Answered: If you had a graph of the current in an…

If you had a graph of the current in an AC circuit and the generator EMF as functions of time, how could you tell if the circuit were at resonance?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 44PQ: In an ideal AC circuit with capacitance, there is no resistance. Is any energy dissipated? How about...

See similar textbooks

Related questions

Q: Identify the following The voltage amplitude across the circuit to the current amplitude in an AC…

A: The circuit that has an alternating source of current used for domestic and industrial purposes is…

Q: An AC generator with an output rms voltage of 36.0 V ata frequency of 60.0 Hz is connected across a…

Q: Below circuit shows an RL circuit connected to AC source. The impedance of circuit is 25 N, and…

Q: Two RLC circuits have different values of L and C. Is it possible for these two circuits to have the…

A: Given, Two RLC circuits have different values of L and C. Is it possible for these two circuits to…

Q: For what value of the phase angle between the voltage output of an ac source and the current is the…

A: As we know that the formula for average power output, Pav = Vrms x Irms x Cos ϕ -------------(1)

Q: why does the current become 0 when the voltage source was changed from DC with 5V to AC Voltage…

Q: When alone in an AC circuit, inductors, capacitors, and resistors all impede current. How do they…

A: Every element has its own characteristics for the applied AC supply. For resistor, current is in…

Q: Suppose that the inductance is zero (L = 0 H) in a series RCL circuit. The rms voltages across the…

Q: In an A.C circuit, if the phase difference (p) is positive, then it shows that inductor is connected…

A: Solution

Q: The voltage-current phasor shown in the picture is for a + AC circuit. purely resistive purely…

A: SOLUTION AS

Q: How can the antenna be driven by an AC circuit?

A: What is an Antenna? An antenna is a metallic structure that captures and/or transmits radio…

Q: As can be seen, the series RCL circuit in the image below has a 90.0 Ω resistor, a 6.00 μF…

Q: Consider the RLC series circuit shown in the Figure below where R = 250 Ω, L = 75 mH, and C = 0.875…

A: Given Data Resistance is R=250 Ω Inductance is L=75 mH=75×10-3 H Capacitance is C=0.875…

Q: AL-C-R circuit as shown in figure is connected with a source 120 V ms and 50 Hz frequency. 100 Q 50…

Q: which of the following oscillations in an rlc series circuit is characterized nu a decreasing…

A: The oscillations in an LCR series circuit is a decreasing amplitude.

Q: In an A.C circuit, if the phase difference (4) is positive, then it shows that inductor is connected…

A: Solution

Q: - The Q factor of a resonant ac circuit (Section 21–15) can be defined as the ratio of the voltage…

A: (a) Explanation: Write the expression for the reactance of the inductor. XL=2πfresL Write the…

Q: The following statements are related to an RLC circuit connectedacross an AC power source. Choose…

A: a)The voltage across the inductor leads the current by 900

Q: Is it possible for the power factor of an L-R-C series ac circuit to be zero? Justify your answer on…

A: Let, the resistance in circuit be 'R' and total impedance of the circuit be 'Z' and the phase angle…

Q: In an L-R-C series circuit, what criteria could be used to decide whether the system is overdamped…

A: An underdamped system moves quickly as compared to the overdamped system. The criteria of resistance…

Q: Suppose that the inductance is zero (L = 0 H) in a series RCL circuit. The rms voltages across the…

A: Given: V=39 VVr=20 V This is a vector addition problem. The voltage drop across the resistor and the…

Q: What is the phase difference between voltage and current in a L-C-R series circuit at resonance?

Q: An ac generator with a frequency of 60.0 Hz and an rms voltage of 120.0 V is connected in series…

A: The phase angle in RLC circuits is given by ϕ =tan-1(XL-XCR) Where XL =2πfLXC =12πfC

Q: I am doing a lab about Analysis of AC circuits and am not sure about this activiy. How do we…

A: In a pure ohmic resistor the voltage waveforms are “in-phase” with the current. In a pure inductance…

Q: Two AC signals have the same amplitude but different frequencies.Are their root-mean square…

A: The root mean square amplitude depends only on peak amplitude.

Q: The voltage - current phasor diagram shown in the picture is for al AC circuit. purely capacitive…

A: By observing the graph shown in the image we can see that voltage and current are having zero phase…

Q: A coil of self-inductance L is connected in series with a bulb B and an AC source. Brightness of the…

Q: Suppose that the inductance is zero (L = 0 H) in a series RCL circuit. The rms voltages across the…

A: Solution: Consider the circuit as shown above where we have the…

Q: Explain how the impedance of a series-connected RLC circuit is given?

A: SOlution: impedance of the RLC series circuit

Q: An AC source with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a…

A: Given data The rms voltage is given as V = 36 V. The frequency is given as f = 60 Hz. The…

Q: What effect does the value of R in the circuit have on the resonant curve in the following figure?

A: A more selective circuit will have a narrow bandwidth while a less selective circuit will have a…

Q: "In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. QUESTION 17…

Q: Using the loop rule, derive the differential equation for an LC circuit

A: The LC circuit is shown as, Initially, capacitor was charged, and the i=stored in it was Q0. As we…

Q: After the switch is closed in the LC circuit shown in the figure below, the charge on the capacitor…

A: Required : How does the current not become zero in a LC circuit if the charge becomes zero on the…

Q: The voltage-current phasor shown in the picture is for a + AC circuit. wt purely inductive purely…

A: A phasor diagram. We are asked to find out the type of AC circuit based on given phasor.

Q: Explain how the relative phase between voltage and current is given for an RLC circuit?

Q: Voltage Current

A: A phasor is used to show the relationship between the voltage and current in a circuit. The phasor…

Q: For this experiment L = 34mH, C = 100 micro F, R = 10ohms , Vo= 3V were used

A: Given information: Here, the symbol has its usual meaning.

Q: An LC circuit is driven at a frequency lower than its resonance frequency. What can be said about…

A: The phase angle is given by tanϕ =XL - XcR The resonant frequency is given by ω =1LC

Question

If you had a graph of the current in an AC circuit and the generator EMF as functions of time, how could you tell if the circuit were at resonance?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

In an ideal AC circuit with capacitance, there is no resistance. Is any energy dissipated? How about in a real AC circuit with capacitance?
Military aircraft use 400-Hz AC power, because it is possible to design lighter-weight equipment at this higher frequency. What is the time for one complete cycle of this power?
Explain why at high frequencies a capacitor acts as an ac short, whereas an inductor acts as an open circuit.
What is the impedance of an RLC series circuit at the resonant frequency?
The emf of an ac source is given by v(t)=v0sint. where V0=100V and at =200rad/s . Calculate the average power output of the source if it is connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
Calculate the rms currents for an ac source is given by v(t)=v0sint , where V0=100V and =200rad/s when connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
An AC generator with an rms emf of 15.0 V is connected in series with a 0.54-H inductor. The frequency of the source emf is 70.0 Hz. Draw a phasor diagram for this circuit, including the current, the potential difference across the inductor, and the source emf. Draw your diagram with the current phasor pointing toward the right along the horizontal axis.
What is the resistance R in the circuit shown below if the amplitude of the ac through the inductor is 4.24 A?
Suppose you have a simple homemade AC generator like the one in Figure 32.20 (page 1026) whose emf is about half of what you need to power a particular motor. How can you easily modify the generator to suit your needs? Explain your modifications specifically.