Kerosene - Air Benzene 40 cm cm 20 cm 14 cm ст -Water Mercury-

Q: A manometer, shown in the figure is being used to measure the head or pressure drop across a…

A: This question is based on the pascal laws. Pascal law states that the pressure in the horizontal…

Q: A simple mercury manometer connected into a flow line gives reading as shown in the figure. Local…

A:

Q: 3.15 Calculate p, -p, for this inverted U-tube manometer. OIKSG 0.90) 10 in. 60 in. Water 20 in

A:

Q: (b) Water flows from a large tank as shown in Figure Q3. Atmospheric pressure is 101 kPa (absolute)…

A:

Q: U - tube is used to pressure the difference in water channel. p1= 1000 kg/m3. The orange fluid in…

A: Water density = 1000 kg/m3 Orange fluid = 2000 kg/m3 Pressure at point 1 = 111 kpa a = 10 cm h = 15…

Q: 5.103 The minimum pressure on a cylinder moving horizontally in water (T = 10°C) at 5 m/s at a depth…

A:

Q: Q1/ The tank of water in Fig. 1 is (12 cm) wide into the paper. If the tank is accelerated to the…

A:

Q: In the figure given, fluid 2 is carbon tetrachloride and fluid 1 is benzene. If patm = 101.5 kPa,…

A:

Q: B: An open cylindrical tank (1.2m) in diameter and (1.8m) deep is filled with water and rotated…

A:

Q: Example 3 • Calculate the pressure and speed oof water at point B and Cas shown in the figure below?…

A: The Answer is below

Q: EX 4: Derive an expression for the capillary- height change h, as shown, for a fluid of surface…

A: Let Y= surface tension of the liquid θ=Angle of contact between liquid and plates Weight of the…

Q: Two very large open tanks A and F (Fig. ) containthe same liquid. A horizontal pipe BCD, having a…

A: Consider the given diagram: Apply Bernoulli theorem between top of tank A and point D:…

Q: 3.19 Water flows downward along a pipe that is inclined at 30° below the horizontal, as shown.…

A: According to the information we know pressure must be equal and same in a horizontal line so let…

Q: At a certain point in a horizontal pipeline, the water's speed is 2.50 m/s and the gauge pressure is…

A: Given Data  At section 1 V1=2.50 m/s P1=1.80*104 Pa At section 2 V2=? A2=2A1

Q: In Fig., if the oil in region B has SG = 0.8 and theabsolute pressure at point B is 14 psia, what is…

A: Given: The absolute pressure at point B is PB = 14 psi. The specific gravity of oil in region B is…

Q: In compressible fluids, which is not assumed to simplify calculation  a. Steady flow b.…

A: Compressible fluids are the ones which can be compressed whose volume decreases and density…

Q: The fluid in the tank is water. Flow is steady state, incompressible and inviscid. It is known that…

A:

Q: When a clean glass tube with a diameter of 2 mm is immersed in water at 20 ° C, how many mm will the…

A: Capillary effect is the phenomenon by which a liquid rises or falls inside a narrow tube of small…

Q: A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1=…

A:

Q: A Sluice gate is a device that is fitted in a sluice or fluid canal to operate and control the fluid…

A: We need to calculate the hydrostatic force acting on the sluice gate

Q: 8./A plunger is moving through a cylinder at a speed of 6 m/s, as shown in Fig. (1.8). The film of…

A:

Q: For the inverted manometer shown in the figure, all the fluid are at 20 0C.  If PB - PA = 687 kPa,…

A: Answer: The height of water H is 5.0983 m (509.83 cm).

Q: tetrachloride of specific gravity 1.594 under pressure of 103 kN/m² and pipe B contains o of…

A:

Q: Water stands in the open-ends U-tube as shown in figure below. If the entire system is rotated about…

A:

Q: Compute the capillary rise of water between two concentric glass tubes of radius r 1 = 2mm, r 2 = 4…

A:

Q: The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity…

A:

Q: Derive a formula for capillary rise (h) between two concentric glass tubes of radiuses RI and R2,…

A:

Q: Oil (s = 0.80) is the fluid in the pipe shown below and mercury (s = 13.6) is the fluid in the…

A:

Q: Newfound lake, a fresh water lake near Bris has a maximum depth of 60 m, and the mea pressure is 91…

A: given:depth of lake h=60matmospheric pressure p=91kpa

Q: timate the vacuum pressure that should be created by a suction pump in order to lift a ground water…

A: By hydrostatic law P = ρghρ = density = 1000 kg/m^3g = acceleration due to gravity = 9.81 m/s^2h =…

Q: The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity…

A:

Q: Ex, 11 : Calculate the density of paraffin oil, if glass capillary of diameter 0.25 mm dipped in…

A:

Q: Using the figure depicted below, calculate the minimum height h at which cavitation begins to occur.…

A:

Q: A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1=…

A: Given: The velocity of water at the inlet is, v1=5.90 m/s. The diameter of the pipe at the inlet…

Q: In flat areas, water towers are used to supply water to houses. Water is pumped into the tower, and…

A:

Q: If the white fluid is air, the blue fluid is water, the red fluid is oil (S = 0.86), and the green…

A:

Q: At 68 ̊F water has a dynamic viscosity of about 2.11 x 10^-5 lb-s / ft^2, solve the kinematic…

A:

Q: A tank of water 5m deep receives a constant upward acceleration az= 4 m2/sec, determine the gauge…

A: Given: Depth h=5 m, The constant upward acceleration is az= 4 m/s2.

Q: A continuous gravity decanter is used to separate two immiscible liquids, oil (SG = 0.76) and water.…

A: Given information A continuous gravity decanter is used to separate two immiscible liquids. oil (SG…

Q: as shown, and mercury is the manometer fluid. If the deflection Δh is 60 cm and L is 180 cm, what is…

A:

Q: A right circular cone is 100 mm in diameter and 200 mm high and weighs 1.6 N in air. How much force…

A:

Q: What is the vertical component of the force required to hold the reducing elbow (as indicated…

A:

Q: A spherical air bubble rises in water. At a depth of 9 m itsdiameter is 4 mm. What is its diameter…

A: Given data: d1=9 mmd2=4 mmPAtm=101.3 kPa Need to determine the diameter just as it reaches the free…

Q: Assuming specific weight of air to be constant at 12 N/m3, what is the approximate height of Mount…

A: Given Data Specific weight= 12 N/m3 Pb1=654 mm Pb2= 480 mm

Q: While driving around a curve of 200-m radius, an engineer notes that a pendulum in the car hangs at…

A:

Q: A pipe has a cross-sectional area of 16.5cm2 at point A, where the speed of the fluid (water) is 1.2…

A: Given: The cross-sectional area at point A is, AA=16.5 cm2. The speed of the fluid at A is, VA=1.2…

Q: which fluid mechanics principle explained in terms of the law of consevation of energy? a.…

A: Archimedes principal is based on Buoyant force, in which if a body is placed in a fluid will feel a…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.