In the diagram below, let The interconnector has an impedance of X-Ω/phase be X =0.33 + 0.34j Correct every question to two decimal places : (b) Open circuit bc and determine the following parameters by applying Thevenin’s theorem: 32.Ian (A) and it's angle 33 Vac (V) and it's angle 34.Vab (V) and it's angle

In the diagram below, let The interconnector has an impedance of X-Ω/phase be X =0.33 + 0.34j Correct every question to two decimal places : (b) Open circuit bc and determine the following parameters by applying Thevenin’s theorem: 32.Ian (A) and it's angle 33 Vac (V) and it's angle 34.Vab (V) and it's angle

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.13P: A single-phase overhead transmission line consists of two solid aluminum conductors having a radius...

See similar textbooks

Similar questions

Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
In a three-phase overhead line, the conductors have an overall diameter of 3.0 cm each and are arranged in delta formation. Assuming a critical disruptive voltage of 250 kV between the lines, an air density factor of 0.90 and mo= 0.95, find the minimum spacing between conductors that is allowable. Assume fair weather conditions.
A three-phase 60-Hz transmission line has its conductors arranged in a triangular formationso that two of the distances between conductors are 25 ft. and the third distance is 42 ft.The conductors are ACSR Osprey. Determine the inductance and inductive reactance perphase per mile.
A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power factor the voltage regulation will be zero ?
Note that the given 25 kV L-L voltage appears across the loads (right side of ZL) as denoted by Vab, Vbc, and Vca. Since there is no given voltage angle, you may assign angle zero to one of the line-to-neutral voltages. 1. Without the capacitors, what is the magnitude of the current passing through the line impedance ZL?
In medium transmission line "T" configuration phasor diagram, the line drop phasor due to resistance is in phase with the ............... current phasor.
The affect of the earth plane is to slightly increase the capacitance, and as the line height increases, the effect of earth becomes negligible. True False
A single-phase overhead transmission line consists of two solid aluminum conductors having a radius of 3 cm with a spacing 3.5 m between centers. (a) Determine the total line inductance in mH/m. (b) Given the operating frequency to be 60 Hz, find the total inductive reactance of the line in /km and in/mi. (c) If the spacing is doubled to 7 m, how does the reactance change?
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
How can I compute and get the values of branch currents (Iab, Iac, Ibc, Ibd, Icd and Ica) and the algebraic sum of the potential difference for electrical loops (abca, abdca, acda, abcda and acbda) by using Kirchhoff's voltage and current law (KVL and KCL) equations?
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground