III -"Particle Size Distribution Test"Tabulation of Data:147SieveSieveMassMass ofMass of SoilPercentageCumulativePercentNumberSizeofeach SieveRetained-(Wn)on eachpercentFiner(mm)each+ Retainedsieveretained(%)SieveSoil(Rn)(Σ Rn )(3)700(g)44.7672582.38700780102.00700810200.84700860400.42700880600.25730950800.18074011201000.14975013402000.074800910Pan900985Plot the points of each sieve size between particle size and Percent finer.100908070504020100.0000.0010.0100.1001.00010.000Particle Size (mm)Particle Size Distribution ResultPercentage Passing (%)

Answered: Image /qna-images/answer/75d3286c-942d-4ea1-bc60-3e7fb368938e.jpg

Answered: III -"Particle Size Distribution Test"…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

GEOTECHNICAL ENGINEERING: The resuts of a sieve analysis for a soil sample are given in the Table. Cc = 0.5 and Cu = 5. If the LL and the PL of the soil sample are 55 and 40 respectively, classify the soil according to USCS classification. Sieve Opening (mm) % passing 4.75 45 0.075 9
Classify the following soil by the AASHTO classification system. Percent passing No. 4 sieve = 92Percent passing No. 10 sieve = 87Percent passing No. 40 sieve = 65Percent passing No. 200 sieve = 30Liquid limit = 22Plasticity index = 8
For a soil, given e= 0.75, w= 22%, Gs= 2.66, calculate the dry density of soil in slug/ft3. Note ρ of water= 1.94 slug/ft3 a. 3.8 b. 2.95 c. 3.6 d. 2.85 With fbd if necessary
Geotechnical Engineering (UPVOTE WILL BE GIVEN. PLEASE ANSWER THE QUESTION CORRECLTY. NO LONG EXPLANATION NEEDED. FOLLOW THE INSTRUCTIONS CAREFULLY.) A moist soil weighed 895 g with a volume of 425 cm3. After drying, the sample weighed 775 g. Of the dried soil, 400 g was poured into a vessel loose state. Its volume subsequently determined to be 275 cm3. That same 400 g was then vibrated and tamped to a volume of 212 cm3 with Gs = 2.71. Determine the designation of the granular soil based on its relative density. (3 decimal places - Do not round off unless it's the final answer)
Expand in 5 sentences how you are going to interests the results of proctor's compacting test?
Classify the following soil by the Unified Soil Classification System. Percent passing No. 4 sieve = 82Percent passing No. 10 sieve = 71Percent passing No. 40 sieve = 64Percent passing No. 200 sieve = 41Liquid limit = 31Plasticity index = 12
Geotechnical Engineering (UPVOTE WILL BE GIVEN. PLEASE ANSWER THE QUESTION CORRECLTY. NO LONG EXPLANATION NEEDED. FOLLOW THE INSTRUCTIONS CAREFULLY.) A moist soil weighed 895 g with a volume of 425 cm3. After drying, the sample weighed 775 g. Of the dried soil, 400 g was poured into a vessel loose state. Its volume subsequently determined to be 275 cm3. That same 400 g was then vibrated and tamped to a volume of 212 cm3 with Gs = 2.71. a. Determine the relative density of soil in %. b. Determine the designation of the granular soil based on its relative density.
a layer of soil in a tube that is 100mmx 100mm in cross section. Water is supplied to maintain a constant head dierence ot a ocross the sample. The height of each soil sample is 100mm. Knowing that the thiree soll sample were having the sanme length the distane of point B to Ais 300mm. Calculate the eguivalent kin cm/sec from point A to B if k1 k2. and k3 is equal to 1x10 cm/se. 3x10 cm/sec and-4.9x10cm/ser espee
The data from falling head test is shown.Diameter of standpipe: 5cmInitial Head: 93.59cmDuration of test: 19minLenght of Soil sample: 32.37cmDiameter of permeameter: 44cmIf the soil permeability is 0.0051 cm/min, determine the final head (cm) of the permeability test.Roud off to two decmila places.
A 500g (assume no wastes) of dry soil was used for a soil mechanical analysis. Themass of soil retained in each sieve, and hydrometer analysis data are given in Table 1and Table 2, respectively.Table 1. Sieve Analysis DataUS SieveDiameter Mass Ret., g2.00 mm 101.40 mm 20500 μm 135150 μm 60250 μm 145850 μm 6075 μm 45 Particle PercentDiameter Passing, %20 μm 2.510 μm 1.52 μm 11. What is the value of the percent passing for sieve with 2 mm. opening inpercentage?2.What is the value of the percent passing for sieve with 150 μm. opening inpercentage?3.What is the value of the coefficient of uniformity?4.What are the percentages of gravel, sand, and Fines using the limits indicated byUSCS?5.What are the percentages of gravel,…
Subject: Soil Mechanics A. Classify the Soil Using USCS (with explanation/ justification) Given data: D10 = ? D30= 0.0023mm D60= 0.032mm Liquid Limit= 49% Plastic Limit= 24% CHOICES: a. CL (lean clay with gravel) b. CL ( lean clay with sand) c. ML (silt with gravel) d. ML (Silt with sand)
1. Classify the following soils using USCS givegroup symbol and group name.a) A 55% of soil sample retained in sieve no. 4and 89% retained on sieve no. 200. The soilsample has a liquid limit = 28% and plasticLimit = 18% Cu = 4.2, Cc = 1.4 2. A saturated soil has the followingcharacteristics:Initial Volume = 25 cm3Final Volume = 16 cm3Mass of wet soil = 45 gMass of dry soil = 31 ga) Determine the Shrinkage Limitb) Determine the Shrinkage Ratioc) Determine the Specific Gravity of the soil

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS