If R is the total resistance of two resistors, connected in parallel, with resistances R1 and R2, then11RR RIf the resistances are measured in Ohms as R = 172, R2 = 562, with possible error of 1% in each case, estimate the maximum error in thecalculated value of R.The estimate of the maximum error in R is: 73/95200Help Entering Answers

Given data The resistance for the resistor 1 is R1=17 Ω. The resistance for the resistor 2 is R2=56…

If R is the total resistance of two resistors, connected in parallel, with resistances R, and R3, then 1. 1 1 R. R R2 If the resistances are measured in Ohms as R, = 172, R = 562, with possible error of 1% in each case, estimate the maximum error in the calculated value of R. The estimate of the maximum error in R is: 73/95200

If R is the total resistance of two resistors, connected in parallel, with resistances R, and R3, then 1. 1 1 R. R R2 If the resistances are measured in Ohms as R, = 172, R = 562, with possible error of 1% in each case, estimate the maximum error in the calculated value of R. The estimate of the maximum error in R is: 73/95200

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Similar questions

Consider a resistor made from a hollow cylinder of carbon as shown below. The inner radius of the cylinder is Ri= 0.20 mm and the outer radius is R0 = 0.30 mm. The length of the resistor is L = 0.90 mm. The resistivity of the carbon is =3.5105 m. (a) Prove that theresistance perpendicular from the axis is R=2L1n(R0Ri) . (b) What is the resistance?
Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
If two 20uf capacitors in series were connected to two 1 k ohm resistors in parallel… what would the time constant of this circuit be?
Calculus If R is the total resistance of two resistors which are connected in parallel with resistances R1 and R2 then If the resistances are measured in Ohms as R1=27Ω, R2=48Ω with possible error of 0.50% in each case, estimate the maximum error in the calculated value of R.
From the given circuit, find I, the power dissipated by the resistor, and the power supplied by each source. Assume V1 = 11 V, V2 = 14 V, and V3 = -6 V.
In the figures, the value of a resistor "R" will be determined using the ammeter-voltmeter arrangement. The ammeter has a resistance of rA=0.5 Ω and the voltmeter rV=20000 Ω, within what interval of real values of "R" the measured values will be correct, up to within 5%, if the measurement is carried out according to circuits (a) and (b).
The RC charging circuit in a camera flash unit has a voltagesource of 275 V and a capacitance of 125 µF. (a) Findits resistance R if the capacitor charges to 90.0% of its finalvalue in 15.0 s. (b) Find the average current delivered to theflash bulb if the capacitor discharges 90.0% of its full chargein 1.00 ms.
Digital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor, which has a temperature coefficient of resistivity of α = −0.0600 (°C)-1, after it has reached thermodynamic equilibrium with the patient. What is a patient’s temperature, in degrees Celsius, if the thermistor’s resistance at that temperature is 82.5 % of its value at 37.0°C (which is normal body temperature)?
A heating element in a stove is designed to dissipate3.00 x 103 W when connected to 240. V. (a) Assuming theresistance is constant, calculate the current in the heatingelement if it is connected to 120. V. (b) Calculate the power itdissipates at that voltage.
The RC charging circuit in a camera flash unit has a voltage source of 285 V and a capacitance of 131 µF. HINT (a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 13.2 s. Ω (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.14 ms. A