In an LC oscillating circuit, and if we know the values of the inductance and the capacitance then the reciprocal of the square root of their product gives the a. square of the frequency o b. square of the angular frequency O c. frequency o d. angular frequency

In an LC oscillating circuit, and if we know the values of the inductance and the capacitance then the reciprocal of the square root of their product gives the a. square of the frequency o b. square of the angular frequency O c. frequency o d. angular frequency

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 71CP: Shown below are two circuits that act as crude high-pass filters. The input voltage to the circuits...

See similar textbooks

Related questions

Q: A series RLC circuit has a 200 kHz resonance frequency. What is the resonance frequency if the…

Q: Figure 4 shows LC circuit with inductance, L = 19.8 mH and capacitance, C = 19.6 mF. At certain…

A: L = 19.8 mH C = 19.6 mF UB = UE = 17.5 mJ

Q: Q2) Determine the , , (rms), of a half-wave rectifier circuit connected to 1 KQ. 1:1 230 V iD :1 K

A: Solution to the given question is :-

Q: nductor, a capacitor and a resistor are all connected in series across an ac source. If the…

A: Capacitive reactance Xc =1/wC Inductive reactance XL = wL

Q: Determine, Z, of the circuit. Determine the rms current in the circuit. What is the voltage drop…

Q: Problem 4: An AC power supply is connected to a capacitor of capacitance 1.5 μF. At time 0 the power…

A: a)Current through the capacitor is,

Q: Radios often utilize a variable capacitor in series with an inductor to tune the circuit to a…

A: Radios often utilize a variable capacitor in series with an inductor to tune the circuit to a…

Q: For the circuit shown below, what are (a) the total impedance, (b) the phase angle between the…

A: Given that--- delta V = (170V) sin 120 pi t L = 25 mH C = 400 microF R = 5 ohm Question ❓ The…

Q: PI EXPlain The effect of increasing The filter Capacitance on The outPut Voltage in The half - wave…

A: To explain: The effect of increasing the filter Capacitance on the output voltage in half wave…

Q: Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from…

A: Given data The primary winding voltage is Vp = 220 V. The secondary winding voltage is Vs = 12 kV.…

Q: A Step-Down Transformer. A transformer connected to a 120-V (rms) ac line is to supply 12.0 V (rms)…

Q: AC circuit

Q: Radios use resonance in order to tune-in to a particular station. A physics student builds a simple…

A: Given that the value of capacitance and resistor and frequency and RMS value of current then we have…

Q: Obtain the resonant frequency ca, of a series LCR circuit with L = 2.0 H C = 32 micro F and R = 10…

A: Given that - Inductance Capacitance Resistance To Find - We have to determine the Q value of the…

Q: An inductor is one of important device in electrical circuits. To study response of it in pure form,…

Q: [ maximum, split, fast, directly, minimum, slip, slow, inversely ] 17. At resonance the rms current…

Q: A transformer that supplies a full wave rectifier delivers 120 V rms on each side of the secondary…

A: The rms value of voltage is equivalent to the dc voltage.

Q: AL-C-R circuit as shown in figure is connected with a source 120 V ms and 50 Hz frequency. 100 Q 50…

Q: In an oscillating LC Circuit the maximum charge on the capacitor is Q. The charge on the capacitor…

Q: Q2) Determine the , , (rms), of a half-wave rectifier circuit connected to 1 KO. 1:1 230 V ip 1 K

Q: A transformer steps-up the 120-V rms AC powerline voltage to 23 KV rms for a TV picture tube. If the…

Q: 1. A 65 Ω resistor, an 8.0 ?F capacitor, and a 35 mH inductor are connected in series in an AC…

Q: 4) An RLC circuit is rormed by R=40 ohms L=300 mH and C = 650 microC and a power source with…

A: Given information: Here, the symbols have their obvious meaning.

Q: LRC Series Circuit. An LRC series circuit investigated in an experiment is composed of a 160.-…

Q: An inductor has a 51.2-A reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Given: The inductance of the instructor is 51.2 Ohm and the frequency of the source is 60 Hz. The…

Q: Q5. A capacitor C is connected in series with a 402 resistor across a supply of frequency 60 Hz. A…

Q: İR, AUR What is Alternating Current? a Imax-- IR AVmax AUR Please continue and explain all symbols.…

A: Given : To explain Alternating current.

Q: An instructor builds a circuit in which an AC power supply with an rms voltage of 240 V is connected…

Q: A Radio Tuning Circuit. The minimum capacitance of a variable capacitor in a radio is 4.18 pF. (a)…

A: (a) Inductance of the coil, when capacitor is set to its minimum capacitance L=14π2f2C=14π21600×103…

Q: 1. A pure capacitor is connected to an AC power supply. In this circuit, the current 2. In a RLC…

Q: An RLC circuit has a capacitance of 0.35 uF. Part A What inductance will produce a resonance…

A: Given Capacitance ,C = 0.35 uF Inductance,L =??? Resistance,R =??? Resonance frequency ,w = 91…

Q: 5. For an LRC-circuit on a typical US outlet that has an inductance of 0.58 H, a current of 5.5 A,…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An output impedance of an audio amplifier has an impedance of 500 Ω and has a mismatch with a…

A: The given values are, Zp=500 ΩZs=8 Ω

Q: 4)A capacitor C-0.65 pF and unknown resistance R are connected in series to an ac power supply of…

Q: 11. A series RLC circuit consists of 100-N resistor, a 10.0-µF capacitor, and a 0.3 H inductor. The…

A: GivenR=100 ΩC=10 μF=10×10-6 FL=0.35 HVrms=120 Vf=60 Hz

Q: AC An AC current passes through a capacitor as shown. How does the phase of the voltage across the…

A: Let the voltage produced by the AC source is given by : V(t) = Vo Sin(ωt) Where Vo is the maximum…

Q: In an RLC circuit a second capacitor is addedin series to the capacitor already present. (a) Does…

A: a. The resonating frequency (f) of LCR circuit is, f=12πLC Here, L is inductance and C denotes the…

Q: An A.C series circuit as shown in the figure has a phase difference between current and the voltage.…

A: Given that there is phase difference between current and voltage in series RC circuit. To determine…

Q: 2) A series RLC cireuit consists of a 150-2 resistor, a 21-µF capacitor and a 460-mH inductor,…

A: Given: Resistance (R) = 150 Ω Capacitance (C) = 21 µF. Inductance (L) = 460 mH. Supply voltage (V) =…

Q: 2. The plot below shows the voltage (solid line) and current (dashed line) in a device that is…

A: Given, Vmax = 30 mV , Imax = 90 mA a) from graph, T = 0.020 s n = 1/T = 50 ω =…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

In an LC oscillating circuit, and if we know
the values of the inductance and the
capacitance then the reciprocal of the
square root of their product gives the
O a. square of the frequency
o b. square of the angular frequency
O c. frequency
o d. angular frequency

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Shown below are two circuits that act as crude high-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+1/2R2C2 and for the inductor circuit, voutvin=LR2+2L2 (b) Show that for high frequencies, voutvin , but for low frequencies, vout0 .
A 1.05-H inductor is connected in series with a variable capacitor in the tuning section of a short wave radio set. What capacitance tunes the circuit to the signal from a transmitter broadcasting at 6.30 MHz?
A circuit is constructed with a DC battery of 15 volts a resistance of 16 Ohms and 1900 micro Henrys.-What's the inductive time constant of the circuit? -What is the maximum current imaximax -How long will the circuit take to get to 1/2 it's maximum current after it is connected?
For the circuit shown below, what are (a) the total impedance, (b) the phase angle between the current and the applied voltage, and (c) the amplitude of the current through the circuit? The total impedance is________Ω. The phase angle is________rad. (Use the positive phase angle to indicate that the voltage leads the current.) The amplitude of the current through the circuit is________A.
Q5: An inductor is one of important device in electrical circuits. To study response of it in pure form,inductor 240 mH is connected to AC source of maximum voltage 280 V, with a frequency of 120 Hz.Predict the rms current passing through the circuit. Can you predict the change in rms current if thefrequency is increased to 5 kHz? Are there any similar properties for a transformer compared withinductor? Is it possible to operate inductor with DC source? Justify your answer.
capacitive circuit a. What will happen to the capacitive reactance if the frequency increases? b.What will happen to the current in a capacitor if the source frequency is doubles? Halved?
To receive AM radio, you want an RLC circuit that can be made to resonate at any frequency between 500 and 1650 kHz. This is accomplished with a fixed 1.00 μH inductor connected to a variable capacitor. What would be the minimum capacitance, in nanofarads, that would be required? Cmin = Part (b) What would be the maximum capacitance, in nanofarads, that would be required? Cmax=
The graph below represents the voltage and current of a series RLC circuit.a) Find Rb) Find the resonance frequency if L = 200 µH
How is alternating current (AC) different from direct current (DC) in the context of power systems, and when would you use one over the other?
I am doing a lab about Analysis of AC circuits and am not sure about this activiy. How do we determine the phase shift and how to know when the voltage lags or leads or in phase with the current can you explain?
Find the waveform for the voltage induced across a 300mH coil if the current through thecoil is as shown in Figure Q1c below.