In the parallel capacitor turn-off circuit of Fig. 1.38(a), the battery has a voltage of 68 V, the load resistance is 5 2, and the value of the capacitance just required for turn-off is 11.43 µF. Estimate the turn-off time of the load thyristor. Also, sketch the waveforms of v™h, , ic, and ve with values also noted therein. Ans. 40 µs The auvi tn off aironit fellowina doto:

In the parallel capacitor turn-off circuit of Fig. 1.38(a), the battery has a voltage of 68 V, the load resistance is 5 2, and the value of the capacitance just required for turn-off is 11.43 µF. Estimate the turn-off time of the load thyristor. Also, sketch the waveforms of v™h, , ic, and ve with values also noted therein. Ans. 40 µs The auvi tn off aironit fellowina doto:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Apply each of diodeapproximations and determine:a. Current through D1b. Voltage across D2c. Voltage across R3 GIVEN: R1 = 2 kΩ, R2 = 1.2 kΩ, R3 = 6.8 kΩ E= 10 V D1: Si, rB = 2 Ω, rR = 220 kΩ D2: Si, rB = 5 Ω, rR = 560 kΩ DETERMING FIRST IF IT IS A FORWARD BIASED OR REVERSED BIASED THEN, SOLVE IN FIRST APPROXIMATION, SECOND APPROXIMATION AND THIRD APPROXIMATION SHOW THE CIRCUIT DIAGRAM IN EACH APPROXIMATION
A 1N4733 zener diode has a Zz of 7 ohms. Considering the data of the manufacturer's hona, the Vz = 5.1 V with a test current, Iz, of 49 mA. What is the voltage across the zener terminals when the current is 65 mA? When the current is 25 mA? Include the graph where these values are shown.
Using IC that is approximately equal to IE. Determine the value of R1 in ohms, when VCC=16V, RC=2117 ohms, RE=354 ohms, VC=8 V and R2=4948ohm
The high-voltage power supply for a television's picture tube has an open-circuit voltage of 18 kV and an internal resistance of 1.5 MQ. (a) Find the voltage at the anode of the picture tube when the anode current is 800 µA. (b) What will the anode voltage be if the anode current is increased by 50%? (c) Find the short-circuit current of the power supply
Consider an electrical circuit. The voltage V (volts), current I (amperes), and resistance R (ohms)are related by Ohm’s law, which states V = IR. Suppose that V is increasing at the rate of 2 volt/secwhile I is decreasing at the rate of 14 amp/sec.(a) Find the equation that relates dRdt to dVdt and dIdt .(b) Find the rate at which R is changing when V = 12 volts and I =2 amps. Be sure to include units.Is R increasing or decreasing?
A 23-V, 50 Hz, 1-ph supply is feeding the following loads which are connected across it.(i) A motor load of 4 kW, 0.8 lagging p.f. (ii) A rectifier of 3 kW at 0.6 leading p.f.(ii) A lighter-load of 10 kVA at unity p.f. (iv) A pure capacitive load of 8 kVA Determine te capacitance of the capacitor at (a) pf = 0.92 lagging (b) pf = 0.95 leading (c) pf = unity
A zener shunt regulator employs a zener diode for which VZ = 10.1 V at IZ = 10 mA while rz = 20 Ohm.The available supply voltage (VS) is 15 V, R = 200 Ohm, and the load resistance (RL) = 1.0 k a) Find VZ0. b) Calculate the output voltage (VO) (hint: The derived expression for VO can be used here without proof) c) If RL is changed so that the load current (IL) is increased to 20 mA, what is the value of the output voltage (VO)?
Provide a complete solution 1.) A full-wave rectifier (operating from a 60-Hz supply) drives a capacitor-filter circuit (C = 100 uF), which develops 12 V dc when connected to a 2.5-kiloOhms load. Calculate the output voltage ripple. (answer= 0.12 V rms) 2.)A full-wave rectifier operating from the 60-Hz ac supply produces a 20-V peak rectified voltage. If a 200-uF capacitor is used, calculate the ripple at a load of 120mA
Calculate the total current of a circuit with a 9.5 V voltage source connected in series with a directly biased silicon diode and a series resistor of 440 Ω. Consider the second approximation of the diode where it is considered to be connected to a battery in series. Units of the response in milli amperes. Note: I put the original exercise in Spanish, so that it is better understood. Explain step by step, please.
2. A certain zener diode has a maximum power rating of 300 mW at 40 deg Cand a derating factor of 1.4mW/deg C. Determine the maximum power the zener can dissipate at a temperature of 80 deg C. 3. From the datasheet, a 1N4728A zener diode has a ZZ of 10 0. The datasheet gives VZ = 3.3 V at a test current, IZ, of 76 mA. What is the voltage across the zener terminals when the current is 90 mA? When the current is 45 mA?
Fig. 2 shows a single-phase fully controlled rectifier driving a heating element that has a resistance of 10 Ω. The supply voltage, Vs, is 230 Vac at 50 Hz and αf = 30 degrees. Answer the following: Draw a fully labelled waveform diagram showing the output voltage and current with respect to the Vs and the firing angle, αf. Use the waveform to develop an expression for the average output current and voltage Use this expression to calculate the average output current and voltage. What changes (if any) would be observed in Vo if the source Vs was taken from a transformer with a very high inductance?
A shunt regulator employs a zener diode for which VZ = 10.1 V at IZ = 10 mA while VZ = 10.2 Vat IZ = 20 mA. The available supply voltage (VS) is 15.0 V, R = 300 ohm, and the load resistance(RL) =1.0 kohma) Find VZ0 and rz.b) Calculate the output voltage (VO).c) Determine the line regulation (ΔVO/ΔVS).d) Using the line regulation obtained in (c), determine the values of the output voltage (VO) if thesupply voltage (VS) is increased from 15 V to 15.1 V.