3.19 Water flows downward along a pipe that is inclined at 30° below the horizontal, as shown. Pressure difference Pa-PB is due partly to gravity and partly to friction. Derive an algebraic expression for the pressure difference. Evaluate the pressure difference if L=5 ft and h=6 in. Water 30° B Mercury -

3.19 Water flows downward along a pipe that is inclined at 30° below the horizontal, as shown. Pressure difference Pa-PB is due partly to gravity and partly to friction. Derive an algebraic expression for the pressure difference. Evaluate the pressure difference if L=5 ft and h=6 in. Water 30° B Mercury -

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The large reservoir in the following figure provides water for the indicated tank with a flow rate of 10 L/s. Check that the machine is installed and a pump or a turbine, and determine its power, if the yield is 75%. Suppose ideal fluid. Data: γH20 = 104N/m3 ; ATubes = 10mc2 ; g = 10m/s2 .
Three types of fluids stack in an open tank as shown in the picture. If the specific gravidties are sg1=1.00, sg2=2.00, sg3=3.00, and h1=1.00 m, h2=1.00 m, h3=1.00 m, calculate the gage pressure at location 4, P4(gage)=_________(kPa)
2. Estimate the vacuum pressure that should be created by a suction pump in order to lift a ground water which is 10m below the level ground. Neglect the effect of pipe friction. Draw the figure or free body diagram, and explain its step by step solution. 3. Supposed that air (std.) has a uniform density of 1.2kg/m^3, estimate how high (meters) above the sea level where there exists a zero pressure. Assume that in the given condition, barometric pressure at sea level is 101.325 kPa. Draw the figure or free body diagram, and explain its step by step solution.
If the rectangular tank full of water in Fig. P3.37 has itsright-hand wall lowered by an amount δ , as shown, waterwill fl ow out as it would over a weir or dam. we deduced that the outfl ow Q would be given byQ = C b g1/2δ3/2where b is the tank width into the paper, g is the accelerationof gravity, and C is a dimensionless constant. Assumethat the water surface is horizontal, not slightly curved as inthe fi gure. Let the initial excess water level be δ o . Derive aformula for the time required to reduce the excess waterlevel to ( a ) δ o /10 and ( b ) zero.
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?
In Fig., gate AB is 5 ft wide into the paper, and stopB will break if the water force on it equals 9200 lbf. Forwhat water depth h is this condition reached?
A cubical block of wood 13 cm on an edge weighing 20 N floats in water (9810 N/ cubic meter). If it is depressed so that its upper face lies in the water surface and is released, find the equation of the motion. Neglect resistance
When 0.23 m³/s of water flows through a 300-mm diameter pipe, the level difference in a U-tube manometer, connected between two points, separated by 120 m, is 280 mm of mercury. What is the friction factor for the pipe?
Q3)A tank 6 m long 3 m wide and 2 deep contains oil to depth of 1.75 m .If it accelerated horizontally at 2.5 m/s2 in the direction of its length. How muchı oil would spill out and the acceleration force.
A storage tank, 26 ft in diameter and 36 ft high, is fi lledwith SAE 30W oil at 20 ° C. ( a ) What is the gage pressure,in lbf/in 2 , at the bottom of the tank? ( b ) How does your resultin ( a ) change if the tank diameter is reduced to 15 ft?( c ) Repeat ( a ) if leakage has caused a layer of 5 ft of waterto rest at the bottom of the (full) tank.
No wrong answer ..When 0.23 m³/s of water flows through a 300-mm diameter pipe, the level difference in a U-tube manometer, connected between two points, separated by 120 m, is 280 mm of mercury. What is the friction factor for the pipe?
Water at 20°C flows through the orifice in Fig. ,which is monitored by a mercury manometer. If d = 3 cm,(a) what is h when the flow rate is 20 m3/h and (b) what isQ in m3/h when h = 58 cm?