I am preparing for a chem test, and this is one of my example problems. I was curious if you could help me solve this, so then i can understand how they are done? A 1.000g mixture of copper(I) oxide and copper(II)oxide was reduced quantitavely by hydrogen gas to give 0.8390 g of metallic copper. What is the mass of Copper(I) oxide in the original 1.000 g sample?

I am preparing for a chem test, and this is one of my example problems. I was curious if you could help me solve this, so then i can understand how they are done? A 1.000g mixture of copper(I) oxide and copper(II)oxide was reduced quantitavely by hydrogen gas to give 0.8390 g of metallic copper. What is the mass of Copper(I) oxide in the original 1.000 g sample?

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter1: Excel Basics

Section: Chapter Questions

Problem 4P

See similar textbooks

Similar questions

Hi, I found the data in the attached table. The question I am struggling with is attached as well. Particuarly, the last sub-question, part C, which is about what happens to the hydrate formula if the copper sample (or crucible) is "wet" rather than "dry." I think that the hydrate formula would increase from 2 to 3, but could you confirm and explain what steps I would take to know this for sure? Thank you
1. Sketch and label the main parts of the mass spectrometer. 2. Give detail description about how it works.
The average experimental mass percent of oxygen in potassium chlorate is higher than the theoretical value. This is because some of the potassium chloride product splattered out of the crucible during the heating process. Explain this statement using an analysis of the image. TV = 39.165% EV = 40.767%
How many atoms are present in a 1.5 nmol sample of pure silver? Give your answer to the correct number of sig figs and use *10^ for entering your answer in scientific notation.
Show the complete calculation for the formula weight of the EDTA that we use in this experiment. This calculation should start with the number of carbon atoms, the number of hydrogen atoms, etc. The final value should be close to 373.36. If it is not look more closely at your manual.
Calculate the theoretical yield (in grams) of magneisum oxide in this experiment.
Explain why the mass-to-charge ratio of lions in the EI mass spectrometer are usually equal to the mass of the ions?
Please help me answer these question 4. Does the pooling of results in this experiment yield an average % Mg in MgO, which is closer to the accepted value than your class average? 5. Compare the precision obtained by your class to the precision obtained by the composite of all classes. Discuss. 6. What conclusion can you draw from the analysis of the data in assessing whether this laboratory procedure gives accurate results?
What does a refractometer reading of 2 mean when distilling ethanol?
1. Several procedures for the analysis of caffeine involve extracting the caffeine into an organic non-polar solvent (such as methylene chloride CH2Cl2). This about your experiment and what is discussed in the introduction. What might the advantage be for this approach? What is a disadvantage? 2. Think about what you said in the question above. If your sample was espresso, would your answer change? Why? 3. I was careless and ended up using a wavelength other than the peak (Say 250 nm). Would I still be able to carry out the experiment successfully? What might be the reason that I do not get optimum results? 4. I carried out the experiment using a scratched (or several scratches) cuvet for one standard, and clear cuvets for others. How might my calibration curve change (improve or get worse and why)? Pllllz answer these questions as soon as possible
The mass of an empty evaporating dish and watch glass is 62.549 g. After the addition of an unknown, the mass was 63.089 g. The evaporating dish and unknown were heated strongly for 10 minutes. After cooling, the mass of the evaporating dish and sample were found to be 62.928 g. A sample of the unknown was also submitted to a flame test, and found to produce a violet flame. Is the unknown NaHCO3, Na2CO3, KHCO3, or K2CO3? Explain the reasoning used to arrive at your answer
Why does the test for the presence of potassium involve a flame test?