Answered: In medium transmission line,…

In medium transmission line, capacitance is considered as O a. Lumped parameter O b. Distributed parameter O c. neglected O d. Both lumped and distributed

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.10MCQ: Transmission line conductance is usually neglected in power system studies. True False

See similar textbooks

Related questions

Q: A lossless transmission line having 50 Q characteristic impedance and length N4 is open circuited at…

A: Given Lossless transmission line Characteristic impedance Z0=50 ΩLength l=λ4open circuitedVoltage…

Q: Transmission Line is connected in Nominal-Pi Circuit. Select one: True False

Q: three-phase, 60 Hz transmission line has an inductance of 1.378 mH per Km per phase and a…

A: In this question , we will find phase constant , surge impedance and wavelength of lossless line...…

Q: three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance…

A: In this question we will find phase constant , surge impedance for lossless line...

Q: g) Why the Capacitance effect is neglected in Short Transmission Line.

A: As per the guidelines, we supposed to answer one question at a time so, please ask other question…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function…

A: First calculate the wavelength of the signal by measuring the distance between two peaks.

Q: The magnitude of the [A] parameter of a short transmission line is smaller than that of medium line.…

A: first we will write the expression for A constant for short and medium transmission line to judge…

Q: A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line…

Q: While studying the performance of medium transmission linos, only resistance and of the line are…

A: Given About the performance of the medium transmission line

Q: h) Distinguish between Lumped or Distributed elements in a Transmission Line

A: lumped or distributed elements in a transmission line

Q: Calculate the voltage reflection coefficients at the terminating end of a transmission line with a…

A: Voltage reflection coefficient is determined based on characteristics impedence and load impedence…

Q: :State the primary transmission line constants and talk briefly about them.

A: The explanation is as follows.

Q: The attenuation characteristics of loaded line is similar to that of

A: Band stop filter is constructed using a low pass filter in series with a high pass filter. It allows…

Q: a. There are three different transmission line models available, i.e. L-type, T-type and n- type…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: Express the velocity of wave on a lossless line in terms of c and z0 with proper derivative. C is…

Q: Draw the equivalent circuit of long transmission line and derive the equations of sending end…

A: Types of Transmission line Long Transmission line Medium Transmission line Short Transmission…

Q: Derive an expression for sag in a transmission line of equal height poles

A: Consider the diagram for the transmission line between two supports of of equal height as point A…

Q: The capacitance per unit length and the characteristic impedance of a lossless Transmission line are…

A: It is given that, the capacitance per unit length and the characteristic impedance of a lossless…

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: Based on simple schematic diagram, briefly describes the criteria and characteristic of short and…

Q: A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic…

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: 10/Explain in your own words and your own understanding (avoid plagiarism) why there's Capacitance…

A: Simply capacitor is nothing but two conducting materials separated by small distance, in between…

Q: lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: h) Distinguish between Lumped or Distributed elements in a Transmission Line.

A: Given: Distinguish between lumped or distributed elements in a transmission line.

Q: In which Transmission Line classification is Capacitance negligible in its Equivalent Circuit? A.…

A: Short Transmission Line Only In short transmission line capacitance is negligible because of small…

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: We have to derive formula of sag for equal height poles in a transmission line.

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

Q: sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of…

Q: ii) A 10% voltage drop occurs in 2 km of a uniformly loaded transmission line terminated by its…

Q: A lossless transmission line has Z₁ = 100 £, terminated by an unknown impedance. The termination is…

A: Given, A lossless transmission line has Z0=100 ΩVSWR=5

Q: 7. A transmission line has the following per-unit-length parameters: L = 0.25 uH/m, C= 100 pF/m,…

Q: b) In your own words, define the "skin effect" in transmission lines and discuss how can it be…

A: Skin effect: The non uniform distribution of current through the conductor caused to non uniform…

Q: Show that VSWR for a transmission line will have values between 1 and infinity.

A: Although expression of standing wave ratio ‘S’

Q: An unmodulated carrier is 680 Vp-p. Calculate the %m when its maximum p-p value reaches 650, 850…

Q: A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the…

A: For a transmission line, the following line parameters are present: Since the given transmission…

Q: The voltage regulation of a short transmission line is estimated: O a. Only on Line Inductance O b.…

A: At the point when a transmission line is conveying current, there is a voltage drop in the line…

Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False

A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…

Q: Calculate the Reactance of the Line, Current flowing through the transmission line, Sending end…

Q: For a transmission line: a) Draw the lumped-element circuit model. b) State what each element of the…

Q: 2. a) Draw nominal - T model of Transmission Line. ( b) Write ABCD Parameters of the nominal T model…

Q: For a one port network, explain the effect on the admittance frequency characteristics when it has a…

A: In the question, What is effect of frequency in admittance of path if Element(either indotor Or…

Q: 1. The transmission system has two types; 2. For the extra high voltage transmission. 3. ACSR stands…

Q: a) Draw nominal - T model of Transmission Line. b) Write ABCD Parameters of the nominal T…

Concept explainers

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.

Question

Q. 42

In medium transmission line, capacitance is considered as
O a. Lumped parameter
O b. Distributed parameter
O c. neglected
O d. Both lumped and distributed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Transmission line conductance is usually neglected in power system studies. True False
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
lnAk=lnAk True False
A three-phase power of 460 MW is transmitted to a substation located 500 km from the source of power. With VS=1. per unit, VR=0.9 per unit, =5000 km, Zc=500, and =36.87, determine a nominal voltage level for the lossless transmission line based on Eq. (5.4.29) of the text. Using this result, find the theoretical three-phase maximum power that can be transferred by the lossless transmission line.
The maximum power flow for a lossy line is somewhat less than that for a lossless line. True False
For either single-phase two-wire line or balanced three-phase three-wire line with equal phase spacing D and with conductor radius r, the capacitance (line-to-neutral) in F/m is given by Can=.
Approximately how many physical transmission interconnections are there between the United States and Canada? Across which states and provinces are the interconnections located?
A three-phase overhead transmission line is designed to deliver 190.5 M VA at 220 kV over a distance of 63 km, such that the total transmission line loss is not to exceed 2.5 of the rated line MVA. Given the resistivity of the conductor material to be 2.84108-m, determine the required conductor diameter and the conductor size in circular mils. Neglect power losses due to insulator leakage currents and corona.
Expand 6k=13m=12Dkm.
A 500-kV, 300-km, 6()-Hz, three-phase overhead transmission line, assumed to be lossless, has a series inductance of 0.97 mH/krn per phase and a shunt capacitance of 0.0115F/km. per phase. (a) Determine the phase constant p, the surge impedance Zc, velocity of propagation v, and the wavelength of the line (b) Determine the voltage, current, real and reactive power at the sending end, and the percent voltage regulation of the line if the receiving-end load is 800 MW at 0.8 power factor lagging and at 500 kV.
For a lossless open-circuited line, express the sending-end voltage, V1, in terms of the receiving-end voltage, V2, for the three cases of short-line model, medium-length line model, and long-line model. Is it true that the voltage at the open receiving end of a long line is higher than that at the sending end, for small 1?
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance