Investigate the volume capacity of a barrel of oil in gallons, cubic feet, and cubic meters. Also, determine the volume capacity of a bushel of agricultural products in cubic inches, cubic feet, and cubic meters. Write a brief memo to your instructor discussing your findings.

Q: Engineering Fundamentals – An Introduction to Engineering 6th Edition – Saeed Moaveni Chapter 9…

A: Given Information:Intake of water in both of the tank = 2 kg/sVolume of each tank = 14 m3Density of…

Q: 4. A cylindrical container has a diameter of 20 in. and a height of 30 in. If it is to be filled…

A: Specfic gravity=density of fluiddensity of waterVolume of cylinder=πD2h4 converting the dimensions…

Q: solve for the density (kg/li) of a certain liquid if it has a relative density of 0.95. 8. compute…

A:

Q: Suppose a liquid has a specific gravity of 6.28. If the measured pressure at the bottom of the tank…

A: Pressure = SGγh

Q: estimate in feet the depth below the surface of a lake at which the pressure is equal to 2.1 times…

A:

Q: Calorimeters are devices that are commonly used to measure the heating value of fuels. For example,…

A: Following is Junkers flow calorimeter: Principle is as follows: Procedure is as follows:

Q: The rate of water flowing in a common household faucet sink is 10 liters per minute. Convert the…

A:

Q: A cylindrical tank for refrigerant has an inside diameter of 14 inches and is16 inches high. What is…

A:

Q: Consider the duct system shown in the accompanying figure. Air flows through two 20 cm by 25 cm…

A:

Q: From a table inside a room with current temperature of 35 degrees Celsius, a left over Fried Chicken…

A:

Q: Calculate what is the size of water tank for 30000 university students?

A:

Q: A block of wood 0.70 m x 0.70 m x h meters in dimension was thrown into the water and it floats with…

A:

Q: A balloon is being filled with water at an instant when the diameter is 50 cm. If the flow rate into…

A:

Q: If the specific gravity of a liquid is 0.80, make calculations for its mass density, specific…

A:

Q: One pipe can fill a pool in 45 minutes, and two pipes can fill the same pool in 20 minutes. How long…

A:

Q: Consider a cylindrical tank (diameter = 8 m and depth = 5 m) that contains water at 15ºC and is…

A:

Q: Liquid is flowing in a pipeline 60 mm in diameter at 9.5 cu. m. per hour. If the density of fluid is…

A:

Q: A tank can be filled by three pipes separately in 20, 30, and 60 minutes respectively. IN how many…

A:

Q: A vessel containing a mixture of 12 liters of wine and 18 liters of water. Another vessel contains 9…

A: Mixture 1 : 12 Litre Wine and 18 Litre water  And  Mixture 2 : 9 litres of wine and 3 litres of…

Q: Absolute pressure = Gauge pressure + Atmospheric pressureA pressure gauge in a refrigerator system…

A: Given: The gauge pressure is 119.6 psi. The atmospheric pressure is 14.7 psi.

Q: If you are planning to study civil engineering, investigate what is meant bydead load, live load,…

A: Dead loads are weights of material, equipment, or components that are relatively constant throughout…

Q: A horizontal cylindrical tank has an inside diameter of 5 ft and an inside length of 18 ft and…

A: Volume =Area ×LArea=π4D2=π452=19.635ft2

Q: Required information Consider Table 2-1 in the textbook, which lists the specific gravities of…

A:

Q: Calculate the volume of material used in making 30 m of 100 mm type M copper tubing.

A: Standard Dimensions of a 100 mm Type M copper tubing : 100 mm nominal length is equal to 4 in…

Q: The fuel gage for a gasoline tank in a car reads proportional to its bottom gage. The tank is 35 cm…

A: Pressure when tank is fully filled with gasoline PG=γgh PG=0.68×9.810.35m=2.34kpaPressure of water…

Q: Calculate the capillary effect of a glass tube with an internal diameter of 6mm immersed in mercury…

A: Given Surface tension of mercury, σ = 0.51 N/m Internal diameter, d = 6mm = 0.006m Specific gravity,…

Q: 4. Given: A cup shown below Find: the height h to which liquid should be poured into the cup so that…

A: Step 1

Q: The storage capacity of a refrigerator is found by using the inside dimensionsof the refrigerator.…

A: Consider the figure,

Q: p is the density in grams per cubic centimeter .cm3 V is the volume of the space the gas occupies in…

A: Given, theoretical equation as C=C0e0.5rtρV From the graph, we know that C=52e0.2t Equating both the…

Q: Determine the minimum volume of concrete block (γ= 150 lb/ft^3) in cubic feet suspended by a cable…

A:

Q: Next time you are putting gasoline in your car, determine the volumetric flow rate of the gasoline…

A: To find:- t

Q: Calculate the volume of material used  in making 30 m of 100 mm type L copper  tubing.

A: Assume the internal diameter of the copper tubing is denoted by Dinner. Assume the external diameter…

Q: Calculate the weight, mass density, specific weight and specific gravity of an unknown liquid if…

A: solutionGiven mass m=550kg volume v=0.42 m3

Q: A tank contains 49 gallons of a solution composed of 85% water and 15% alcohol. A second solution…

A: Let the A(t) be the amount of alcohol in gallons after the time t minutes. A(0)=15 % of 49=7.35…

Q: Considering the information below, if you do 10- minute shower, approximately how many litres of…

A: Given data, Duration of shower = 10 min

Q: A pitcher throws a fast ball that is moving at a speed of 80 mph. The batter hits the ball in the…

A: Given: The initial speed of the ball is 80 mph. The final speed of the ball is 190 mph. The contract…

Q: From the given figure, shown determine the moment at point A. The unit for Force is in pounds(lbs)…

A:

Q: Calculate the volume of material used in making 100 ft. of 4 in. type L copper tubing.

A: From the table of type L copper tubing. For a 4 in nominal size tube. The outside diameter of the…

Q: What is the volume of oil in L?

A:

Q: Determine the number of gallons of paint needed to paint the outside surface of the water-supply…

A: Consider the figure shown below. The value of the perpendicular distance and the length of the…

Q: (2) The fuel gage for a car's gasoline tank reads proportional to the bottom gage pressure. If the…

A:

Q: A tank contains 500 kg of a liquid whose specific gravity is 2. Determine the volume of the liquid…

A:

Q: An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of…

A: The given data is: Diameter of the tank=8 ft Height vertical tank=16 ft  Calculating the area of…

Q: cylindrical tank having a base radius of 500 millimeters and a height of 2500 millimeters is filled…

A:

Q: A full oil tank holds 280 gallons of #2 fuel oil. During 4 months, the amountsof fuel oil used are:…

A: given data amount of oil  filled in a tank =280gallons monthly oil used as 1st month -0 gallon 2nd…

Q: 1.) Calculate the volume of a water cylinder with a total height of 10 meters and whose diameter is…

A: Given data :-Calculating the volume of a cylinder :-Area of Base A=30 cm2Height H=6 cmVolume of…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.