If the thickness of the insulating material in the problem with code COFFEE is increased by 30%, what will be the new insulation resistance of the cable? Answer in Megaohms. * Your answer Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of 8.2 mm. Given the specific resistance of the insulating material as 7.5E10^8 Megaohms-cm, calculate the insulation per quarter-kilometer of the cable in Megaohms. *

If the thickness of the insulating material in the problem with code COFFEE is increased by 30%, what will be the new insulation resistance of the cable? Answer in Megaohms. * Your answer Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of 8.2 mm. Given the specific resistance of the insulating material as 7.5E10^8 Megaohms-cm, calculate the insulation per quarter-kilometer of the cable in Megaohms. *

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 4PA: Using the above example, determine the wire size needed for the 400-ampere service in accordance...

See similar textbooks

Similar questions

A transmission-line cable with a length of 2 km consists of 19 strands of identical copper conductors, each 1.5 mm in diameter. Because of the twist of the strands, the actual length of each conductor is increased by 5. Determine the resistance of the cable if the resistivity of copper is 1.72-cm at 20C.
One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for commercial bare-aluminum electrical conductors lists a 60 Hz resistance of 0.0080 ohm per kilometer at for a 793-MCM AAC conductor. Determine the cross-sectional conducting area of this conductor in square meters. Find the 60 Hz resistance of this conductor in ohms per kilometer at 50C.
Using the above example, determine the wire size needed for the 400-ampere service in accordance with the National electrical Code. Assume that the conductors have type THWH insulation. (Note: As a general rule, for each 100 feet of conductor length the wire size is increased one standard size because of voltage drop.)
4. Eight 10 AWG aluminum conductors with Type THWN insulation are installed in a single conduit. What is the maximum current-carrying capacity of these conductors? Assume an ambient temperature of .
What are the colors of the conductors in nonmetallic-sheathed cable for a. 2-wire cable? _______________, _______________ b. 3-wire cable? _______________, _______________, _______________
A 415 single core cable has a conductor diameter of 0.5 cm and a sheath of inside diameter 3 cm. In cable insulation, find: (i) minimum stress (in V/cm); (ii) maximum stress in (V/cm); (iii) Describe where these minimum and maximum stress will occur in cable insulation?; (iv) Suggest what should be the minimum dielectric strength (in V/mm) of the cable insulation to avoid any breakdown of the given cable
If the thickness of the insulating material in the problem with code COFFEE is increased by 30%, what will be the new insulation resistance of the cable? Answer in Megaohms. Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of 8.2 mm. Given the specific resistance of the insulating material as 7.5E10^8 Megaohms-cm, calculate the insulation per quarter-kilometer of the cable in Megaohms.
A wind farm is being built on an island 6km offshore and needs to be connected to the power grid substation 12km down shore before it can become operational. The cost of laying cable under water is $10,000/km, and the cost of laying cable on land is $8,000/km. a) Determine the cable route that will minimize cost. b) What is the minimum cost
A transmission line has a span of 250 m between supports, the supports being at the same level. The conductor has a cross-sectional area of 1·29 cm2. The ultimate strength is 4220 kg/??2 and factor of safety is 2. The wind pressure is 40 kg/??2. Calculate the height of the conductor above ground level at which it should be supported if a minimum clearance of 7m is to be kept between the ground and the conducto
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of 8.2 mm. Given the specific resistance of the insulating material as 7.5E10^8 Megaohms-cm, calculate the insulation per quarter-kilometer of the cable in Megaohms.