Answered: Imagine there was the solution left at…

Imagine there was the solution left at the tip of a TD pipette. Will these affect calculations? Come up with a calculation to explain this.

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 134AP

See similar textbooks

Related questions

Q: A chemist prepared 100 mL of a 335.1 mM solution of manganese chloride by diluting a 9.87 M stock…

A: Given, Stock solution: Molarity of the stock solution (M1) = 9.87 M Volume of the stock solution…

Q: How many microliters of original sample are required to produce a final dilution of 102 in a total…

A: according to Dilution law initial = final M1V1 = M2V2 final dilution = M2 / M1 =10-2 (given)…

Q: 1. Solutions of known % (v/v) is prepared by the use of . a. balance b. volumetric flask c.…

Q: The mass fraction of B in a solution is 0.17. Calculate, in g, the mass of the solution that…

A: We have to calculate the mass of solution.

Q: A student measures the conductivity of three different aqueous solutions of KNO3 using a…

A: C ) #3 has a solute conc. higher than #1

Q: Which of the following pieces of equipment delivers the most accurate volume of solution. A Buret B…

A: We are to discuss which of the given instruments can measure volume of solution most accurately.

Q: Which type of glassware should be used to make this How should the correct amount of solute be…

A: As A,B,C,X do not signify what they represent in the questions. So I'm solving other two parts.

Q: Calculate the molarity of a solution made by diluting 0.052 L of 0.21 M HCI solution to a volume of…

A: The number of moles present in solution before and diluting the solution will be equal. The…

Q: Complete the table below and show the complete and correct solution. a. 105.9g/mol b. 100.9 g/mol…

A: Graham's law:

Q: What volume of 0.193 M sugar solution can be prepared from 48.8 mL of 0.386 M solution? Enter your…

A: Molarity Formula of the solution is - MiVi = MfVf Here - Mi = Initial Molarity of the sugar Solution…

Q: 1. Solutions of known % (v/v) is prepared by the use of ... a. balance b. volumetric flask c.…

A: (1) The %(v/v) can be defined as the solute in litres is present in liquid solvent. The %(v/v)…

Q: What volume of 0.231 M sugar solution can be prepared from 66.9 mL of 0.461 M solution? Enter your…

A: Interpretation - To determine the volume of 0.231M sugar solution can be prepared from 66.9mL of…

Q: You have a 0.2500 M HCl solution and you need to make 1.000 L of 0.1500 M HCl solution. What volume…

A: Given,

Q: What is the molarity of the solution prepared by diluting 27.4 mL of 2.10 M AgNO3 to the final…

A: Molarity is defined as number of moles of solute divide by volume of solution

Q: What is the dilution factor when 100 ul is added to a final volume of 5ml?

A: Since the units of initial volume is given ul instead of µl. Hence I'm assuming it to be µl i.e…

Q: A standard solution contains 500ppm of chloride ions. If a 25 mL sample of this were diluted to 250…

A: Welcome to bartleby !

Q: A 7.0% v/v solution of ethanol in water, would contain 7 mL of ethanol in a total of 100 mL of…

A: In multiple questions we solve only first question according to Bartleby guidelines. Concentration…

Q: a 4.8 g sheet of magnesium was immersed in the Fe (II) sulphate solution. After some time it was…

A: The reaction between Mg and Fe(II) sulfate is: Mg + FeSO4 → MgSO4 + Fe. Mass of Mg = 4.8 g

Q: I have 6 tubes with the contents labeled. How can I make a 20% concentration serial dilution? Please…

A: Serial dilution: A serial dilution is any dilution in which the concentration decreases by the same…

Q: alt A solution was prepared by dissolving 1.058 g of NAOH pellets with 100 mL of distilled water and…

A: Here 1.058 gram of NaOH pellets was dissolved in 100 ml distilled water and then transferred to…

Q: A geochemist measures the concentration of sait dissolved in Lake Parsons and finds a concentration…

Q: Calculate the number of grams of unknown solute (MW = 56.105 g/mol) in 250.0 mL of a 0.169 M…

A: Answer Option A) 2.37 g

Q: A student made 10.0 mL of a 0.750 M solution in the following way. First, the student took some…

Q: You are a work study student in our chemistry department. Amy, your supervisor has just asked you to…

A: Molarity (M) of a solution is defined as the number of moles of solute dissolved per volume of the…

Q: A water sample was tested for iron content, but was diluted prior to obtaining the instrument…

Q: After diluting a 70 mL solution at 2.00 M to a concentration of 1.25 M, what would be the new total…

Q: Use the data below for the concentrated acids and bases. Reagent Concentration %w/w 99.7 29.0 37…

A: we can prepare a diluted solution from concentrated stock solution using dilution law

Q: How many grams of chlorine gas are needed to make 6.00x 10^6 g of a solution that is 1.70ppm…

Q: A laboratory procedure calls for a 0.250 M solution of cobalt (II) chloride. How many grams of…

A: Molarity = moles / volume (in L) Given that , molarity = 0.250 M Volume = 0.500 L

Q: 2.00 grams of Sodium hydroxide was dissolved in water up to 500 mL. Calculate the : Normality of the…

A: Solution -

Q: A volution of Na2004 is added dropwise to a volution that is o.o150 M in Ba²4 and o.0150M in Sr, pue

Q: Calculate the concentration of a solution made by diluting 40.040.0 mL of 4.34.3 M HBrHBr to a final…

A: In this question, we want to determine the Concentration of Diluted Solution of HBr. You can see…

Q: CALCULATED VALUES VOLUMES Calculate the volume of each solution, volume of water and the total…

Q: What volume of 0.236 M sugar solution can be prepared from 62.4 mL of 0.471, in scientific notation

A: The number of volume of 0.236 M sugar solution can be prepared from 62.4 mL of 0.471M has to be…

Q: 1. Zinc metal reacts with aqueous hydrochloric acid to produce zinc(II) chloride and hydrogen gas.…

Q: Which of the following solutions has the lowest electrical conductivity? A) 0.10 M aqueous ammonia…

A: Electrical conductivity of a solution depends on extent of dissociation of solute and also nature of…

Q: A chemist must dilute 73.3 mL of 108. pM aqueous silver(II) oxide (AgO) solution until the…

Q: Water is added to 0.20 L of a 61 MNa solution to make 211 of a diluted NaF solution Express your…

A: Given data is as follows: The volume of NaF solution = 0.20 L The molarity of NaF solution = 6.1 M…

Q: You have a 2.00 M solution of sucrose and need to use it to make 1.0 L of a 0.500 M solution of…

A: Given conditions areOriginal Molarity of the sucrose solution= 2.0MNew molarity of the sucrose…

Q: A 32.5 mL sample of an 5.6 % (m/v) KBr solution is diluted with water so that the final volume is…

Q: Why is softening of water necessary?…

Q: Solutions of hydrogen in palladium may be formed by exposing Pd metal to H2 gas. The concentration…

A: Henry's law basically states that concentration of any gas is directly related to corresponding…

Q: normality of 0.5781 g acid (eq wt = 187.3) in 250.0 mL of solution

Q: 1. What type of dilution is this? 2. Please place the dilution factor under each tube 3. Which is…

A: Since you have posted questions with multiple sub-parts we will solve the first three for you. To…

Q: What volume of 40% w/w HCI (36.5) density 1.198 m/ml must be diluted with water to obtan excatly 250…

A: To get 250 mL of 1.0 F concentration of HCl we need to calculate stock formula concentration of HCl.

Q: What volume of 7.28M phosphoric acid solution should be used to make 0.716L of 3.15M phosphoric acid…

A: Given Molarity (M1) = 7.28 M Molarity (M2) = 3.15 M Volume (V2) = 0.716 L

Q: you dissolve sugar in water and then try to run an electric current through it, what will happen? *…

A: An electrolyte is the substance that breaks up into ions when dissolved in water. A non electrolyte…

Q: A 113 – mL sample of a 1.4 M sucrose solution is diluted to 600 mL . -

A: The given information is as follows: The initial volume of the sucrose solution V1= 113 mL The…

Question

Imagine there was the solution left at the tip of a TD pipette. Will these affect calculations? Come up with a calculation to explain this.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Your lab partner gets out a 100-mL graduated cylinder and a 100-mL beaker to prepare 100.00 mL of 0.1201 M solution from a 1.201 M solution by dilution. What are the two correct pieces of glassware that should be used? Explain.
You are a work study student in our chemistry department. Amy, your supervisor has just asked you to prepare 100ml of 2.50M HClO4 solution for tomorrow's undergraduate experiment. The Stock Solutions cabinet is under the Stockroom Explorer. You will find find a 2.50 liter bottle containing 15M HClO4. Please prepare a flask containing 100ml of a 2.50M solution. To ensure proper credit, please write your calculations in the space given below.
You need to prepare a solution of 0.123M CuSO4 by starting with solid CuSO4·5H2O. You would be able to use a lab scale that measures to the thousandths and any size volumetric flasks, and pipets that you would need.
An unknown sample containing a mixture of NaCl and Na2CO3 was analyzed to determine the % composition of each compound. In the analysis for Na2CO3 (soda ash), the following data were obtained mass of unknown - 0.4436 g conc. of HCl used - 0.25 N initial volume - 0.5 mL final volume - 20.0 mL (MW soda ash) 106.12) 1.) What method was used to determine the concentration of HCl? 2.) What is the net volume of HCl used in the titration? 3.) What is % Na2CO3 in the given sample? NOTE: Round off your answer to a whole number (2 sig fig)
A 32.5 mL sample of an 5.6 % (m/v) KBr solution is diluted with water so that the final volume is 236.5 mL.
Earth’s oceans contain about 1.31 × 109 km3 of water. One tablespoon is equal to 15 cm3. If you could remove 6.02 × 1023 tablespoons of water from Earth’s oceans, would you completely drain them?
A chemist must dilute 21.1mL of 6.81M aqueous calcium bromide CaBr2 solution until the concentration falls to 2.00M. He'll do this by adding distilled water to the solution until it reaches a certain final volume. Calculate this final volume, in milliliters. Round your answer to 3 significant digits.
What volume of 7.28M phosphoric acid solution should be used to make 0.716L of 3.15M phosphoric acid solution? Report your answer in L with the correct number of significant figures.
Concentrated sulfuric acid is 18.0 M. You need to make a 2.0 L of 1.0 M solution from this concentrated acid. What volume of the original acid do you use?
A 12.5 mL portion of a base solution of an element from Group 2A is diluted to 500 mL, and the resulting concentration of this solution is determined to be 0.125 M. What is the normality of the original solution?
A chemist prepared 100 mL of a 335.1 mM solution of manganese chloride by diluting a 9.87 M stock solution. Calculate the volume of the stock solution required in mL, and report your numerical answer to two decimal places.
"How many grams of copper (II) fluoride are needed to make 6.7 L of a 1.2 M solution? Make sure to show your work clearly and to the correct number of significant figures". Please show each step of the solution, thank you in advance!