Imagine that you are performing an experiment pertaining to organic chemistry. Second, follow the procedures given. Lastly, answer the question given below. Question: What can you conclude? in 5-8 sentences OBJECTIVES - Demonstrate the process of salting out. MATERIALS Distilled water (Absolute, green cover) Sodium Chloride (NaCl, Salt) Isopropyl Alcohol (C3H8O) Medium-sized beads Funnel Plastic Bottle

Imagine that you are performing an experiment pertaining to organic chemistry. Second, follow the procedures given. Lastly, answer the question given below. Question: What can you conclude? in 5-8 sentences OBJECTIVES - Demonstrate the process of salting out. MATERIALS Distilled water (Absolute, green cover) Sodium Chloride (NaCl, Salt) Isopropyl Alcohol (C3H8O) Medium-sized beads Funnel Plastic Bottle

Basic Clinical Laboratory Techniques 6E

6th Edition

ISBN:9781133893943

Author:ESTRIDGE

Publisher:ESTRIDGE

Chapter1: The Clinical Laboratory

Section1.8: Laboratory Math And Reagent Preparation

Problem 15RQ

See similar textbooks

Similar questions

Why Purified synthetic alcohol is preferred for level vial?
Procedure:1. Prepare 5 test tubes. Place 1 ml of 1% starch and add 10 drops of saliva toeach tube. Mix thoroughly.2. Place the first tube in ice water, the 2ndtube leave at room temperature, the 3rdtube in 40°C , the 4thtube at 60°Cwater bath and the 5thtube boil for 2minutes..3. Leave the 4 tubes in their respective temperatures for 30 minutes. The 4thtubeallows to stand for 30 minutes after heating for 2 minutes.4. Test the contents of each tube with iodine and benedict’s tests.
Give 3 uses of calculations of concentrations of solutions to the medical settting.
When conducting a flame test for sodium iodide, is the result positive or negative?
Test solution Indicator thatcan be usedInitial colour ofthe solutionFinal colourof thesolution1. Lemon juice Blue litmus Red
In sterilization, which among the supplies, instruments, glassware, etc. under the list of materials can be sterilized using either or both equipment below? List them down under the category: a) For “autoclaving” only, B) For Dry heat oven sterilization ,And C) Can be sterilized with either. Materials: 200-ml Erlenmeyer flask Stove 500-ml Erlenmeyer flask Autoclave 10-mL graduated cylinder Analytical balance 100-ml graduated cylinder pH meter Spatula Stirring rod 100-mL beaker Test tubes Distilled water Petri dish Stirring rod Alcohol lamp Glass dropper
By applying Gravimetry, Titration (Chemical indicator) and Potentiometry lessons which technique should be used in following situations. Explain your answer. In your explanation, state what is the advantage of the technique you chose over other technique and /or the barrier/difficulty of using the technique. Your choice should not be dependent on cost. For chem students- Total Acid content per tablet of a newly developed drug that has yellow coating Target level is 1%.
50 mL of 15 mg/mL NaOH solution from 100 mg/mL NaOH
An injectabie contains 5 mg of active ingredient in each 10-ml ampule. If the dose of the drug or a patient is 150 mg, hoW many milliliters should injected
Using Benedict's Test would the substance (saliva + acid + potato chips) test positive or negative? Using the Iodine Test would the substance (saliva + acid + potato chips) test positive or negative?
Test tube Ascorbic acid stock (20 μg/mL) Citrate buffer Final Concentrations 1 0 μL 1000 μL 0.0 μg/mL 2 125 μL 875 μL 2.5 μg/mL 3 250 μL 750 μL 5.0 μg/mL 4 500 μL 500 μL 10.0 μg/mL 5 750 μL 250 μL 15.0 μg/mL 6 1000 μL 0 μL 20.0 μg/mL 7 1 mL of the fresh orange juice (20x diluted) 8 1 mL of the heated orange juice (20x diluted) 9 1 mL of the pre-citrus urine sample (5x diluted) 10 1 mL of the post-citrus urine sample (5x diluted) Plot a graph in which y-axis represents for absorbance and x-axis represents for concentration From graph, y=mx + c Calculate the vitamin C concentrations of samples by the equation with consideration of dilution factors. 1. StandardCurve Sample (μg) Absorbance (520 nm) 0.0 0.621 2.5…
100 mL of 2.5 X NaOH solution from 50X NaOH solution