How to eliminate the errors caused by the sag method?

Q: 2. Refer to Figure Q2, which shows a diagram of a loaded frame. Using the Principle of Virtual Work,…

A:

Q: A U-tube with both limbs open to atmosphere contains two in.miscible liquids of densities P₁ and p2…

A: Using manometric equation.  Starting from the top of right limb. [Note that the density of fluid in…

Q: A cable with supports at the same elevation has a span of 600 m. The cable weighs 50 N/m and the sag…

A:

Q: Question- A water treatment plant is to treat water at the rate of 6000 m³/day. If there are two…

A: Detention time (t) t = (Volume of tank) / ( Rate of flow through the tank) t= V/Q Volume of one tank…

Q: 5. A 12-mm-diameter steel [E = 200 GPa] rod (2) is connected to a 30-mm-wide by 8-mm-thick…

A: Given ; Dia of steel rod= 12 mm , E = 200 GPa Dimension of rectangular aluminum bar : Width = 30 mm…

Q: 10. What is the net section area of steel plate 40cm wide and 10mm thick with one bolt if diameter…

A: given- width b=40 cm=40 mmthickness t=10 mmdiameter of bolt hole dh=18 mm

Q: Problem #5 a. A 30m steel tape is supported only at its ends and under a steady pull of 7kg. if the…

A: Solution: a) Given: Length of the steel tape, L=30 m Pull, P=7kg Weight of the tape, W=0.9kg

Q: 4. Compute maximum deflection at point B of the truss shown in fig.4 by using the method of virtual…

A: Given data : AE/L = 1200 k/ft Use Equilibrium equations to find reactions at support Then use joint…

Q: A water sample contains the following dissolved ions: [Na+] = 75 mg/l [HCO]=250 mg/1 [CH] = 100 mg/l…

A: Given data  Na+ = 75 mg/l ,   HCO3- = 250 mg/l  Ca2+ = 45 mg/l,    Cl- = 100 mg/l  Mg2+ = 48 mg/l,…

Q: The figure below depicts a network of bridges and land areas designed for a local garden. a) b) 0 H…

A:

Q: A flexible pavement has the following class loads during a particular hour of the day. i. ii. 80…

A: Given data- 80 buses with 2 axles, each axle load is 40 kN160 trucks with front axle load=40 kNTo…

Q: E. To transfer loads from frame A to one end of the river to frame C at the other end, high strength…

A:

Q: Problem 5.48 If rope BC will fail when the tension becomes 75 kN. (Figure 1) Figure 1 AT of 1 26 kN…

A: Given : To Find :  Fmax , FA ?

Q: Name the different layers that make up the Earth.

A: Layers of Earth: Inner core Outer core Mantle Crust

Q: Blocks D and E have a mass of 4 kg and 6 kg,respectively. Suppose that F= equilibrium.Determine the…

A: Data Given :

Q: Design a rectangular tied column for flexure in a reinforced concrete frame is subjected to the…

A: Answer Let us first calculate the Maximum axial load Pu and Maximum Moment Mu 1)Pu = 1.2*PD+1.6*PL…

Q: Beam AB, 8.5 m long, is hinged at A and has a roller support at B. The roller support is inclined at…

A: Given Data A simply supported beam with following dimensions Two point loads and one inclined force…

Q: The gear reducer is subject to the couple moments shown. Determine the resultant couple moment and…

A: Given :

Q: Z 900 N 65⁰- y O 20⁰ 35⁰ 750 N 25⁰ X

A:

Q: Q- Constant head permeability tests were performed on two soil specimens. S1 and S2. The ratio of…

A: Given data- ratio of heights=1.5ratio of dia=0.5ratio of constant heads=2To Find-Ratio of…

Q: A W1 را در 3 P ↓ B 3 2P C 3 W2 D ) A 12m long beam ABCD is loaded as shown above and rests on…

A:

Q: The figure shows a U-tube having a 5 mm x 5 mm square cross-section filled with mercury (specific…

A:

Q: In terms of quantity surveyor's unethical behaviors explain conflicts of interest, professional…

A: Apart from corruption, bribery, nepotism, there are various unethical behaviors are present in a…

Q: A laminated beam is composed of four planks, each 6 in. by 2 in., glued together to form an outside…

A: Given:Outside width(B)=6 inOutside depth(D)=10 inInside width(b)=4 inInside depth(d)=6 inSpan…

Q: Why is fire safety and prevention important? Subject: Occupational health and safety

A: Fire safety- A series of behaviours called "fire safety" are meant to lessen the damage that fire…

Q: Carbon dioxide at 30 °C and 305 kPa absolute pressure expands isothermally to an absolute pressure…

A: Given data:- The given temperature is carbon dioxide is, Ti=30°C The given absolute pressure expands…

Q: The viscosity of a certain fluid is 8 x 10 poise. Determine its viscosity in both (a) SI and (b) BG…

A: Solution: SI unit: 1 poise = 110N.s/m2 BG unit: 1 poise = 1478.8 lb.s/ft2

Q: Given the coordinates of the land defined by fence posts 1-2-3-4-5-6-1 are shown in the following…

A:

Q: A certain object weighs 541 N at the earth's surface. Determine (a) the mass of the object (in…

A:

Q: Question: If the sensitivity of an irrigation module is 0.5, then what percent variation in outlet…

A: Given- Sensitivity S=0.550% variation in the canal water depthIt is needed to find the variation in…

Q: GIVEN: f'c = 21Mpa fy= 275Mpa. Size of beam 300x600mm effective depth of 550mm REQ'D: 5m 15kN/m a.)…

A:

Q: Find the modulus of elasticity Stress=2 MPa

A: According to given data  Stress = 2 MPaStrain = 0.1

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A:

Q: The velocity field in a flow system is given by v = 2i + (x+y)j + (xyz)k. The acceleration of the…

A: Calculate the acceleration at (1,1,2)?

Q: Situation #2: A properties: Width, b = 400 mm 415 MPa rectangular beam has the following Effective…

A:

Q: urrent Attempt in Progress A 1-m³ volume of water is contained in a rigid container. Estimate the…

A:

Q: Using the Double Integration Method. for the given cross-section of the beam below, find the ff.…

A: Given:- E=100GPa Hollow rectangle outer size=250*150 Inner size=50*50 To find:- a. Rotation in…

Q: Give examples of common civil engineering symbols.

A: By creating roads, bridges, airports, homes, hospitals, parks, tunnels, stadiums, and just much…

Q: Determine the tensions in cables A, B, C and D of the cable system supporting a weight of 100 N as…

A: Given data  Find force in member A, B, C and D.

Q: What is VBA?

A: VBA: Visual basic for Application

Q: A curve having a radius of 192.18m has an intersecting angle of 42°15'. PC is at Station 0+700. Find…

A: In the question given data Radius of the curve , R = 192.18m PC (Point of curve- from where the…

Q: Q1) Draw contour lines of 301.2m, 301.6m, 302m, and 302.4m by interpolation method, with scale…

A: Solution: The contour lines for the 301.6 and 302 are drawn using interpolation method. The contour…

Q: A rod has a radius of 4m. Determine the smallest force F that must be applied along the rope in…

A: Given: r = 4m, M= 1400Nm

Q: 7. Lawrence takes out a loan For S8000 to start a business after high school, The bank charges him…

A: Hi! Thank you for the question.  As per the honor code, we’ll answer the first question since the…

Q: Analyze the continuous beam using Moment Distribution (maintain at least 3 decimal places) A w = 5…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: A sieve analysis test for fine aggregates was performed on a sample of fine aggregates and produced…

A: The given data is shown below:

Q: Small droplets of carbon tetrachloride at 68 °F are formed with a spray nozzle. If the average…

A: Given - Diameter of the Droplet = 240 um  Temprature = 68 °F Find = Pressure difference between the…

Q: A certain object weighs 231 N at the earth's surface. Determine (a) the mass of the object (in…

A: Hello dear Please find the solution below a. Mass of object m=23.55 Kg b. Weight of object on ther…

Q: 1. Estimate wind loads on the building frame shown in Fig.1 marked by dotted lines. Take floor…

A: As you are asking for only 1 question, therefore I am solving only 1st question.  To find out the…

Q: The rods AB and CD are made of steel having a failure tensile stress of ?FAIL = 500MPa. Using a…

A: Given data  Failure tensile stress = 500 MPa  Factor of safety (F.0.S) = 2  Find the smallest…