is the head, h in meter over the orifice is required?

Q: At a point in a 15 cm diameter pipe, 2.5m above its discharge end, the pressure is 250 kPa, If the…

A:

Q: Water is flowing through a pipe of 5 cm diameter under a pressure of 29.43 N/cm² (gauge) and with…

A:

Q: Water from a large reservoir is discharged to atmosphere through a 100mm diameter pipe 450m long.…

A:

Q: Water at 5°C is siphoned from a tank, as shown in the figure below. Depth of the lowermost parts of…

A:

Q: P6.32 SAE 30 oil at 20°C flows in the 3-cm-diameter pipe in Fig. P6.32, which slopes at 37°. For the…

A:

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

A:

Q: Pump Patm = 100 kPa D=3 cm Gasoline, SG= 0.68 x-

A: Given data:  Discharge, Q = 65 gallons/min Q=65×6.309×10-5 m3/s Diameter of pipe, d = 3 cm = 0.03 m…

Q: 3. Determine the flow rate of water, in m3/s, at 5 C though the piping system as shown in the…

A:

Q: Q2: What would be the discharge of liquid (u = 1.48x 10-6 m2/sec, s = 0.89) through a smooth pipe of…

A:

Q: 0.04 m diameter (1) 3 m (2) A Q2) Water is siphoned from a tank as shown in figure 2. If viscous…

A: Given: The diameter of pipe, d = 0.04 m The depth of point A, h = 3 m

Q: Water is flowing through a pipe of 100 mm diameter under a pressure of 19.62 N/cm? (gauge) and with…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: A pipe, inside diameter 1.27 cm, water flows through the pipe at a rate of 0.5 liters per second at…

A:

Q: : The pipe flow in Fig. 2 is driven by pressurize eded to provide water flow rate Q =75 m³/h?. T…

A:

Q: Water flows through a venturi as shown in the figure at a flow rate of Q=49.7 L/s. The inlet and…

A: Given:- Water flowing through venturi meter Flow rate (Q) = 49.7 L/s = 0.0497 m3/s Inlet Diameter…

Q: A vertical orifice is 10 cm. square and has an actual flow of 28 Ips with Cy= 0.95, C= 0.62 as shown…

A: The coefficient of discharge can be determined as,

Q: estimate the allowable distance Y if the allowable pressure in the systems is -18kPa (gage). aasume…

A:

Q: QI: Gasoline is being discharged from apipe at point 2 at elevation 66.66 m. point 1 located 965.5m…

A:

Q: Water flows through a Venturi as shown in the figure at a flow rate of 5.4x10 m /s. What is the…

A:

Q: Air at 200°F flows through a pipe with 0.5 inch diameter at a rate of 0.08 Ibm/s. What is the flow…

A: The temperature of the air is T=200°F. The diameter of pipe is D=0.5 in. The flow rate of the air is…

Q: A pipe, diameter 15 cm, leaves a straight pipe with a diameter of 10 cm at point A, and later…

A:

Q: A pumping system is installed at a location where the reading of barometer is Pa=90kPa and the vapor…

A: Given: The atmospheric pressure, Pa = 90 kPa The vapour pressure, Pv = 3.5 kpa The cavitation number…

Q: 2. Corsider a horizontal 120 cm-diameter galvanized-iron pipe simuating the Alaskan pipel ine. The…

A: We have given

Q: 3. In the figure, ideal fluid (water) flow from the infinity large basin through the atmosphere.…

A:

Q: Prob3 Consider a laminar flow that flow rate Q=0.2 ft³/s; v = 6.55 * 10.5 ft²/s. Find pipe diameter…

A: Reynold number for the fluid flowing through the pipe: When the flow occurs in a pipe, the flow is…

Q: estimate the distance X required to obtain a volume flow rate of 7.1 x 10^-3 m^3/s.

A: Given: The flow through pipe, Q = 7.1x10-3 m3/s The diameter of pipe, D = 50 mm = 0.05 m The…

Q: Water flows through a venturi as shown in the figure at a flow rate of Q=57.1 L/s. The inlet and…

A: Given:Q=57.1 L/sD=3 cmd=2.5 cmL1=65 cmL2=53 cm

Q: 02. Gasoline at 20°C is pumped through a smooth 12-cm diameter pipe 10km long, at a flow rate of 75m…

A: From the given data,Energy equation of steady state;The velocity will be equal as pipe dia. is…

Q: estimate the allowable distance Y if the allowable pressure in the systems is -188kPa (gage). aasume…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: 4: Water flow through a pipe at 5L/s as shown in figure. If gage pressure of 12.5kPa, 11.5kPa and…

A: The head loss can be calculated using the Bernoulli's equation which is given below as-…

Q: A 72 mm diameter orifice discharges 0.023 m3/s of liquid under a head of 3 m. The diameter of the…

A: Given data: d=72 mmQ=0.023 m3/sh=3 mdv=64.57 mm Need to determine the coefficient of contraction.

Q: O.S. A vertical orifice is 10 cm. square and has an actual flow of 28 Ips with Cv=0.95, Cv = 0.62 as…

A: Given Data: Actual flow rate, Q=28 Lps

Q: In Lake Geneva (Switzerland), there is a water jet (called the Jet d'Eau) that is discharged 425…

A: Given: diameter of pipe, d =8 inch =0.2032 m take two sections; one at free surface of lake and…

Q: If the two pipes in Fig.  are instead laid in serieswith the same total pressure drop of 3 lbf/in2,…

A: Given data: The pressure drop is, ∆P = 3 lbf/in2. Calculate the flow rate as follows:…

Q: A surge chamber 10m in diameter is situated at the down stream end of a low pressure tunnel 9.8km…

A:

Q: Oil, with p-950 kg/m' and v=2x10* m/s ,flows through a 30-cm-diameter pipe 100 m long with a head…

A:

Q: Water at 20°C flows through the orifice in Fig. ,which is monitored by a mercury manometer. If d = 3…

A: Given Data Area of the pipe, A=πD24=π0.0524 Rate of the discharge, Q=20m3/h  To find out the…

Q: Estimate the flow rate Q at time t = 4s by using: (a) 2-Point Forward Difference (b) 2-Point…

A: Q = dVdt (a) Forward difference: f'(x) = f(x+h) - f(x)h (b) Backward difference: f'(x) = f(x) -…

Q: P.4.10 Oil of viscosity 10 mNs/m? and specific gravity 0.90, flows through 60 m of 100 mm diameter…

A:

Q: A siphon consisting of a 2 cm diameter tube is used to drain kerosene oil from a large open tank.…

A:

Q: Oil, with p = 875 kg/(m^3) and v = 2E-5 (m^2)/s flows through a 250-cm-diameter, 200-m long pipe…

A:

Q: A venturi meter, shown in Fig. designed constriction whose pressure difference is a mea- sure of the…

A: Apply energy equation between points 1 and 2 P1ρg+V122g+Z1=P2ρg+V222g+Z2 By rearranging the terms…

Q: For this siphon the elevations at A, B, C, and D are: 30 m, 32 m, 27 m, and 26 m, respectively. The…

A: Given Data Elevation are : A=30 m,B=32 m,C=27 m,D=26 m Diameter of pipe is : d=25 cm =0.25 m…

Q: 25) A venturimeter having a diameter of 7 cm at throat and 14.4 cm diameter at the enlarged end is…

A:

Q: irstream flows in a converging duct from a cross-sectional area A1=50cm2 to across-sectional area…

A: Given  at inlet A1= 50 cm2 T1= 300 K V1=100 m/sec P1= 300 kPa A2= 40 cm2

Q: external cylindrical mouthpiece of diameter 120 mm is discharging w under a constant head of 6 m. If…

A: Given data : Cd=0.86Cc=0.62Diameter of mouth piece (d)=120 mmHead (h)=6 m

Q: Q2: Find the piezometric head at tank (C), if the discharge in pipe (1) = (65 L/sec). Use (-0.025)…

A:

Q: A smooth pipe (30 cm) diameter and (100m) long has flush entrance and submerged discharge. The…

A: Given               Velocity, v = 3 m/s            Diameter, D = 30 cm                Length, L =…

Q: Oil with a kinematic viscosity of 6 x 104 m2/s flows in a 0.9 m straight pipe at a rate of 0.05 m/s.…

A:

Q: A necked-down section in a pipe flow, called a venturi,develops a low throat pressure that can…

A: Solution: D1=diamter at throat (section 1)D2=diameter of pipe (section2)ρ=density of water The…

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.