If initial and equilibrium concentration of acetic acid before and after the adsorption is 1 gmol/liter respectively and the volume of solution taken is 50ml.Then the weight of acetic acid adsorbed/unit mass of charcoal is a. 1 g b. 2 g с. 3 д O d. 0 g

If initial and equilibrium concentration of acetic acid before and after the adsorption is 1 gmol/liter respectively and the volume of solution taken is 50ml.Then the weight of acetic acid adsorbed/unit mass of charcoal is a. 1 g b. 2 g с. 3 д O d. 0 g

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter11: Solutions

Section: Chapter Questions

Problem 39P

See similar textbooks

Related questions

Q: The following data were obtained for the adsorption of acetone on charcoal from an aqueous solution…

Q: Sketch and explain the differences between adsorption isotherms of nanoporous adsorbent and porous…

A: Adsorption is a process or phenomenon in which a substance adheres to another substance, when the…

Q: The surface area of 1.0 g alumina was determined by adsorption of nitrogen at -196°C. At pressure of…

A: The BET equation for the multi-layer adsorption of a gas on a solid surface is given as PP∘V(P∘ -…

Q: 4. If a monolayer of N2 molecules is 0.03075 mole per one gram of activated carbon, and the surface…

Q: 0.1 g of a zeolite adsorbs 5.58 cm³ of N2 gas at a pressure of 5.56 mbar, and 22.22 cm3 of N2 gas at…

A: Introduction: The sorption of a gas or liquid on a solid surface is called adsorption…

Q: Gold particle size range ....... .. nanometers show the highest cell uptake. Larger particles, for…

A: Gold particles, sized between 1 and 100 nm indiameter show the highest celluptake. Larger particles,…

Q: 51. The adsorption of CO on mica at 90K gave the following results: Pressure 1.05 4.55 5.46 7.91…

A: To show whether the given data fit the Langmuir adsorption isotherm or not. “Since you have…

Q: 10. If x is amount of adsorbate and m is amount of adsorbent, which of the following relations is…

A: Adsorption is the deposition of atoms on surface of a material.

Q: n gravimetric analysis unwanted material gets precipitated along with the required product.…

A: Adsorption and absorption are the two process take place in surface chemistry.

Q: In the adsorption of N2 at 90.1 K on a certain solid, the following volumes of gas, reduced to…

A: a) The BET equation is given by, where p and p0 are the equilibrium and the saturation pressure of…

Q: n gravimetric analysis unwanted material gets precipitated along with the required product.…

A: Gravimetric analysis is a method used for quantitative analysis of chemical species.

Q: adsorption

A: Qmax is basically the maximum adsorption capacity considered of a particular material. It even tells…

Q: A solid in contact with a gas at 12 kPa and 25°C adsorbs 2.5 mg of the gas and obeys the Langmuir…

A: Given:A Solid in a contact with gas at P1 = 12 kPa and T1 = 25°C adsorbs 2.5mg of the gas and obeys…

Q: kindly answer this problem and follow this format GIVEN REQUIRED SOLUTION and write regibly thank…

A: 1.26 g of substance A is adsorbed in charcoal from the aqueous solution

Q: The destruction and removal efficiency for a particular VOC in an incinerator is 97.5%. Determine…

A: We have find out mass flow rate

Q: A thin film of Co was deposited on the end of a long cylinder of Fe3O4. Afterwards, the cylinder was…

A: Diffusion coefficient can be manipulated by using the Fick’s law .The equation for diffusion…

Q: The following data were obtained for the adsorption of a certain material (ORA) on activated carbon…

Q: 6. Calculate the acetic acid adsorption on a solid adsorbent, if the equilibrium concentration of…

Q: A certain solid sample adsorbs 0.63 mg of CO when the pressure of the gas is 36.0 kPa and the…

A: Given Data : At Pressure 36 kPa, Mass of CO adsorbed = 0.63 mg and At pressure 4 kPa, Mass of CO…

Q: The adsorption of a gas is described by the Langmuirisotherm with a= 1.85 kPa-1 at 25 oC. Calculate…

A: Given: a=1.85 k Pa-1 To find: pressure of the gas

Q: 2. Initial concentration of SAS solution equals to 0.44 mol/dm³. After adsorption of SAS from 60 cm³…

A: A question based on adsorption that is to be accomplished.

Q: A lake with volume of 200 m³was contaminated with oil. Activated carbon was used as adsorbent for…

A: The adsorption isotherm is drawn by plotting a graph between log q and log C. The linear line of the…

Q: The technique of the sorption purification of living body, in which adsorption of toxic substance…

A: Answer is option (c) enterosorption.

Q: 1. The following are data for the adsorption of CO on wood charcoal at 0°C. The pressure P is in mm…

A: The relation between the gas absorbed on the surface and gas pressure is known as Freundlich…

Q: 2. The following data are for Xenon adsorption on ZSM5 zeolite. Evaluate the constants from the a)…

A: To Evaluate the constants from a) Langmuir Isotherm b) Freundlich Isotherm

Q: Gold particle size range nanometers show the highest cell uptake. Larger particles, for example,…

A: Gold particles, sized between 1 and 100 nm in diameter show the highest celluptake. Larger…

Q: In a sample of MgO held at 1500°C grains of MgO grew from 1um diameter to 10 um diameter in 1 hour.…

A: Answer: In given data: T = 15000C, diameter= 1 to 10 um. time = 1.0 hrs. Diffusion energy = 250…

Q: A certain solid sample adsorbs 0.44 mg of CO when the pressure of the gas is 26.0 kPa and the…

Q: Gold particle size range ... .. nanometers show the highest cell uptake. Larger particles, for…

A: Gold particles, sized between 1 and 100 nm in diameter show the highest celluptake. Larger…

Q: 17. It is known that the adsorption of carbon monoxide is molecular adsorption on the surface of…

A: Adsorption is a physical process in which one substance get attached physically on the surface of…

Q: 5) In the adsorption of N2 at 90.1 K on a certain solid, the following volumes of gas, reduced to…

A: The BET equation is given by, where p and p0 are the equilibrium and the saturation pressure of…

Q: Calculate the initial sticking probability of oxygen, if O2 gas at 10-6 mbar is dissociatively…

A: The sticking probability (s) = paI where, Pa = adsorption rate I = Flux

Q: Q1) Calculate the quantity adsorbed at equilibrium according to first and second order equations for…

A: The first-order equation for adsorption of methylene blue on activated charcoal is:…

Q: A thin film of Co was deposited on the end of a long cylinder of Fe3O4. Afterwards, the cylinder was…

A: Concept: Diffusion coefficient can be calculated using Fick's Law. J =DdcdxOn rearranging, we…

Q: Template Assisted Crystallization (TAC) is a a commercial softening alternative. Which of the…

A: Template assisted crystallization is a commercial softening alternative which involves use of…

Q: synthesis of Tris(ethylenediamine)nickel(1I) chloride dihydrate The equations of the preparation of…

Q: The adsorption isotherms for two test material, A and B, were generated to determine which material…

A: Adsorption is confined to the formation of a single monolayer of adsorbate at the adsorbent surface,…

Q: 3.1 Briefly describe why (and how) adsorption takes place on a solid surface. 3.2 Use your knowledge…

Q: When plotted according to the linear form of the BET equation, data for the adsorption of N2 on…

Q: I Need —> 1. Try fitting these data using Langmuir Isotherm and obtain K and monolayer of ORA…

Question

If initial and equilibrium concentration
of acetic acid before and after the
adsorption is 1 gmol/liter respectively
and the volume of solution taken is
50ml.Then the weight of acetic acid
adsorbed/unit mass of charcoal is
a. 1 g
b. 2 g
с. 3 g
d. 0 g

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Potassium hydrogen phthalate is a solid, monoprotic acid frequently used in the laboratory as a primary standard. It has the formula KHC8H4O4. This is often written in the short-hand notation as KHP. If 25.0mL of a potassium hydroxide solution are needed to neutralize 2.26g of KHP, what is the molarity of the potassium hydroxide solution? Potassium hydrogen phthalate sometimes called potassium biphthalate, as shown on this bottle is an acid that is convenient to store and use because it is a solid.
Tris(pentatluorophenyl)borane, commonly known by its aeronym BARF, is frequently used to initiate polymerization of ethylene or propylene in the presence of a catalytic transition metal compound. It is composed solely of C, F, and B; it is 42.23% C and 55.66% F by mass. a. What is the empirical formula of BARF? b. A 2.251-g sample of BARF dissolved in 347.0 mL of solution produces a 0.01267-M solution. What is the molecular formula of BARF?
25 mL of a bleach (NaOCl) sample is diluted to 500 mL. An excessive amount of KI is added to the 20 mL solution taken from here and the I2 released is titrated with 35.5 mL of 0.0409 M NaS2O3. Accordingly, calculate the weight percent by volume of NaOCl in the sample. (MaNaOC:74,4 g/mol)
1.Calculate the normality of the solutions containing 5.267g/L K2Cr2O7 (the Cr is reduced to Cr3+).(FW=294.19 g/mol) 2.A and B react as follows: A + B 2C. The equilibrium constant is 5.0 x 106. If 0.40 mol of Aand 0.70 mol of B are mixed in 1L, what are the concentrations of A, B and C after reaction? 3. The following data is given at a certain temperature:(1) 2N2 (g) + O2 (g) 2N2O (g) K1 = 1.2 x 10-35(2) N2O4 (g) 2NO2 (g) K2 = 4.6 x 10-3(3) ½N2 (g) + O2 (g) NO2 (g) K3 = 4.1 x 10-9Calculate the molar equilibrium constant, K for the reaction:2N2O (g) + 3O2 (g) 2N2O4 (g)
A public water supply was found to contain 0.8 partper billion (ppb) by mass of chloroform, .(a) How many molecules would be present in a350 mL glass of this water? (b) If the in part (a)could be isolated, would this quantity be detectable onan ordinary analytical balance that measures masswith a precision of g?
All the CaSO4 present in 0.511g of an impure sample of plaster is converted to 0.821g BaSO4. What is the % of CaSO4 in that sample?
What is the molarity of a solution in which 150g of CaO are dissolved in 1900mL of solution? (Use thefollowing given information: overline MW:Ca=40g/mol , O=16g/molA. 1.41 mol/LB. 0.0014 mol/LC. 0.0014 MD. 1.41 m
xwidevumaodecsrnocrmiocrvsntrclfmvrcxAMOICcinozcstbunvrlmxcmervor,tnivCCBSVI,dv,drvnkcnvunivrmrn binbo,bynlmrvtmiceucreivnebttnoevnejsfkdnxmvnfgkdjfkdgjksfjsnsfrgirog .1.If a dry gas is isothermally mixed with a liquid in a fixed volume, will the pressure remain constant with time? ans. No, explain. asnjcaericaqeonievtbcneivobuvntoigobnrcotuicnivvnrv
What mass of silver nitrate will precipitate out of solution if 950.0g of silver nitrate is initially dissolved into 225 g of water at 50oC and then the solution is cooled to 20oC?
True or false reflux is the process of heating a reaction mixture and condensing the solvent vaports back into the reaction vessel, whereas boiling is the process of heating a reaction mixture and allowing tye vapor to eacape
The following evidence was obtained from an experiment to determine the solubility of calcium chloride at room temperature. A sample of saturated calcium chloride solution was evaporated to dryness, and the mass of solid residue was measured.EvidenceVolume of solution (mL) = 15.0Mass of empty beaker (g) = 90.54Mass of beaker and residue (g) = 101.36The solubility of calcium chloride is g/100 mL
A smart chemical engineering student spilled some peach juice onhis expensive T-shirt. He knew that he should rinse at least the part ofhis T-shirt in water before the stain becomes permanent, and he had todry it very quickly so that he could wear it in the afternoon party.Suggest methods (at least two) to that student to dry the T-shirt asquickly as possible.