysis is a process to change a substance chemically by passing electric current. When…

Q: How many grams of Silver can be deposited from the electrolysis of 30g AgCl?

A: The mass of silver can be deposited = 22.5792 g.

Q: charge

Q: b) The electrolysis of a sodium sulphate solution produces 0.84 L of O2 at 1 atm and 25°C. Calculate…

Q: How much current is required to electroplate a metal surface with 0.493 g nickel metal from a…

Q: Balance the following redox reaction in acldlc solution. 2+ Br (aq)+MnO,(aq) Br,(1)+Mn (aq) Br (aq)…

A: The given redox reaction is as follows: Br- + MnO4- → Br2 + Mn2+ A redox reaction is balanced by…

Q: What is the oxidation state of lead in the cathode of this battery?

A: Lead storage battery: It is used in invertors and automobiles. The battery is designed as it consist…

Q: How many Faraday is needed to deposit 1.5 g of Calcium (Ca) from CaCl2 solution using electrolysis…

A: Recall the data, Mass of Ca=1.5 g molar mass of Ca=40 g mol-1 number of Faraday=?

Q: How many Faraday is needed to deposit 0.7 g of Calcium (Ca) from CaCl2 solution using electrolysis…

Q: How many Faraday is needed to deposit 1.8 g of Sodium (Na) from NaCl solution using electrolysis…

A: Faraday's first law: The amount of substance deposited is directly related to the amount of…

Q: How many Faraday is needed to deposit 17.1 moles of Sn from SNCI4? О а. 34.20 O b. 68.40 О с. 17.10…

Q: . Electrodepositing all the Cu and Cd from a solution of CuSo, and Cdso, required 1.20 F of…

A: The two half-reactions are as follows: Cu2+ + 2e- → Cu Cd2+ + 2e- → Cd Let us assume that x is mol…

Q: 3) How many minutes will it take to plate out 16.22 g of Al metal from a solution of AS using a…

A: Given Mass of Al =16.22g Used Current =13.8amps Number of electrons =3 electrons (Al-->Al+3)…

Q: Metals A,B and C have a standard reduction potentials of +0.68V, -1.48V and -0.80V. Which…

A: Please find the below attachment.

Q: 13.76 Chrome is plated from solutions of chromium(III) ions. If a particular application requires…

Q: Which metal can be oxidized with an Sn* solution but not with an Fe" solution?

A: The order of reactivity of metals can be remembered by MAZINT- magnesium, aluminium, zinc, iron,…

Q: Salt bridge A concentration cell similar to the one shown is composed of two Al electrodes and…

A: Left compartment : anode = oxidation Right compartment : cathode = reduction Anode : Al .....>…

Q: Write the balanced reduction half- reaction: 5. 02(g) is reduced to hydrogen peroxide acidic…

Q: For each set of half reactions, write the overall balanced equation for the reaction and calculate…

A: The question is based on the concept of electrochemistry. we have to write the net ionic equation…

Q: 18.11 Calculate the standard emf of a cell that uses the Mg/Mg*and Cu/Cư²+ half-cell reactions at…

A: The galvanic cell is the type of electrochemical cell. The electrochemical cell is the one that…

Q: How long will it take in hours to create 1.026 grams of Cr at the cathode of an electrolytic cell if…

Q: What is the equation to determine cell voltages using standard reduction potential? 2. What are the…

Q: How many seconds will it take to plate out 2.19 grams of chromium metal from a solution of chromium…

Q: The electrolysis of CUCI(ag) produces Cu(s) and Cl2(g). What is the minimum external emf needed to…

A: Standard reduction potential of Cu+/Cu = 0.52 V Standard reduction potential of Cl2/Cl- = 1.36 V

Q: Steel is often coated with a thin layer of zinc if it is to be used outside. What characteristics do…

A: Steel is an alloy of iron and carbon, so it is prone to rusting. Galvanizing is a process where iron…

Q: What will be produced at the anode and cathode when an aqueous solution of AuBrz is electrolyzed?…

A: the Process of decomposition of chemical compound in an aqueous solution or in molten state…

Q: How many grams of magnesium metal will be deposited from a solution that contains Me" ions if a…

A: It is an application of Faraday 1st law of electrolysis

Q: Complete the following, providing written work for each part in order to receive credit: (a) Use…

Q: long

Q: 17) The number of Faraday of charge needed to deposit 3.54 x 10-4 moles of Cr+3 ion from its…

A: In this question, we want to determine the number of Faraday of charge. Given : moles of Cr3+ ion…

Q: Would you expect a mercury cell to give a constant voltage and why?

A: Yes, mercury cell provides a constant voltage throughout life. This is because there are no ions…

Concept explainers

Science behind corrosion-test

Corrosion is defined as an activity that transforms refined metals into more chemically stable forms such as oxide, hydroxide, carbonate, or sulfide. It refers to the slow decomposition of things (typically metals); thanks to chemical and/or electrochemical reactions with their surroundings. Corrosion engineering is the science of preventing and controlling corrosion.

Corrosion

Question

How many Faraday is needed to deposit 1.9 g of
Aluminium (AI) from AICI3 solution using
electrolysis process.
Answer:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

How many Faraday is needed to deposit 0.7 g of Calcium (Ca) from CaCl2 solution using electrolysis process.
In the electrolysis of water, how long will it take to produce 1.000 × 102 L of H2 at STP (273 K and 1.00 bar) using an electrolytic cell through which a current of 52.00 mA flows? (Answer in years!)
Given the data below:??2?7 (??)^2− + 14 ?^+ + 6 ?^− → ??(??)^3+ + 7 ?2?(?) ?°??? = 1.33 ???(??)^2+ + 2 ?^− → ??(?) ?°??? = 0.34 ? a. Draw the galvanic cell, including labelling the electrodes and the other portionsof the cell.b. Write the balanced equation for a galvanic cell (balance using the half-reactionmethod, then combine the equations).c. State which half reaction is the cathode and which is the anode.d. Calculate the standard cell potential for this cell.e. Determine the Ecell at 25°C, given: [????? (??)^?−7 ] = ?. ???? ?,[??(??)^?+ ] =?. ???? ?,?? = 5
Respond correctly to what is asked It represents the quantitative relationship between activities and the electrode potential: it is always written using the half reaction in the sense of reduction
How many Faraday is needed to deposit 5 moles of Aluminium (Al) from AlCl3 solution using electrolysis process?
In the electrolysis of water, how long will it take to produce 1.000 × 102 L of H2 at STP (273 K and 1.00 bar) using an electrolytic cell through which a current of 58.00 mA flows? Answer in yr
4. Determining electrolytic activity in a dilute solution. Electrolysis of dilute aqueous NaCl solution was carried out by passing 10 milliampere current. The time required to liberate 0.01 mol of H2 gas at the cathode is?
A magnesium bar with a mass of 6.0 kg is attached to a buried iron pipe to serve as a sacrificial anode. An averagecurrent of 0.020 A flows between the bar and the pipe.(a) Which reactions take place at the surface of the magnesium bar and the surface of the iron pipe? (b) How many years would it take for the entire magnesium bar to be consumed?
If a concentration cell is created based on the half reaction: PbO2(s)+4H+(aq)--->Pb2+(aq)+2H2O(l) determine its concentration of Pb2+ at the cathod given that the cathode [H+] concentration is 3.63 M while the anode [Pb2+] conc. is 2.43 and the H+ concentration is 0.094. Cell voltage is 0.263 V while the temp. is 22.6°C
Write balanced redox equations for the following reactions. Show the full balancing process and supply H+ and/or H2O as needed to obtain balance. Item g is balanced in basic medium while the rest are in acidic medium.
Make an inference about the effect of applied current and electrolysis time on the mass of deposited copper. Thoroughly explain and relate any observed trend to Faraday’s Law of Electrolysis.a. What happened to the mass of deposited Cu when the applied current is increasedb. What happened to the mass of deposited Cu when the electrolysis time is increased
Given the ff data at 25 C: cathode= AuNO3 anode= Hydrogen (conc. 1.01 M) In the photo attached is the table for ln [concentration of Au] against potential (V) for the electrochemical cells . It shows how the potential changes when concentration of the cathode is changed (ln concentration) 1. Determine E at y- intercept 2. Calculate delta G and Keq Thank you.