If the gain of the effective medium in a laser is (1.05), its mirror reflectivity coefficient (0.999 & 0.95), the laser length (30 cm) and the loss coefficient (a=1.34x10-4 cm) calculate: a- loss factor k, b- gain of one cycle G, c- gain coefficient y?

If the gain of the effective medium in a laser is (1.05), its mirror reflectivity coefficient (0.999 & 0.95), the laser length (30 cm) and the loss coefficient (a=1.34x10-4 cm) calculate: a- loss factor k, b- gain of one cycle G, c- gain coefficient y?

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter9: Condensed Matter Physics

Section: Chapter Questions

Problem 56P: The measured density of a KCl crystal is 1.984 g/cm3. What is the equilibrium separation distance of...

See similar textbooks

Related questions

Q: What are the magnitude and direction of the electric force on an electron in a uniform electric fiel...

Q: +4.00 µC The drawing shows an equilateral triangle, each side of which has a length of 2.00 cm. Poin...

A: Force between two points charges F = kq1 q2 /r2 If two forces acts at a point net force can be de...

Q: Q3- Choase (Twa only): A) Mention the types of potential energy ? B)Explain the gas Embelism ? COSho...

Q: 3. Calculate the electric field intensity midway between two point charges, one of +500 statC, the o...

Q: should not be used in calculating for other values because it is already rounded off and might affec...

A: Given A silver sphere of diameter 20 cm carries a total charge of -3uC uniformly distributed over...

Q: II. Calculate the values asked in the following questions with the given circuit diagram. Determine ...

A: C1 = 1 μF C2 = 1 μFC3 = 1μFC4 = 1 μFC5 = 1μFV3 = 5 volts

Q: A bucket of water is pushed from left to right with increasing speed across a horizontal surface. Co...

Q: 2. A car enters a 350 m radius curve at a speed of 50 kph. If it accelerates at 2m/s², find its tota...

Q: Given the following data solve for the Equilibrant Force: F1= 85.0 N@ 15.0° N of E F2= 25.0 N @ 20.0...

Q: What is the pressure at the bottom of a 2.0-km-deep oil well filled with oil of 8.6 x 10^2-kg/m^3 de...

A: Given Density of oil D = 8.6 × 102 kg/m3 Depth of oil well h = 2 km h = 2000 m To find Pressure ...

Q: (b) A block of mass, m = 0.40 kg is attached to a spring with force constant, k= 2.5 Nm' and damping...

A: Given: x(t) = Ae-b2mtsinωt+φ0b = 0.56 kg/secm = 0.4 kgk = 2.5 N/mAt t =0, v = -0.6 m/s

Q: What are some of the physical properties of substances that exhibit only dispersion forces?

A: Given : What are some of the physical properties of substances that exhibit only dispersion forces

Q: Suppose you begin sliding down a 15° ski slope. Ignoring friction and air resistance, how fast will ...

Q: 3.Two particles A and B are released from rest, having equal charges of -8 x 10-6 C ad initially sep...

A: Given, Charge of each Particle (q1=q2)=-8×10-6 C Separation Distance between them (d)=0.025 m Mass o...

Q: An aluminium (Bulk Modulus =70.0 GPa) sphere of radius 53.1 cm is dropped to the bottom of a 2.80 m ...

A: We have givenBulk Modulus =70 GPaSphere of radius =53.1 cmDepth of dropped sphere =2.80 m

Q: The hydrostatic pressure experienced by a scuba diver at 40 meters below the surface of the ocean is...

A: As we go down the iicena ,the pressure increases as the water exerts a pussh .

Q: If a star’s parallax is 35 arcseconds, what is the distance to the star?

Q: Data and Results Initial Length Initial reading of micrometer caliper Final reading of micrometer ca...

Q: Explain what is Reservoir Petrophysics (100 words).

A: Petrophysics reservoirs is the study for the hydrocarbon industry. Petrophysicists are employed to h...

Q: A block weighing 400 N is pulled along a level from at a constant speed by a rope which makes 40° wi...

Q: Define the azimuth and zenith angles from sun path diagram at February 1:00 PM 10 20 30 40 June 50° ...

A: February 1 pm corresponds to the blue spot shown

Q: 12. A physics student makes a device that prevents an egg from cracking when dropped. The mass of th...

A: For egg from drop to ground Initial velocity= 0 as it is dropped V= 5m/s and accelaration ,a= -g= -1...

Q: A ball is dropped from a height of 1.0 m. An observer recorded 0.46 s as the time of fall. What is t...

A: Given: Change in time (∆t) = 0.46 second Height (S) = 1.0 m

Q: this were some problems i saw in a textbook so i can't remember if i am missing anything, so let me ...

A: 2nC, -6nC, -2nC and 1nC , r=5cm Consider Horizontal direction as X-axis Vertical direction as Y-Ax...

Q: Directions: Write all pertinent solutions including illustrations and box your final answer. 2. I...

A: Here it is given that two charges (say q1 and q2) are fixed at a distance r such that r is kept cons...

Q: The quarter ring shown has a mass m and was cut from a thin, uniform plate. Knowing that r =r2, dete...

Q: If a 40000-kg asteroid falls to earth from a very great distance away, how much kinetic energy will ...

A: We have givenMass of asteroid (m)=40000 kg

Q: apply a flame to 1 L of water for a certain time and its temperature rises by 2C°. If you apply the ...

A: Given:- Suppose you apply a flame to 1 L of water for a certain time and its temperature rises by 2...

Q: The United States and Canada use 120 V rms as the standard household voltage, while most of the rest...

A: 120 V rms as the standard household voltage Advantages- a) If a person touched a live wire so less c...

Q: 1. From the given coplanar force system which consists of two forces and one couple. Replace the for...

Q: A satellite is placed in orbit 8.10 x 10 m above the surface of Jupiter. Jupiter has a mass of 1.90 ...

A: Given Height of satellite h = 8.1 × 105 m Mass of Jupiter M = 1.9 × 1027 Kg Radius of Jupiter R =...

Q: II. A stationary proton is moved from point A, where the potential is 450V, to point B, where the po...

Q: An electric water heater consumes 5.63 kW for 2.85 h per day. What is the cost (in dollars per year)...

A: Given: The heater consumption of electricity is 5.63 kW for 2.85 h per day. The cost of electricity ...

Q: II. A silver sphere of diameter 20cm carries a total charge of - 3µC uniformly distributed over its ...

A: Given, Charge is uniformly distributed over its surface, q = -3 μC diameter of sphere, D = 20 cm rad...

Q: The capacity of a physical system to do .6 . work is called • Energy • Kinetic energy • Work If the ...

A: energy is the capacity to do work pressure = hρg mountain sickness occurs at high altitudes

Q: power supply, as shown in the figure. The resistance of R, is greater than the resistance of R2. Whi...

A: When resistors are connected in series then the same amount of current flows through each resistor, ...

Q: MN Lbs 47 degrees 28 degrees FN Lbs The resultant force is and the angle of direction from the posit...

A: Given Forces are given as MN=29 Lbs and FN=78 Lbs Angle of MN with positive x axis is θ1=47° Angel o...

Q: State Newton’s First and Second Law of Motion

A: Newton's first law of motion: An object at rest remains at rest or in motion remains in motion at co...

Q: Uniform circular motion is an example of accelerated motion because; a. the acceleration is const...

A: The force which keeps the body in circular motion is called centripetal force

Q: + Ime time Time 4. Describe in words the predicted shape of the velocity vs. time and acceleration v...

A: The predicted shape of the velocity vs. time Graph: The shape of velocity vs. time graph is a straig...

Q: 16 Half portion of a spherical capacitor is filled with a dielectric of dielectric constant k = 2 co...

A: Given: Dielectric constant, k= 2 To find: value of x ( time taken for leaking of charge)

Q: Two small plastic spheres are given positive electrical charges. When they are 15.0 cm apart, the re...

Q: - Density is defined as the ra where p is the Greek letter measured to be m = 50 ga What is the dens...

A: mass= m =50 g = 0.05 kg Volume = V = 1000 cm3= 1000 x 10-6 m3 V = 10-3 m3 density = ...

Q: A ball is thrown into the air with an initial velocity of 15 m/s at an angle of 50° relative to the ...

A: a) it is projectile motion So, Hmax = u2Sin250°/2g Hmax = (152×Sin250°)/(2×9.81) Hmax = 6.73 m ...

Q: In a lab activity, forces A and B were set on the force table. A = 0.10 N at 0 degrees and B = 0.10 ...

Q: A large number of small projectiles with initial velocity v = 20.22 m/s are launched in all directio...

Q: A particle of mass m = 4.00 kg moves along one dimension at a speed v = 2.00 m/s. The particle is su...

Q: Consider the vector whose x- and y-components are given to be 2.5094 and -4.1328, respectively. Find...

Q: B)Calculate the atmospherie pressure at 3500m in units (Pa)?

A: Write the expression for the pressure. Here, P0 is the pressure at a height of h0, M represents the...

Question

If the gain of the effective
medium in a laser is (1.05), its
mirror reflectivity coefficient
(0.999 & 0.95), the laser length
(30 cm) and the loss coefficient
(a=1.34x10-4 cm) calculate:
a- loss factor k, b- gain of one
cycle G, c- gain coefficient y?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An InGaAsP semiconductor laser operating at a wavelength of 1.3 x10-6m has a cavity (formed by its interfaces with the air) of length 300 x10-6m. Assume normal incidence of the beam on the semiconductor faces. The refractive index (n) of the InGaAsP compound is 3.9 and its absorption coefficient is alpha=10cm-1. If a film is deposited on one side of the laser to produce 90% reflectance, what is the minimum gain for laser emission? . NOTE: The refractive index of air = 1 and the Reflectance for normal incidence: R=((n1-n2)/(n1+n2))2
Suppose a pure Si crystal has 5 × 1028 atoms m-3. It is doped by 1 ppm concentration of pentavalent As. Calculate the number of electrons and holes. Given that ni =1.5 × 1016 m-3.
A three-level laser emits a light of wavelength of 5500 Å. What will be the ratio of population of upper level (E2) to the lower level (E1) if the optical pumping mechanism is shut off (Assume T = 300 K)? At what temperature for the above condition the ratio of population will be half? [kB = 1.38 × 10-23 JK-1]
The active volume of a laser constructed of the semiconductor GaAlAs is only 200 mm3 (smaller than a grain of sand), and yet the laser can continuously deliver 5.0 mW of power at a wavelength of 0.80 mm.At what rate does it generate photons?
A zener diode is specified as having a brealdown voltage 9.1V, with a maximum power of 364mW. What is the maximum current the diode can handle?
The 10-fold X-ray reduction values for (a) water, (b) concreate, (c) iron and (d) lead are equal 100 cm, 20 cm, 10 cm and 5 cm, respectively. Find corresponding values of linear attenuation coefficients.
Determine VL, IL, IZ and IR considering that the following values for R = 2.7 k ohms, RL = 450 ohms, with a power supply Vi = 50 V. Using a zener diode with a Vz = 10 V and an IZM = 32 mA. Check to see if the zener conducts with that arrangement. In the case of not driving, what arrangement do you have to make to achieve the diode conducts and stays within the safety margins indicated.
The measured density of a KCl crystal is 1.984 g/cm3. What is the equilibrium separation distance of K+ and Cl- ions?
For the circuit shown below, calculate Vout if the saturation current for the diode is 50nA, ZVT=25mV
Calculate the transistor’s Collector current if it is driven by a small Base current of 1.96mA with a Emitter current of 100mA
Discuss with details the efficiencies of Laser Diode?
Integrated circuits are composed of very high purity silicon which is doped with small and highly controlled quantities of Phosphorus (group VA) and Boron (group IIIA). For Silicon that has been doped with B with the concentration of 6.5E21 atoms per cubic meter, compute the (a) weight percent and (b) the atom percent of B present.