In systems wherein liquid flows down an inclined flat plate, gravity force willA.Accelerate the fluid down the plateВ.Decelerate the fluid down the plateC.Have no effect on the velocity of the fluid down the plate since it is countered byother forcesD.Make the fluid adhere to the plateE. None of these.

When any liquid flows down an inclined flat plate then the liquid acts as a solid body and the…

Answered: In systems wherein liquid flows down an…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water leaves a hose at a rate of 3.6-kg per 2.0-s with a speed of 19.3-m/s and is aimed at a toy car at the exact moment the car is hit the water slows down to 4.0-m/s (That is, we ignore any splashing back.) What is the force exerted by the water on the toy car?
If a pump is capable of lifting 5000kg of water through a vertical height of 60m in 15 min, the power of the pump is
The head lost from point 1 to point 2 is 4m. If the specific gravity of mercury is 13.6, determine The velocity at point 1 in m/s and the maximum height the water can reach “hm” if neglecting air friction in m
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?
An office room has a dimensions of 3x4x3 meters. It is desired to ventilate theentire air in 20 minutes. The opening from where the air will escape has dimensionsof 2x2 meters. Find the required velocity of the ventilated air for this purposes?
Include appropriate diagram and sketch. Air flows steadily at low speed through a horizontal nozzle (by definition a device for accelerating a flow), discharging to atmosphere. The area at the nozzle inlet is 0.1m². At the nozzle exit, the area is 0.02m². Determine the gage pressure required at the nozzle inlet to produce an outlet speed of 50 m/s.
2. A pump draws water from a lake delivered to a height of 50 meters above the lake and encounters 15 meters of headloss. Determine the pump power requirement in Kilo-Watts to deliver a constant supply of 500 Liters per second? The correct answer has a margin of 1 from exact answer. Velocity head is neglected.
A jet of freshwater strikes a series of vanes of a turbine at 25° with the direction of motion and leaves it at 150° absolute with the direction of motion. The absolute inlet velocity of the jet is 25 m/s and the vanes move at a velocity of 10 m/s. Ignore friction across the vanes. Calculate:1.1 the vane inlet angle. 1.2 the vane outlet angle. 1.3 the power/kg of water and, 1.4 the hydraulic efficiency.
A jet of freshwater strikes a series of vanes of a turbine at 25 degrees with the direction of motion and leaves it at 150 degrees absolute with the direction of motion. The absolute inlet velocity of the jet is 25 m/s and the vanes move at a velocity of 10 m/s. Ignore friction across the vanes. Calculate: 1.1 the vane Inlet angle 1.2 the vane outlet angle 1.3 the power/kg of water and Hydraulic efficiency
A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open manometer reads a vacuum of 20 cm of mercury. The pipe is 10 cm in diameter and the flow is 35 L/s of water. Find the total energy at the location of the manometer, relative to a datum, through the pump. ( WITH FREE BODY DIAGRAM ) CHOIECES: A.2.56 B.-2.72 m C.12.74 m D.-4.67 m
..Consider a leather belt with the following given: width of 100 mm, thickness of 6.4 mm, velocity of 18.3 m/s. Which of the following is the centrifugal force across the belt? Note that the density of belt is approximately 974 kg/m3Group of answer choices 205 N 309 N 209 N 305 N
A jet of water strikes a stationary curved plate at one end at an angle of 30°. The jet of 75 mm diameter has a velocity of 30 m/s. The jet is deflected at an angle of 160° with respect to the horizontal. Determine the magnitude and direction of the force exerted by the water on the plate. Assume an ideal fluid. (Express Area in m2; Velocity in m/s; Discharge in m3/s and Force in N) The horizontal component of the force acting on the plate is:

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

In systems wherein liquid flows down an inclined flat plate, gravity force will A. Accelerate the fluid down the plate B. Decelerate the fluid down the plate O c. Have no effect on the velocity of the fluid down the plate since it is countered by other forces