(i) Determine how many flip flops are required to build a binary counter that count from 0 to 1023? (ii) Determine the frequency at the output of the last flip flop of this counter for an input clock frequency of 2 MHz. (iii) Give the MOD number of this counter. (iv) If the counter is initially at zero, determine the count if it hold after 2060 pulses.

(i) Determine how many flip flops are required to build a binary counter that count from 0 to 1023? (ii) Determine the frequency at the output of the last flip flop of this counter for an input clock frequency of 2 MHz. (iii) Give the MOD number of this counter. (iv) If the counter is initially at zero, determine the count if it hold after 2060 pulses.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

Design a synchronous 3-bit binary up-counter using D flip-flops.Determine the Number of FFs required, Counting Range, and Drow theexcitation table
Design a 4 bit binary ripple counter that trigger as mention below on the edge of the clock. What will be the count if (a) the normal outputs of the flip‐flops are connected to the clock and that trigger on the positive‐edge of the clock (b) the complement outputs of the flip‐flops are connected to the clock and that trigger on the negative‐edge of the clock
Compare the circuits, characteristic tables, and the timing diagrams of SR Flip-flops, JK flip-flops, and D flip flops. In your own words, describe the similarity and differences in behavior of these flip flops. Then go on to make comparison between Mealy and Moore machines, first describe each FSM and then elaborate on the similarity and differences between them.
Design a 3 bits binary synchronous counter with JK flip-flops. That count the odd numbers
Assume an 8-bits regular up counter with the current state 10100111, how many flip flops will complement (flip) its current state to achieve the next count?
Design a 3 bits binary synchronous counter with JK flip-flops. That count from 0 to 4.
Design a binary counter that counts from 0 to 5. At each clock pulse, 3 lights will be ON and 3 lights will be OFF. Use JK flip flops.Steps for solution:-> State diagram-> State table-> K-map reductions-> design
Design a 2-bit synchronous binary counter using T flip-flops. Include the state diagram, state table, state equation, flip-flop input function and logic diagram
Design a continuous counting synchronous counter circuit as 0,5,7,1,3,0 respectively, using d flip flop and show the circuit connections by drawing
Design a 2-bit synchronous binary counter using T flip-flops. Requirements: a.) State diagram b.) state table c.) State equation : A (t+1) = B (t+1) = d.) Flip-flop input functions : e.) Logic diagram
Draw and explain the operation in detail (while including necessary table) the block diagram and logic circuit diagram of J-K master-slave (M-S) flip flop. Why an M-S configuration is necessary?
how about if it's low level clocking d flip flop?? what is the waveform for it?