leaves the exhaust pipe of a motor car with a pressure of 1.2 bar and a temperature of 4000C. If the exhaust gas specific was 1.6653 m3 per kg, determine the identity of the exhaust gas. please show the formula used and cancellation of units, if possible include illustration also.

Q: A reservoir contains 2.83ft3 of CO2 at 760psia and 66°F. An evacuated tank is filled from the…

A: Given data as per question The volume of the co2 =2.83 ft3 = 0.0792872 m3 converting units into SI…

Q: Question 20 Calorimetry When determining the latent heat of fusion for ice, we added a small handful…

A:

Q: Thermodynamics Specific Heats question: 2.5 kg of nitrogen gas initially at a temperature of 300 K…

A: Given data,

Q: Air at standard sea level condition undergoes the isentropic process until it is three-fourths the…

A: Initial Conditions are that of standard sea level Temperature :  288.15 K = 518.67oR Pressure :…

Q: Water leaves the safety valve of a boiler at a velocity of 100 ft/sec. What is the gauge pressure in…

A:

Q: 1. Identify which of the following are extensive properties and which are intensive properties: (a)…

A: Extensive properties : The properties which are dependent on the mass are called extensive…

Q: 0.29 kg of a certain perfect gas occupies a volume of 0.024 mº at a pressure of 11.5 bar and…

A:

Q: A tank contains 5ft3 of air at a pressure of 350 psi and temperature 212F. If the air is cooled…

A:

Q: You run the same type of experiment with an unknown mass of silver that began at 75.0˚C and had a…

A: Given data: The specific heat of water is

Q: The volume and temperature of a gas at the beginning of expansion are 0.0056m3 and 183°C,…

A:

Q: An object with the weight of 19.62 kN is floating in water, where the specific weight of water is…

A:

Q: A frictionless piston–cylinder device and a rigid tank contain 2 kmol of an ideal gas at the same…

A: Given data: n=2 kmol∆T=10°C Need to determine the amount of extra heat that must be supplied to the…

Q: For the Figure shown, answer the following three questions Oxygen is first at a pressure of 250 kpa…

A: As per given question need answer of 10 just 10 . Distillation columns are part of a. fuel cells b.…

Q: 1. The mean effective pressure of an engine running at 300 rpm is 500 kPa. What is the…

A: Givenpart aP=500kPaN=300rpmd=250mmL=450mmpart bh1=1500kJ/kgV1=150m/sh2=1200kJ/kg

Q: An unknown gas with a mass of 1.5 kg is contained in a bottle of 1.17 m3 at a temperature of 27…

A:

Q: All specific physical quantities are .5 measured relative to the specific volume of the system. O…

A: all specific physical quantities are measured related to ....

Q: 1- A container filled with a sample of an ideal gas at the pressure of 1.5 atm. The gas is…

A: 1)  Given data  Initial pressure (P1) = 1.5 atm Let initial volume be  V final volume = V/4   To…

Q: In an industrial process 0.4 kg of oxygen is compressed according to PVn =C, where n = 1, from 1.01…

A: GIVEN DATA m=0.4kg  P1=1.01bar ,T1=22'C P2=5.5bar WE HAVE TO FIND WORK AND HEAT TRANSFER

Q: A four-cylinder four-stroke petrol engine with the following specifications: - The bore(diameter) =…

A: Petrol engine works on otto cycle. in which chemical energy of petrol is converted into heat energy…

Q: A bottle with a lid contains 0.0083kg of air at 64°C. If the volume of the air inside

A:

Q: 0 ⁰C came into contact with material B with initial temperature of 15 ⁰C. What are the scenario/s…

A: given:TA=800cTB=150c

Q: At 1:00 PM, a thermometer reading 80°F is taken outside where the temperature is constant. At 1:05…

A: Given: At 1:00pm T=80 After t=5mins, T=35 Now after 40 mins T-Ts=15 To find:- Time taken

Q: Thermodynamics. Please show the complete and step by step solution. Steam has a quality of 95% at a…

A:

Q: Moist steam is contained in a sturdy sealed container (mass and volume unknown). If heating…

A: Solution:

Q: Question 3 a. Explain briefly the following thermodynamic processes with regards to their nature and…

A: It is required to explain given thermodynamic process

Q: 1 cubic meter of a perfect gas at constant pressure of 1 bar and temperature of 17°C are compressed…

A:

Q: 21. The temperature of Oxygen is changed from 110°F to 270°F while pressure remains constant…

A:

Q: Determine the value of degree of superheat if steam has 100 Bar pressure and the corresponding…

A: Given data: Steam Pressure P=100 Bar Corresponding to pressure  Saturation Temperature Tsat=311°C…

Q: Exhaust gas leaves the exhaust pipe of a motor car with a pressure of 1.2 bar and a temperature of…

A:

Q: Convert the following units: (a) 1,000 mm water pressure into psi. (b) Heat rate of 2,375 Kcal/KWh…

A:

Q: According to newton’s law of cooling, the rate at which a substance cools in air is directly…

A: Write the given values with the suitable variables. T0=30 °FT1=100 °FT2=75 °Ft1=15 minTi=80 °FTf=35…

Q: A thermodynamics system is defined as a quantity of matter or a region in space chosen for study,…

A:

Q: 1. The pressure in the substance drastically decrease from 354 to 21 POUNDS PER SQUARE INCHES (PSI),…

A: (a) Write the initial and final pressures of a substance.   P1=354 lb/in2P2=21 lb/in2   Write the…

Q: Suppose we have a piece of a candy bar that has an initial mass of 28g.  If we ignite the piece of…

A:

Q: b. 0.01 kg of a certain perfect gas occupies a volume of 0.003 m3 at a pressure of 7 bar and a…

A: As per given question  Mass=0.01 Volume =0.003m3 Pressure =7 bar T=131°C We have to determine the…

Q: A gas contained within a cylinder fitted with a piston is initially at a pressure of 50 bar. The gas…

A: Given:P1=50 barV2V1=5n=2

Q: A vessel of capacity 7.5 m3 contains the mass of 8 kg of Oxygen gas at a pressure of 180000 N/m2 and…

A:

Q: Oxygen (molar mass 32 kg/kmol ) expands reversibly in a cylinder behind a piston at a constant…

A:

Q: When the gas is in the initial state, the volume is 9.00 L, the pressure is 4.00 atm, and the…

A: Given, PA=4atm=405.3KPaVA=9L=9×10-3m3TA=400Km=PAVARTAm=0.032kgPB=2PA=810.6KPaA→B- Constant volume…

Q: Determine the final weight (lb

A:

Q: Helium gas initially has a volume of 50 liters, a pressure of 2 x 10⁵ N/m², and a temperature of 300…

A:

Q: s mass is 150 g. The stu

A: given: In a science lab, students determined how the mass of a cart affects its gravitational…

Q: b) Matter consists of tiny particles that can combine in specific ratios to form substances with…

A: a) it is Gay-Lussac's law (observed phenomenon, can be used for prediction);

Q: For isochroic process, ___________ A. Change in internal energy is equal to change in enthalpy B.…

A: Isochoric process is a thermodynamic process in which the the volume of the system remans constant.

Q: Oxygen (molar mass 32 kg/kmol ) expands reversibly in a cylinder behind a piston at a constant…

A:

Q: A closed vessel contains air at a pressure of 160 kN/m2 gauge and temperature of 30oC. The air is…

A: Given data: P1 =  160 kN/m2T1 = 30 °C = 30 + 273 = 303 KT2 = 60°C =333 K

Electric Heating Unit

An electric heating unit, or an electric unit heater, is designed to warm up spaces and is available in various types suitable for a range of applications. The method of transforming electrical energy to heat energy is called electric heating. An electric heater converts electric currents to heat using an electrical resistor (heating element).