If the populations of two levels of energies E₁ and E, and statistical weights g; and g¡(E¡ < Ej) are found to be n, and nj, respectively, find an expression for the excitation temperature of this transition

If the populations of two levels of energies E₁ and E, and statistical weights g; and g¡(E¡ < Ej) are found to be n, and nj, respectively, find an expression for the excitation temperature of this transition

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter18: Raman Spectroscopy

Section: Chapter Questions

Problem 18.5QAP

See similar textbooks

Related questions

Q: 3. Find the molar absorptivity Concentration Measured coefficient, the R? assuming that the path len...

A: To find out molar absorptivity, first draw the graph for given data and then solve all the questions...

Q: 2. Draw a molecule with the molecular formula CŞH100 that would have the following peak(s) in it spe...

A: C5H10O

Q: 3. Rank the following in order of increasing acid strength (1-weakest acid, 15 strongest; add rank n...

Q: Which is the correct mass percentage of hydrogen in acetamide, C₂H₅NO?

Q: Sulfur dioxide combines with O2 in the presence of a catalyst as represented by the equation 2SO2(8)...

Q: The molar conductivity at infinite dilution of hydrobromic acid, sodium acetate, & sodium bromide at...

A: Molar conductivity at infinite dilution of : Hydrobromic acid (HBr) = 520.1 S cm2 mol-1 Sodium acet...

Q: Hepten-2-one is a ketone that also contains a C=C double bond between carbons 6 and 7. If this subst...

A: Alkene is reduced to give alkanes using Pt as a catalyst in presence of H2.

Q: Which is NOT true about stock solutions? A Must be rarely touched during experiments B Cannot be con...

A: Stock solution is a concentrated solution that is prepared well in advance. It is then used to prepa...

Q: What is reservior in environmental chemistry? What are O1D (O singlet D) and O3P( O priplet P)? Not ...

A: As follows.

Q: 1. The action of catalyst regarding the rate of reaction involves: A. Arranges the orientation of th...

A: The answers are below

Q: Question Completion Status: QUESTION 2 Match the hydrogens on the structure below to the appropriate...

Q: What is the cell potential for the following reaction at 25 °C? NI(s) • Cu2*(0.010 M) -- N2*(0.0010 ...

A: Answer: Nernst equation will be used over here to calculate the cell potential.

Q: The cell notation for the Galvanic cell is Cd(s)Ca2*/12(s)/" The Standard Reduction Potential are as...

Q: What is the IR of this compound ? with clear peaks

A: Infrared spectroscopy (IR) falls under the infrared region of electromagnetic spectrum and used to i...

Q: If the available number of valence electrons for a molecule or polyatomic ion does not complete all ...

A: If the available number of valence electrons for a molecule or polyatomic ion does not complete all ...

Q: The molar heats of fusion and vaporization of ethanol are 7.61 and 26.0 kJ/mol, respectively. Calcul...

A: Given Data : Molar heats of fusion ethanol , Q 1 = 7.61 kJ /mol Molar heat vapo...

Q: What is the appropriate size of volumetric flask to use if you want to dilute a 75.00 mL solution of...

A: It is observed that the concentration of the solution is inversely related with the dilution. From d...

Q: What is the cell potential for the following reaction at 25 °C? Ni(s) + Cu2+(0.010 M) → Ni2+(0.001...

A: The cell reaction given is, => Ni(s) + 2 Cu2+(0.010 M) → Ni2+(0.0010 M) + 2 Cu+(1.0 M) Given: Tem...

Q: Create 3 different lewis structures that are not resonance structures for a compound. Note that the ...

A: The three Lewis structures fulfilling all the requirements are drawn in the following step.

Q: Vanillin is being reduced to vanillyl alcohol. The chemicals involved in this reaction are: vanillin...

A: Synthesis of vanillyl alcohol from Vanillin Vanillin is a phenolic aldehyde and it has three functio...

Q: 13 4 10 5.50 g of a certain Compound X, known to be made of carbon, hydrogen and perhaps oxygen, and...

A: Here an organic compound of mass 5.5 gram containing carbon and hydrogen , perhaps containing oxygen...

Q: Which of the following is the correct IUPAC name for the MAJOR substrate product formed by the dehyd...

Q: -1 3) The IR absorption at 1630 cm belongs to (a) CH;-C=N )CH>-CH=CHICH, (c) CH2=CH-CH=CH-CH2 (d) H-...

A: The correct option are: Note: as per company policy we are supposed to answer first three questions ...

Q: Which of the following will you use to find the Ka value for bromocresol green? Select one: a.The g...

A: the Ka value for bromocresol green, we can calculate from

Q: What are the ΔHrxn and ΔSrxn values that indicate a spontaneous reaction at all temperatures? ...

A: For a spontaneous reaction : The value of ∆Hrxn and ∆Srxn = ?

Q: An element has three isotopes with the following masses and percent natural abundances. Determine th...

A: Given that,

Q: Relate the properties of water in the following: a. Water as a solvent in plant nutrition b. High ...

Q: he most convenient way of expressing the random error, regardless of the concentration or weight of ...

A: The most convenient way of expressing the random error, regardless of the concentration or weight of...

Q: Which of the following pairs is correctly matched? A. beaker: measures volume of liquids B. spatula:...

A: In chemistry laboratory different types of equipments are used. Every equipment have it's own use. ...

Q: For the following process, determine the change in entropy for the system (ASsys), the surrounding (...

Q: Which reaction is more energetically favored, one with ΔG0 = - 44 kJ/mol or one with ΔG0 = + 44 kJ/m...

A: The spontaneity of a reaction can be found out by the change in Gibbs free energy of the reaction. I...

Q: Francis A. Santos Which of the following is not a way of expressing data reliability: A Statistical ...

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: -1490 wing molecule, iustrale the molecuia I (M*) first and then cations (M-N) and

Q: please answer both

Q: Consider the reaction: N204(g) 2 NO2(g). What is AS° at 25 °C? AHP, kJ mol-1 AGf, kJ mol-1 NO2 33.85...

Q: A 30.0030.00 mL Ba(OH)2Ba(OH)2 solution of unknown concentration was neutralized by the addition of ...

Q: Consider the following equilibrium: N204(8) = 2NO2(g) Suppose two different experiments were conduct...

Q: Which of the following glassware is best used for slow dispensing of 47.00 ml of a solution? (A Grad...

A: Solution is made up of solute and solvent.Solute is present in small amount and solvent is present i...

Q: Which of the following is true for a system whose equilibrium constant is muc greater than one? The ...

A: The equilibrium constant is much greater than one signify that:

Q: A possible mechanism for the gas phase reaction of NO and H, is as follows: Step 1 Step 2 2NO N202 N...

A: The correct option is:

Q: 1. For the following questions determine what error would be introduced in the value for the calcula...

A: The solution is as follows:

Q: 4. When a person inhales, air moves down the bronchus (windpipe) at an estimate of 18 cm/s. The aver...

A: Given data: 1)Speed of air in bronchus = 18 cm/s V1 = 0...

Q: Which of the following is the correct sequence of weighing using an analytical balance? I. Press Tar...

A: The steps given are,

Q: What is the change in enthalpy for the reaction of S S2- ?

A: The reaction given is, => S + 2 e- → S2-

Q: The standard cell potential for the reaction at 298.15 K: Fe (s) + Zn2+ (aq) ⇋ Fe2+ (aq) + Zn (s) i...

Q: Which of the following describes an electrolytic cell? The chemical reaction is spontaneous ...

A: In an electrolytic cell, the anode and cathode are positively and negatively charged respectively.

Q: Which of the following is a correct practice in handling reagents? A Return any excess reagent to it...

A: The options given are,

Q: 5. Water flowing through a garden hose of diameter 2.74 cm fills a 25.0-L bucket in 1.50 min. a. Wha...

A: Diameter = 2.74 cm Volume = 25.0L Time = 1.50 min

Q: 4 5.00 5.00 4.00 6.00 6. 3.00 7.00

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for ...

Q: At 100oC and 2 bar pressure, the degree of dissociation of phosgene is 6.30 x 10-5. Calculate the e...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Calculate the relative populations of a linear rotor at 298 K in the levels with J = 0 and J = 5, given that ᷉ B = 2.71 cm−1.
Calculate the relative populations of a linear rotor in the levels with J = 0 and J = 5, given that B = 2.71 cm-1 and a temperature of 298 K.
Estimate the values of γ = Cp,m/CV,m for gaseous ammonia and methane. Do this calculation with and without the vibrational contribution to the energy. Which is closer to the experimental value at 25 °C? Hint: Note that Cp,m − CV,m = R for a perfect gas.
Evaluate, by explicit summation, the mean vibrational energy of CI4 and plot its value as a function of temperature. At what temperature is the equipartition value within 5 per cent of the accurate value? Use the wavenumbers 178 cm−1 (symmetric stretch, non-degenerate), 90 cm−1 (deformation, doubly degenerate), 555 cm−1 (deformation, triply degenerate), 125 cm−1 (deformation, triply degenerate).
For a set of non-degenerate levels with energy E=0, 80, and 160 cm-1, calc the probability of occupying each state when T= 200, 300, and 3000K. As the temperature increases, the probabilities reach a limiting value. Find the value.
The centrifugal constant for HCl is D = 4.59 x 10-4 cm-1. Determine the change in energy (in Joules) of the J = 3 -> J = 4 rotational transition when HCl is described as a non-rigid rotor but not a rigid rotor.
Estimate the centrifugal distortion constant for 1H127I, for which ᷉ B = 6.511 cm−1 and ᷉v = 2308 cm−1. By what factor would the constant change when 2H is substituted for 1H?
Calculate the relative populations of the J = 2 and J = 1 rotational levels of HCI at 25 oC. For HCI the rotational constant is B =318.0 GHz.
The four lowest electronic levels of a Ti atom are: J = 2, 3, 4 and 1, at 0, 170, 387 and 6557 cm-1, respectively. There a many other electronic states at higher energies. The boiling point of Ti is 3287 oC. What are the relative populations of these levels at the boiling point if the degeneracy of levels is 2J + 1? Is the ground state most highly populated level?
The ground configuration of carbon gives rise to a triplet with the three levels 3P0, 3P1, and 3P2 at wavenumbers 0, 16.4, and 43.5 cm-1, respectively. (a) Eva luate the electronic partition function of carbon at (i) 10 K, (ii) 298 K, (b) Hence derive an expression for the electronic contribution to the molarinternal energy and plot it as a function of temperature. (c) Evaluate the expression at 25 °C.
Answer the following questions in minimum 5 sentences 3. Describe the difference between real deviations from Beer’s law and those due to instrumental orchemical factors.4. How does an electronic transition resemble a vibrational transition? How do they differ?
Calculate the ratio of the populations in the first two rotational energy levels of carbon monoxide, the lowest J=0 energy level and the higher J = 1 energy level, at 300 K if the energy difference between the levels is 3.8 cm-1and the degeneracies gJ of the two levels are g0 = 1 and g1 = 3, respectively. (You will see in Section 20.3 that there are 2J 1 1 rotational quantum states at each energy level EJ.)