It is given as ?1 = ?3 = 50Ω and ?2 = 25Ω in the two-gate Π circuit given in the figure. According to this, a) Find the scattering matrix of the two-port circuit Π. b) Using the scattering matrix in a), determine the properties provided by the two-port circuit

Q: A symmetrical, passive, reciprocal and lossless two-port network has a Z, (real) characteristic…

A:

Q: In AM, if the unmodulated power carrier is 10 kW, and the total power is 15 kW, what is the upper…

A: Given: In AM The unmodulated carrier power, Pc=10 kW Total power, Pt=15 kW Modulation index,…

Q: 3.1 The mean optical power launched into an optical fiber link is 1.5 mW and the fiber has an…

A:

Q: Consider a single shunt resistor of R=100 2 as a two-port with Zo=50 2 characteristic impedance…

A:

Q: 1. The channel is defined as the medium to a signal. a. receive b. generate c. transfer d. non…

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.…

Q: Q1) A microwave 2-port network has the following scattering matrix 0.1 <45° [s] = [0.5 <20° ¹0.5…

A: For the given two port network by using the scattering matrix the loss seen at port 1 when the port…

Q: A standard air-filled rectangular waveguide with dimensions a = 8.636 cm, b = 4.318 cm is fed by a…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: Consider a series RC circuit as shown in below (R =25 Q, C = 1.59 pF). We want to match this load at…

A:

Q: An 8 km optical fiber link without repeater uses multimode graded index fiber, which has a…

A: Given the optical fiber is of 8 km link. The bandwidth is 4000 MHz The 1 km fiber have the bandwidth…

Q: 4. An AM transmitter radiates 15kW. The modulation depth is rated at 80% with a channel capacity of…

A: In this question we will find carrier power , sideband power....

Q: A communication system has a bandwidth of 150 MHz and an SNR (dB) of 35 dB. a. What is the…

A: Communication system- The system which provide the transfer of data or information from one place or…

Q: Design an emitter-stabilized network at Ico equals 1/2 of IcsaT and VCEQ equals 1/2 of Vcc. Use…

A:

Q: 9. Sketch the frequency spectrum by using Bessel function table by use the value of modulation index…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An AM transmitter radiates 20kW. The modulation depth is rated at 75% with a channel capacity of…

A: The given characteristics of the given Amplitude modulation are,  Pt=20 kWm=0.75fm=5 kHzfc=0.8…

Q: nna size is affected by FALSE TRUE

A:

Q: An SSB transmitter with a carrier of 2.3 MHz is modulated by an intelligence signal in the 300-Hz to…

A: Given for an SSB AM modulation system,  fcarrier = 2.3 MHz = 2300kHz, fmin =300 Hz= 0.3kHz, fmax = 4…

Q: Consider an AWGN channel with bandwidth 50 MHz, received signal power 10 mW, and noise density No…

A:

Q: Consider a cellular system with 500 total allocated voice channelfrequencies. Calculate the mean S/I…

A: Cellular System, Total number of voice channel=500 calculate S/I ratio is equal to 4,7,12; N=4,7,12

Q: 3) If a signal to interference ratio of 15 dB is required for satisfactory forward channel…

A:

Q: i) A communications of 20 dB. Determine channel with a bandwidth of 4 MHz has a signal-to-noise…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A channel was designed to transmit information with capacity (3000 kbit/sec) and bandwidth (1 MHz),…

A: Solution 1.Compute the signal power required at this case(in dB): Given that: Channel capacity…

Q: It is given as Z1 = Z3 = 50Ω and Z2 = 25Ω in the two-port Π circuit given in the figure. According…

A: Apply nodal analysis at V1 side I1=((V1-0)/50)+((V1-V2/25) 50I1=V1+2V1-2V2 3V1-2V2=50I1…

Q: Consider a cellular system with operating frequencies around fc = 900 MHz, cells of radius100 m, and…

A: We need to find transmitted power for given system .

Q: Suppose you have a 2.4 GHz W-Fi access point that has an EIRP of 23 dBm 1. Express the EIRP in mw…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: [S)=

A: Power divider circuit

Q: Question 3: Enumerate solutions to decrease propagation delay. Question 4: What are the effects of…

A: 3) Following are the solutions to decrease propagation delay- 1. Minimize no. of transistors through…

Q: Show that minimum spacing for non-coherent orthogonal fsk is double than the minimum spacing for…

A:

Q: Digital MPSK transmissions carried on a 6GHZ terrestrial link require a bandwidth of 24MHZ. The…

A: MPSK (multi pre-shared key) is a WPA2 improvement. IEEE manages the WPA2 certification program,…

Q: 14.10 Assuming that Rayleight scattering is approxi- mately isotropic (uniform in all directions),…

A: Given, that Raylight scattering is generally isotropic and equal in all directions. Let the letter R…

Q: For a transmission medium, SNRD6 is given as 18. If bandwith is selected as 3,67 MHz, which answer…

A:

Q: When a two-port network is terminated by any load, the expression of the input reflection…

A:

Q: The optical power, after propagating through a fiber that is 7 km long is reduced to 30% of its…

A: Consider the given data: The length is given as 7 km The optical power is reduced to 30% of its…

Q: 2. Calculate the channel capacity of a communication system with a channel bandwidth of 1 MHz and…

A:

Q: 4. Consider a communication system with a bit rate requirement of 200Kbps. Assuming a sy a)…

A: As per Barley guideline for more than three subpart only first three are to be answered please…

Q: Wireless communication Determine the minimum C/N ratio for an 8-PSK system when the transmission…

A: The solution is given below

Q: A mobile station (MS) is located 15 km away from a base station (BS) transceiver and uses a vertical…

A:

Q: It is given as Z1 = Z3 = 50Ω and Z2 = 25Ω in the two-port Π circuit given in the figure. According…

A: consider the given question;

Q: n a DSB-LC system, the message signal 1s 15 cos (87*10*t) and the modulation index s 0.8. The…

A: We need to find losses and signal to noise ratio for given system .

Q: Digital MPSK transmissions carried on a 6GHZ terrestrial link require a bandwidth of 24MHZ. The…

A: Digital MPSK transmissions carried on a 6 GHz terrestrial link require a bandwidth of 24  MHz. The…

Q: Suppose two hosts A and B, are separated by 10,000 kilometers and are connected by a direct link of…

A: Answer : Given the distance between 2 hosts A &amp; B=10000 km = 107 m Also propagation speed (s) of…

Q: A system is being designed to use a 30 GHZ link with a 300HZ bandwidth to receive signals from a…

A: According to the question we have to discuss about SNR.

Q: Q5: A directional coupler has the scattering matrix given below. Find the return loss, coupling…

A: The given scattering matrix is shown below:…

Q: How large dish diameter is needed for 80 dB gain at 300 MHz

A: Given data: Gain G=80 dB Frequency f=300 MHz From the frequency, the corresponding wavelength of…

Q: Assume that two hosts are directly connected via a submarine optical fiber cable, which goes from…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: An SSB transmitter with a carrier of 2.3 MHz is modulated by an intelligence signal in the 150-Hz to…

A: Given data, Carrier frequency = 2.3 MHz. Upper frequency = 4.2 KHz. Lower frequency = 150 Hz

Q: a. For a Communications system with capacity of 40000 bps and SNR = 30dB and a lower frequency of…

A:

Q: For a transmission medium, SNRdb is given as 30. If bandwith is selected as 9,06 MHz, which answer…

A:

Q: A satellite uplink link has a RSL(receive signal level) of -100.57 dBW. The receiver has a 15 MHz…

A: First, we will calculate the equivalent noise temperature by the expression of the noise figure that…

Q: For a transmission medium, SNRdb is given as 12. If bandwith is selected as 5,62 MHz, which answer…

A: For a transmission medium, SNRdb is given as 12. If bandwith is selected as 5,62 MHz, which answer…

Q: i) A communication system employs a continuous source. The channel noise is white and Gaussian. The…

A: Given that Bandwidth, W= 10 MHz Signal to noise power ratio, S/N=100 We have to find channel…