Answered: In the case of heating the air with a…

In the case of heating the air with a heating coil, the absolute humidity of the air can either increase, or decrease. does not change. increases. decreases.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter34: Indoor Air Quality

Section: Chapter Questions

Problem 16RQ: The relative humidity in heated homes is generally the _____in the winter season. A. highest B....

See similar textbooks

Related questions

Q: 8 kg/s of R134a is condensed from 700 KPa and 70 °C to saturated liquid at 700 KPa in a water- coole...

A: Given Data Mass flow rate of refrigerant=8 kg/s State 1: 700 kPa,70°C State 2: saturated liquid,700...

Q: What are the Oven's OBJECTIVES/PURPOSE and its UNIT? note: specify the brand

Q: An increase in temperature difference has the largest impact on heat convection. There is no sign...

A: It is required to choose correct option

Q: Discuss a case study where the mechanical hazard caused an accident, determining: - the cause of acc...

A: The incident discussed here is the one in which smoke entered the working space and due to that 2 em...

Q: 2. Carbon dioxide is compressed in a cylinder in an equilibrium process from initial conditions of p...

A: According to guidelines First question will be done for multiple questions posted. Therefore please ...

Q: rom rest. What is the speed of the ball of mass

A: To find Speed of ball m2

Q: The trunk of a tree is towed by two tractors A and B determine the magnitude of the two forces of th...

Q: 1. The mass of packages C, D, and E are 300, 200, and 400 lb, respectively. Ignore the masses of the...

Q: Calculate the modulus of elasticity of the following material if it has a design stress of 250 kPa, ...

Q: Problem No. 3. The compound shaft has the following properties: G in both Segment 1 Segment 1 Outsid...

A: Calculate the inner diameter of the shaft 1. d1=D1-2t1 Here, D1 is the outer diameter of shaft 1, d1...

Q: Water at 60F is flowing through a 3-inch inside diameter smooth horizontal pipe. If the Reynolds num...

Q: Write the two equations of equilibrium, EFx = 0 and EFy = 0. Do not solve. y F 20 450 N 30 40 300 N

Q: A tank contains 21 kg of dry air and 0.3 kg of water vapour at 24°C and 100 kPa total pressure. Dete...

Q: An aluminum strut 2 m long has a rectangular section 20 mm by 50 mm. A bolt through each end secures...

Q: The gage pressure of the air in the tank shown in figure below is measured to be 80 kPa. Determine t...

Q: Please derive the C.O.P of the refrigerator as a function of temperature using the temperature-entro...

Q: bb) Hot air at 60 °C leaving the furnace of a house enters a 12 m long section of a sheet metal duct...

Q: Q5. According to the manufacturer, a Porsche Spyder reaches 0-100 kmph in 3 seconds. A person starts...

Q: 5. It is desired to design a valve spring of I.C. engine for the following details: (a) Spring load ...

A: Spring are elastic members which distort under load and regain their original shape when the load is...

Q: Q 1: Find the Centroid of the Lamina in Fig. 1. (All units are in mm) 85 35 55 115 35 125 Fig. 1 Q 2...

A: Given Shaded Zone To find Centroid Moment of inertia

Q: Air lows past an object and exits as a free jet as shown in the figure. Because of the obstruction, ...

Q: How many turns should a 14 cm long solenoid have if it is to generate a 0.875 mT magnetic field when...

A: following is the solution for the above problem-

Q: If the beam shown in the Fig. has a square cross section, what is their minimum required width (bmin...

Q: Calculate the mechanical advantage of the 30'

A: Given :- To find mechanical adavantage.

Q: Carbon dioxide is compressed in a cylinder in an equilibrium process from initial conditions of p1 =...

A: As per our guidelines we are supposed to solve only one question if multiple questions are asked . K...

Q: When a football of 30 cm diameter fell into a water tank, 10% of its volume found under water. Deter...

Q: In a steam power plant based on Rankine cycle, steam is initially expanded in a high-pressure turbin...

A: From the given data, Work done in high-pressure turbine = WT1 = 400 kJ/kg Work done in low-pressure ...

Q: A centrifugal pump having four stages in parallel delivers 12 kiloLiters per minute of liquid agains...

Q: m k 0.61 0.61 Drive the equation of motion of the above structure using two methods comparing the eq...

Q: Problem No. 2. A 150-mm-wide steel bar with a butt-welded joint, as shown. SET LOAD P NORMAL STRESS ...

A: Given DataP=205kNσn=80MPaτ=40MPaθ=57{taken} C section taken for computing the minimum thickness

Q: The left leg of a U-tube mercury manometer is connected to a pipeline conveying water, the level of ...

Q: A manometer with two tubes are connected to the roof of a car. The first tube points to the front of...

A: Given DataS.G=0.64s=2.7 inces

Q: For the following mechanism, rod AB is pinned to the two disks at point A and point B, and the two d...

Q: A fluid enters the boiler tube of constant inside diameter of 22.6 mm at 70 bar and 65 degC. The sub...

Q: Q1: 1. What's the main purpose of using sensor/transducer unit in mechatronics systems? Your answer ...

A: Answer-1 In Mechatronics systems sensors/transducers are used to sense the required output according...

Q: A column is clam- ped at the bottom and is carrying a vertical load F, at the center of F. F the top...

Q: A force, F = 12 N, making an angle of 82 = 15° to the ramp pulls up a block of mass m = 2 kg. The ra...

A: Given: m =2 kg x = 0.6-0.5 = 0.1 m angle_1 = 30 deg angle_2 = 15 deg k = 10 N/m

Q: Two solid bars support a load P as shown. Bar (1) has a cross-sectional area of A1 = 4250 mm2 and an...

Q: The velocity of a particle traveling along a straight line is v= (312 - 6t) ft/s, where t is in seco...

A: Given: Velocity of the particle→v=312-6t fts We know that→v=dsdt Hence: →dsdt=312-6t→ds=312-6tdt→∫d...

Q: Calculate the maximum load (P) that can be supported by the knuckle joint that shown in the figure b...

Q: Q2/ A power cycle operating between two reservoirs receives energy Qi by heat transfer from hot rese...

Q: A centrifugal pump is designed for 1800 rpm and a head of 55 m. determine the speed if the impeller ...

Q: A vertical rod of length L and diameter dis fixed at its upper end and carries a load Wat its lower ...

A: Write the torsion equation for the rod. TJ=GθL Here, J is the polar moment of inertia, and G is the ...

Q: Consider a room with dimensions as in the sketch. Assuming all emissivities of surfaces are equal to...

A: Please refer next page for the answer.

Q: Why is correct dimensioning of engineering drawings important? Use suitable examples in your explana...

A: To find:- Imprtance of dimensioning in engineering drawing with example.

Q: Q3.Determine the reactions at the supports as shown in figure below. Note: [P = 28 kN [3 marks] 10 K...

Q: Exercise: 1. Design a hydraulic circuit to operate the shear as in part B as well as ensuring that t...

A: A shuttle valve, also known as a double-check valve, allows pressure in a line to be obtained from a...

Q: Figure below shows a single degree of freedom system. The system has a moment of inertia I =37 kg.m2...

Q: 3. A square aluminum bar is to support a load of 40 kN on a length of 3 m. Assuming pinned ends, det...

Q: In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg....

Question

In the case of heating the air with a heating coil, the absolute humidity of the air

can either increase, or decrease.

does not change.

increases.

decreases.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The relative humidity in heated homes is generally the _____in the winter season. A. highest B. lowest
The recommended relative humidity for a home is between A. 500/0 and 70%. B. and 40%. C. and 50%. D. and 60%.
Relative humidity in question 10 is _______%.
As the Airstream is cooled and dehumidified, the relative humidity____ and the absolute humidity___ A. Increases , Increases B. Decreases, Decreases C. Increases, decreases D. Decreases, Increases
If the air temperature is 85°F, what is the water vapor pressure corresponding to a relative humidity of 55 percent and at 55°F with 25 percent relative humidity.
what is the relationship and formula of relative humidity and temperature?
As the Airstream is cooled, the relative humidity _____ and specific volume _____. A. Decreases, decreases B. Increase, decreases C. Decreases, Increases D. Increase, increase
PLEASE SOLVE ANY TWO QUESTIONS. a) Air at 80°F DB and 50% RH is cooled and dehumidified to 50°F and 100% RH. What is the rate of latent heat removed from 1,000 CFM of air? b) If 500 CFM of outside air at 96°F DB and 76°F WB is mixed with 1,500 CFM of return air at 80°F DB and 50% RH, what is the specific humidity of the mixed air stream? c) A room has a sensible cooling load of 32,000 Btu/hr. The room latent load is 12,000 Btu/hr. What sensible heat factor results from these loads? d) Air at 40°F DB enters a furnace with a heating capacity of 50,000 Btu/hr. If the temperature of the air is increased to 90°F, what is the air flow rate supplied to the furnace? e) Find the enthalpy of air whose dry bulb temperature is 76°F with a humidity ratio of 60 grains/lb f) Air at 30°F DB and 80% RH is heated to 75°F DB by passing it over a heating coil (i.e. sensible heating only) What is the wet-bulb temperature of the heated air?
ASHRAE standard 62.2 states that the minimum acceptable rate of airflow into and out of a room is 15cfm (cubic feet per minute). If air is supplied at 68°F with a relative humidity of 45%, how many gallons of water (minimum) must be added to a portable room humidifier before you go to sleep if you would like to maintain the room at 65% humidity for 7 hours?
Consider 2000 ft3 of an air–water vapor mixture at 14.7 lbf/in.2 , 90 F, 70% relative humidity. Calculate the humidity ratio, dew point, mass of air, and mass of vapor.
At a climate station, air pressure is measured as 100 kPa, air temperature as 24°C, and the wet-bulb or dew point temperature as 19°C. Calculate the corresponding relative humidity in percent.
JUST NEED QUESTION 2 NOT 1 1. Air at a dry bulb temperature (dbt) of 40 oC and a relative humidity of 30% is heated to a dbt of 80 oC. Using psychrometric chart to determine: a. The change in moisture content per kg of dry air. b. The change in enthalpy from the initial unheated air to heated air. 2. The previous heated air is then conveyed through a humidifier to raise its relative humidity to 25%. Using psychrometric chart to determine: a. The change in moisture content per kg of dry air. b. The change in enthalpy from the heated air to final humidified air. Hint: the humidifier changes the humidity ratio without changing dry bulb temperature.