In a deposit of normally consolidated clay Lütfen birini seçin: O A. effective stress and water content increases with depth but undrained strength decrease with depth O B. effective stress and undrained strength increase with depth but water content decreases with depth O C. effective stress increases with depth but water content of soil and undrained strength decrease with depth O D. effective stress, water content and undrained strength decrease with depth

In a deposit of normally consolidated clay Lütfen birini seçin: O A. effective stress and water content increases with depth but undrained strength decrease with depth O B. effective stress and undrained strength increase with depth but water content decreases with depth O C. effective stress increases with depth but water content of soil and undrained strength decrease with depth O D. effective stress, water content and undrained strength decrease with depth

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter10: Shear Strength Of Soil

Section: Chapter Questions

Problem 10.20P

See similar textbooks

Similar questions

A sample of dry sand is tested in direct shear. Theshear box holding the sample has a circular crosssection with a diameter of 50 mm. The normal(compressive) load imposed is 200 N. The sam-ple shears when the shear force is 130 N.(a) Determine the test normal stress and shearstress at failure.(b) Determine the angle of internal frictionfor this soil.(c) What is the probable condition of the testedsample (dense, loose, etc.)?
A clay formation having a depth of 4 m. underlies a sand formation having a depth of 3 m. The dry unit weight of sand is 16.5 kN/m3 and the saturated unit weights of clay and sand are 20.4 kN/m3 and 19.6 kN/m3 respectively. The groundwater table is at the interface of the sand and clay. Compute the effective stress at the bottom of clay. Use 3 decimal places in MPa.
There is an upward flow of 0.06 ml/s through a sand sample with a coefficient of permeability 3 × 10^–2 mm/s. The thickness of the sample is 150 mm and the cross-sectional area is 4500 mm2.Determine the effective stress in N/m2 at the bottom the sample, if the saturated unit weight of the sample, is 18.9 kN/m3. Provide Diagram a.709.5 b.177.38 c.88.69 d.354.75
The shear strength of a normally consolidated clay can be given by theequation (tau)f=(sigma prime)tan(21). The results of a consolidated-undrained test on theclay areChamber confining pressure 5 225 kN/m2Deviator stress at failure 5 112 kN/m2Determine:a. The consolidated-undrained (total stress) friction angleb. Pore water pressure developed in the specimen at failure
For a normally consolidated insensitive clay ∅_CD = 30°. Deviator stress at failure of the same soil is 250 kN/m2 in CU test. If Skempton’s A-parameter at failure is 0.62, find out the confining pressure during the consolidation state. a. 260 b. 270 c. 280 d. 250
Answer any one asap 1.A triaxial test is performed on a normally consolidated clay. The sample is further consolidated by the test of all-around confining pressure prior to the application of the axial load. The axial force is applied very slowly. The equipment pore pressure lines remain open so that drainage of the soil pore water can occur during the test. The sample fails when minor principal stress is 49 kPa and the major principal stress is 91 kPa. Determine the angle of internal friction with no decimal places. 2.A dry sand sample was tested in direct shear and yielded a shear strength of 132 kPa under a normal stress of 215 kPa. Lab results indicate the soil's wet unit weight is 18.1 kN/m3 and the saturated unit weight is 20.2 kN/m3. Determine the shear strength, in kPa, within the native sand deposit at a depth of 2.5 m below the water table. The water table is 3 m below ground surface. Provide your answer with 2 decimal places, do not include the units and assume a unit…
A normally consolidated clay layer, 4m thick, has the following properties:Initial void ration, eo = 0.65Compression Index, Cc = 0.20Average effective pressure, σ’o = 100 kPaExpected pressure increase due to loading on ground surface = 30 kPaSecondary compression index, Cα = 0.02Time for completion of primary settlement = 1.5 yearsWhat is the total settlement of the clay layer five years after the completion of primary consolidation settlement?
A dilatometer test (DMT) was conducted in a clay deposit. The water table was located at a depth of 3 mbelow theground surface. At 8 m depth the contact pressure (p1) was 280 kPa and the expansion stress (p2) was 350 kPa.Assume σo = 95 kPa at the 8 m depth and μ = 0.35. Determine (a) Coefficient of at-rest earth pressure Ko,(b) Overconsolidation ratio OCR and (c) Modulus of elasticity Es.
A consolidated-undrained test on a normally consolidate clay yield the following results: Confining Pressure = 151 KPa; Deviator Stress = 187 KPa; Pore Pressure = 71 KPa. Calculate the consolidated undrained friction angle. Please answer this asap. For upvote. Thank you very much
There is an upward flow of 0.06 ml/s through a sand sample with a coefficient of permeability 3 × 10^–2 mm/s. The thickness of the sample is 150 mm and the cross-sectional area is 4500 mm2.Determine the effective stress in N/m2 at the middle of the sample, if the saturated unit weight of the sample, is 18.9 kN/m3. a. 177.38 b. 354.75 c. 88.69 d. 709.5
Refer to Figure P3.3. Vane shear tests were conducted in theclay layer. The vane (tapered) dimensions were 63.5 mm(d) 3 127 mm (h), iB 5 iT 5 458 (see Figure 3.23). For the test at A, the torque required to cause failure was 51 N ? m.For the clay, given: liquid limit 5 46 and plastic limit 5 21.Estimate the undrainedcohesion of the clay for use in thedesign by usingBjerrum’s l relationship
24.A series of consolidated, undrained triaxial tests were carried out on specimens of asaturated clay under no backpressure. The test data at failure are summarized:Confiningpressure (kPa) Deviator stress(kPa) Pore waterpressure (kPa) 150 192 80300 341 154450 504 222 a. Draw the Mohr circles and find the cohesion and friction angles in terms of effectivestresses.b. Compute Skempton’s A- parameter at failure for all three specimens.c. Is the soil normally consolidated or over consolidated? Why?d. Another specimen of the same day that was consolidated under a cell pressure of 250 kPa wassubjected to a consolidated, drained tri axial test. What would be the deviator stress at failure?