In a well-insulated fixed-volume closed vessel, there is initially 5 kg of saturated liquid-vapor mixture water at 100 kPa pressure. In this state, one quarter of the total mass is in the vapor phase. Then the container The electric heater inside is working and a current of 8 A is supplied from the heater plugged into a 110 V outlet. How long will it take to evaporate all the liquid in the container? Draw in the T-v diagram. ww w ww m wm ww wwwww w www ww

In a well-insulated fixed-volume closed vessel, there is initially 5 kg of saturated liquid-vapor mixture water at 100 kPa pressure. In this state, one quarter of the total mass is in the vapor phase. Then the container The electric heater inside is working and a current of 8 A is supplied from the heater plugged into a 110 V outlet. How long will it take to evaporate all the liquid in the container? Draw in the T-v diagram. ww w ww m wm ww wwwww w www ww

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An 80-L vessel contains 4 kg of refrigerant-134a at a pressure of 160 kPa. Determine(a) the temperature, (b) the quality, (c) the enthalpy of the refrigerant, and (d) thevolume occupied by the vapor phase.
a rigid tank contains 2kg of saturated liquid-vapor mixture of water at 250kPa. Initially, three-quarters of the mass is in the liquid phase. an electric resistor placed in the tank is connected to a 110 volt source and a current of 9 amp flows through the resistor when the switch is turned on. Assuming an adiabetic process, determine how long it will take to vaporize (saturated vapor) all the liquid in the tank.
There is 2 kg liquid-vapor at 400 kPa pressure in a rigid container with a volume of 0.4 m3. What is the dryness degree of the liquid-steam mixture?
A rigid tank contains 2kg of saturated water vapor mixture at temperature of 50 degrees C and quality of 70%. Electrical heating is used to convert this to superheated steam at 1.2MPa and 250 degrees C. If the heat transer from the tank during this process is 500kJ, what is the required electrical energy? What happens if the process continues ti 10 minutes, what is the required electrical power?
Ten pounds of water at 35oF, and 6.00 lb of steam at 250oF and 20 psia are mixed together in a container of fixed volume. What is the final temperature of the mixture? How much steam condense? Assume that the volume of the vessel is constant with a value equal to the volume of the steam and that the vessel is insulated.
For a liquid-vapour mixture, which of the following can give us all the properties of the mixture?
Carbon dioxide gas enters a throttling valve at 5 MPaand 100°C and leaves at 100 kPa. Determine the temperaturechange during this process if CO2 is assumed to be (a) anideal gas and (b) a real gas.
Ten pounds of water at 35oF, and 6.00 lb of steam at 250oF and 20 psia are mixed together in a container of fixed volume. What is the final temperature of the mixture?
Not Ai generated, please show all steps The volumetric analysis of a mixture of gases is 30 percent oxygen, 40 percent nitrogen, 10 percent carbon diox-ide, and 20 percent methane. This mixture flows through a 1-in-diameter pipe at 1500 psia and 70°F with a velocity of 10 ft/s. Determine the volumetric and mass flow rates of this mixture (a) treating it as an ideal-gas mixture, (b) using a compressibility factor based on Amagat's law of additive volumes, and (c) using Kay's pseudocritical pressure and temperature.
A steam boiler of volume 2.3 m3 initially contained 1.7 m3 liquid water in equilibrium with 0.6 m3 of vapour at 100 kPa. The boiler is heated keeping the inlet and discharge valves closed. The relief valve is set to lift when the pressure in the boiler reaches 5500 kPa. Determine the amount of heat supplied to the contents in the boiler before the relief valve lifts.
Water vapour at 100 kPa and 150 is contained in a rigid vessel. At what temperature will the vapour stat to condense when the container is cooled slowly? How much heat will have to be removed per kilogram in this cooling process? Ans:95.68C, -81.4kj/kg
1. Saturated steam at a pressure of 25 psia is sprayed into a stream of moist air. The initial condition of the air is 55 dry-bulb temperature and 35 F de-point temperature. The mass rate of air flow is 2000 lb per min. Barometric pressure is 14.696 psia. Determine how much steam must be added in lb per min to produce a saturated air condition, b) the resulting temperature of the saturated air.