Question

In a Ragone plot, which technology has the greatest specific energy

  •  
    A. Super-Capacitors
  •  
    B. Ni-Cd batteries
  •  
    C. lead acid batteries
  •  
    D. Li-ion batteries

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Other

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: A potential difference V(t) = V0sin ωt ismaintained across a parallel-plate capacitor withcapacitanc...

A: Given Vt=V0sinωt a) Calculating Ires(t) Ires(t)=V(t)RIres(t)=V0sinωtR    

Q: How can I find the solutions for this problem? (answers are given) Answers: a.i. Eth = 4 V, Rth = 3....

A: Click to see the answer

Q: The emitter current is always (a) greater than the base current (b) less than the collector current ...

A: The relation between emitter, collector and base current of a BJT is given as IE=IC+IB Where, IE is ...

Q: In the circuit given below, R = 4 Ω. Calculate v1 and v2.    The value of v1 in the circuit is _____...

A: Click to see the answer

Q: For the circuit given in Figure 3, determine which light bulb(s) will glow brightly, and which light...

A: Consider the current through I, is in the circuit. The resistance of all the bulb is equal so the cu...

Q: 1. What difference you notice when you connect (i) 47 µF, (ii) 470 µF and (iii) 4700 µF capacitors a...

A: Use of capacitors in rectifier: The capacitor acts as a rectifier at the output load resistors of re...

Q: Find out the transfer function

A: The given block diagram is:

Q: An ammeter has a PMMC instrument with a coil resistance of R = 99 N and FSD current of 0.1 mA. Shunt...

A: Given values are - Im=0.1mARm=99OhmRSh=1Ohm

Q: Graphs of current against voltage for two resistors P and Q are shown in Figure 4. Determine the val...

A: To determine the value of resistors from the graph  This is tha graph drawn between current and volt...

Q: Kindly answer all parts.

A: Click to see the answer

Q: This question from Measurements instrumentation course.

A: Non linearity is used to represent the behavior or certain device and element. Non linearity occurs ...

Q: please help, Design a common source (CS) amplifier to have a voltage gain of -25V/V when the drain c...

A: Click to see the answer

Q: A 100-volt shunt motor is developing 6 hp while operating at an over-all efficiency of 86%. The arma...

A: Given, A 100-volt shunt motor having, Output power, Pop=6 hp= 6×745.5=4473 watt Efficiency, η= 86%=0...

Q: Sketch the root locus of the unity feedback system 120 Y(s) R(s) (s+2)(s+ 17) Position K

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9...

A: As  current through long time indicates that time "t" tends to infinity

Q: In a welding process, a current of 400 A flows through the arc when the voltage is 35 V. The length ...

A: Click to see the answer

Q: Discuss power equation of synchronous motor.

A: Click to see the answer

Q: Draw the circuit of serial in serial out and parallel in parallel out shift register using gates if ...

A: Click to see the answer

Q: This question from MATLAB COURSE. Demonstrate by using several values ​​of angles x that: sin^2 (x)...

A: Matlab code:   %Q%display all the values for which the expression results to 1 fprintf(“\n\n- - - -\...

Q: If 50 Hz input ac signal is applied at the input of a full wave rectifier, then what will be the out...

A: Given information: The frequency of the input ac signal is fin=50 Hz

Q: Draw a WIRING DIAGRAM for wiring Two Way - One Gang Switches (S1 and S2) to control Fluorescent Lamp...

A: The wiring diagram of the given circuit having two switches (two way one gang type), fluorescent lam...

Q: An atomic spectrum contains a line with a wavelengthcentered at 488 nm. Careful measurements show th...

A: Given data: An atomic spectrum contains a line with a wavelengthcentered at 488 nm. The expression f...

Q: What is the largest time delay that can be achieved using Timer0 and a pre-scaler? Assuming the micr...

A: Timer 0 has the capacity of 8-bit and counting capacity of 0-255 and Pre-scalar has the capacity of ...

Q: A certain population of bacteria doubles in 2yrs. If in 3yrs there are 59,377 of bacteria present, h...

A: Given, a certain population of bacteria doubles in every 2 years. And, in 3 years the bacteria popul...

Q: In the circuit given below, R = 130 kΩ. Find the voltage v0.  The value of v0 in the circuit is ____...

A: Click to see the answer

Q: Radium decomposes at a rate proportional to the amount present. If half of the original amount disap...

A: Click to see the answer

Q: The emitter current is always (a) greater than the base current (b) less than the collector current ...

A: Click to see the answer

Q: 50 KVA, 34.5 kV/380V of y/y-connected, three- phase transformer internal parameters R1= (16/10) 0/ph...

A: Click to see the answer

Q: In the circuit given below, R = 30 Ω. Calculate the mesh currents i1 and i2.  The value of i1 in the...

A: Click to see the answer

Q: Consider the circuit shown in Figure 1. Vcc= +12 V (DC), R1 = 100KΩ, R2 = 10 KΩ, RE = 1KΩ and RL = 2...

A: To find all the circuit parameters given the circuit can be modified as From the figure we have 

Q: A three-phase, two-pole, 60-Hz induction motor is observed to be operating at a speed of 3502 r/min ...

A: Given values are - Pin=15.7kWI=22.6AStator resistanceRs=0.2OhmP=2f=60HzNr=3502

Q: In Selection of bonding conductor, size of the conductor mainly depends on size of

A: Bonding conductor: It is the conductor that ensures required electrical conductivity.

Q: What will be the output of the following circuit? (Assume 0.3v drop across the diode) 1BH62 V1 12 V

A: Given data, The value of voltage is V1 = 12 V. The value of diode voltage is VD = 0.3 V. Apply KVL...

Q: Determine the currents I1, I2 and Iz for the electrical network shown in the following figure:

A: Write KVL in both loops,   50-5I1-20I3=0         .....130+20I3+10I2=0      ......2                  ...

Q: 4.12 Use the mesh-current method to find the power dissipated in the 1 N resistor in the cir- cuit s...

A: Click to see the answer

Q: Consider the generalized block diagram of an PLL. For any two stages of the block diagram ,consider ...

A: Click to see the answer

Q: L:26) A permanent magnet that is infinitely long in the direction perpendicular to its height t, is ...

A: Click to see the answer

Q: F (A, B, C, D) = Σ (4, 5, 10, 11, 12, 13)Draw using a minimum number of NMOS and PMOS.

A: Click to see the answer

Q: Draw a root locus diagram for the following system. Compute the values for any breakaway ints, depar...

A: Click to see the answer