E EDA 214HW(2)1 of 19A Particular areahydro stution or steam station. The followingdata is available:Com be Supplied either byHydrosteumCapital ast /KwRunning cast /kwhInterest 8 depreciationD 2100BD 120050 fids9 %25%32 fids7,5%Reserve Capacity33%) At what load fuctor would the overall cst bethe Some in lth cases.ü) what would be the cost if genevatig 4oxio unitsat this load factor.

Part (a) Assume that maximum Demand =d Annual load factor at which overall cost is similar for…

HW(2) 1 of 1 12A particular avea Com be Supplied esther boy hydro stution or steam station. The followig data is awailable ; Hydro steum Capital cst /Kw Running cast /kwh Interest & depreciation D 2100 BD 1200 32 fids 50 fids 9 % 25% 7,5% Reserve Cupacity 33% ) At whut loud fiuctor would the overal cst be the Some in lbth cases. ü) what oubd be the cost if genorvatig 4oxio units at this loud factar.

HW(2) 1 of 1 12A particular avea Com be Supplied esther boy hydro stution or steam station. The followig data is awailable ; Hydro steum Capital cst /Kw Running cast /kwh Interest & depreciation D 2100 BD 1200 32 fids 50 fids 9 % 25% 7,5% Reserve Cupacity 33% ) At whut loud fiuctor would the overal cst be the Some in lbth cases. ü) what oubd be the cost if genorvatig 4oxio units at this loud factar.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An industrial load of200KW has a powerfactor of 0.5 lagging. Agroup of synchronousmotors operating at apower factor of 0.8leading is installed andthe over-all power factorimproves to 0.75 lagging.Determine the KVArating of the synchronousmotors installed.Answer = 130.2354 KVA
Consider the microgrid of Figure 3.66. A three-phase transformer, T1, israted at 500 kVA, 220 VY grounded/440 V delta, a transformerwith a reactance of 3.5%.Themicrogridis supplied from anAC bus of a PV generating station.The DC bus rated at 540 V.The distributionlineis 10mileslong and has a series impedance of 0.1 + j1.0 Ω per mile and local load of 100 kVA at 440 V. The microgrid is connected to the local power grid using a three-phase transformer T2, rated at 440 V Y grounded/13.2 kV delta,500 kVA with a reactance of 8%. Compute the per unitimpedance diagram of the microgrid system. Assume the voltage base of 13.2 kV on the local power grid side and kVA base of 500
A 3Ø, 1000KW, 2500V alternator is open-circuited and is operated at rated speed toproduce rated current at 4A excitation. Maintaining the open-circuit and with theexcitation adjusted to 4A, the voltage between stator terminal is 1300V. The effectiveresistance between terminal as measured with dc is 2Ω. Determine the %V.R. of thealternator at half-load and pf of 0.8 lagging.Note: Please read and analyze carefully the problem question.
A 60Hz sourcewith an effective voltage of 240 volts supplies 4500 volt-amp to a load with a p.f. of 0.75 lagging. Determine the parallel capacitance required to improve the power factor to: a) 0.9 lagging and b) 0.9 leading. What per cent reduction in line current resulted in part (a)?
COURSE: Electrical EngineeringSUBJECT: Electrical ApparatusINSTRUCTIONS:• Write the GIVEN with their respective symbols and units.• Do not skip the SOLUTIONS, do it step-by-step with their respective symbols and units• Round up to 3 three decimal places the FINAL ANSWERS and BOX it. PROBLEM: A source delivers 50 kVA to a load with a power factor of 65 percent lagging. Find the load’s average and reactive powers.
TOPIC: Power Systems, Power Plants & IlluminationINSTRUCTIONS:- Answer in this format: Given, Illustration, Required Conversion, Solution, Final Answer.- Step-by-step solution, do not skip even simple calculations to avoid confusion.- If answered in written form, make sure it is readable.PROBLEM: A generating station has two 50 MW units each running for 8,500 hours in a year and one 30 MW unit running for 1,250 hours in one year. The station output is 650 x 106 kWh per year. Calculate the utilization factor. 0.732 0.653 0.811 0.795
According to the relevant legislation, the reactive energy tariff is not applied to household subscribers with connection power in kW and below, lighting subscribers, single-phase subscribers and producers that provide energy (generation) to the system? a) 5. b) 12 c) 9. d) 50
6.8. A three phase, 50 Hz, 100 km transmission line has resistance 0.1 ohms/km, inductance 111.7 mH/km and capacitance 0.9954 x 10- uF/ph per km. The line is delivering 20 MW at a 0.8 power factor lagging and 66 kV to a balanced load. Determine the efficiency and regulation. Use nominal it method. Ans. n= 93.5%, VR = 17.47%
Find the characteristics of the load at the sending end and the efficiency of a three phase transmission line 160 km long delivering 15 MVA load at 110 kv, 50 Hz and 0.9 power factor (lagging) having inductance 1.356 mH/km per phase, capacitance 0.0085 uF/km per phase and resistance 40 ohms. Use nominal T-method Ans. Is = 70.3 20,8° Amp, Vsa.LD= 117.6 29.2 kV, power factor = 0.9898, n = 95.3%
11 A) A Single-Phase AC Distributor AB,400 meters long, is fed from end A and is loaded as under: A. 120 A at 0.6 pf lagging 300 m from Point A. B. 80 A at 0.45 pf lagging 400 m from Point A. The Resistance and Reactance of the Distributor is 0.4 Ω and 0.6 Ω per 500 m. Calculate the Total Voltage Drop in the Distributor. The Load Power Factors refer to the Voltage at the Far End.
A 5 km long, 3-phase 34.5 kV line has a horizontal configuration of 4 ft. spacing. The conductor is 336.4 ACSR with GMR of 0.0244. What is the inductance of the line? * A. 7.63 mH B. 4.76 mH C. 5.33 mH D. 6.49 mH
Two equal voltages are out of phase with respect to each other by 90 electrical degrees. If the resultant is 311 Volts, what is RMS value of each one?-write legibly-show the complete solution