In the figure here, a small, solid, uniform ball is to be shot from point P so that it rolls smoothly along a horizontal path, up along a ramp, and onto a plateau. Then it leaves the plateau horizontally to land on a game board, at a horizontal distance d from the right edge of the plateau. The vertical heights are h, = 5.0 cm and h, = 2.00 cm. With what speed must the ball be shot at point P for it to land at d = 7.5 cm? Ball

In the figure here, a small, solid, uniform ball is to be shot from point P so that it rolls smoothly along a horizontal path, up along a ramp, and onto a plateau. Then it leaves the plateau horizontally to land on a game board, at a horizontal distance d from the right edge of the plateau. The vertical heights are h, = 5.0 cm and h, = 2.00 cm. With what speed must the ball be shot at point P for it to land at d = 7.5 cm? Ball

Name: PRINTER VERSION1 BACKNEXTChapter 11, Problem 014 GoZ Your answer is p
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: PRINTER VERSION1 BACKNEXTChapter 11, Problem 014 GoZ Your answer is partially correct. Try again.In the figure here, a small, solid, uniform ball is to be shot from point P so that it rolls smoothly along a horizontal path, up along a ramp, and onto

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 43P

See similar textbooks

Similar questions

An 8.79cm diameter floppy disk rotates at its fastest at 470 rpm. Part D: What is the angular velocity at the center of the disk? Part E: If the disk took 3.2 sec to spin up to 470 rpm from rest, what was the average angular acceleration? How many revolutions did the disk complete within this time? What is the net displacement? Part F: If you turn off the floppy disk drive and the disk comes to a stop in 6.7 s, what is the average angular acceleration for this period of motion?
3. A ball rolls along the smooth frictionsless track shown in in the figure below with an initial speed of 5.00 m/s. Assume that the ball turns all the corners smoothly with no loss of speed. Calculate to three significant figures despite what the figure shows. (a) What is the ball’s speed as it goes over the top? (b) What is its speed when it reaches the level track on the right side? (c) What is the difference between the final speed and the initial speed?
Part E: What is the angular displacement in degrees of ladybug B during a time interval of 0.7 s? Express your answer in degrees to two significant figures.
Question 1 a) Calculate the linear velocity (in m/s) of the earth’s rotation about its axis if its equatorial radius is 6378 km. b) If ‘N’ is the rotational frequency of an object in revolutions per hour, write the expression for the angular velocity (speed), for this object in revolutions per second in terms of ‘N’. (Express your answer in simplest terms and standard form).
Please help me on the following three questions! (a) What is the magnitude of the tangential acceleration of a bug on the rim of an 11.0-in.-diameter disk if the disk accelerates uniformly from rest to an angular speed of 79.0 rev/min in 4.50 s? ___________________m/s2 (b) One second after the bug starts from rest, what is the magnitude of its centripetal acceleration? ___________________m/s2 (c) One second after the bug starts from rest, what is its total acceleration? (Take the positive direction to be in the direction of motion.) magnitude _____________m/s2 direction ______________ ° from the radially inward direction
A Google search revealed that the disc in a CD player spins at between 200 and 500 revolutions per minute (RPM) depending upon which area of the disc is being read or played. (a) How many radians per second are equivalent to 200 RPM? (b) By pressing and holding the fast-forward button, the CD player could quickly increase its speed from 200 RPM to 448 RPM in just 0.75 seconds. What was the angular acceleration (α) of the CD in units of radians per secondsquared as it sped up from 200 to 448 RPM?
A golfer is attempting to hit a golf ball from a sand trap into a hole that is 3 m away (Figure 1). The hole is on a green that is at an elevation of 0.3 m above the sand trap. If the golfer hits the ball at an angle of θ = 60∘ above the horizontal, (a) what must be the speed v0 of the ball for it to go directly into the hole without rolling along the green? (b) How long is the ball in the air? (c) What is the final speed of the ball just as it enters the hole? (d) At what angle is the ball traveling just before it enters the hole?
Some bacteria are propelled by motors that spin hair-like flagella. A typical bacterial motor turning at a constant angular velocity has a radius of 1.2 x10-8m, and a tangential speed at the rim of 2.5 x10-5 m/s. (a) What is the angular speed (the magnitude of the angular velocity) of this bacterial motor? (b) How long does it take the motor to make one revolution?
[#169] Bobby thumbed a diesel down. How many revolutions does the drive shaft of a truck engine make during its lifetime? Inputs: Let's suppose that the truck travels a million km (1 billion m) at an average speed of 80 km per hour. The engine turns at a rate of 2000 revolutions per minute. Hint: use the 'multiply by 1' technique and be careful: it's not difficult. However, there are several factors involved, so we suggest that you write your answer down formally, showing all units in the working, the way we did in the lesson. Give your answer as a number (not a power of ten). For example, for 40 million, write 40000000. Remember to use the appropriate number of significant figures
1) A discus thrower starts his spin while standing facing the back of the circle. He releases the discus 2 s later after spinning 540° to his left. Assume that he accelerates at a constant rate. a) What was his angular acceleration during the throw? b) How fast was he spinning after the first half-revolution (180°)? c) How fast was he spinning at the time of release of the discus?
A Ferris wheel is programmed to always rotate with a constant angular acceleration of α = 0.100 rad/s2. A gondola (the one painted green in the figure) starts its motion from rest at the top of the wheel. (a) Find the time it would take for the above gondola to be completely horizontal and to the right, as shown in the figure. (b) Calculate the angular velocity at the instant of time in the previous paragraph. (c) If the radius of the wheel is 100 m, calculate the radial and tangential acceleration vectors at the same instant as in the previous sections. Use the unit vectors to express your answer.
A pendulum consists of a small object called a bob hanging from a light cord of fixed length, with the top end of the cord fixed, as represented in Figure CQ7.5. The bob moves without friction, swinging equally high on both sides. It moves from its turning point A through point B and reaches its maximum speed at point C. (a) At what point does the bob have non-zero radial acceleration and zero tangential acceleration? What is the direction of its total acceleration at this point? (b) At what point does the bob have nonzero tangential acceleration and zero radial acceleration? What is the direction of its total acceleration at this point? (c) At what point does the bob have both nonzero tangential and radial acceleration? What is the direction of its total acceleration at this point? Figure CQ7.5