Left graph is column A; Right graph column B. 0.006 012 0.10 O ON 004 0.001 0.02 00 02 04 0.6 1.0 20 40 100 1, em/s , ems a. What is the optimum flow rate for the separation in both columns? b. What is the minimum height that can be achieved in the separation in both columns. c. What is the maximum number of plates that can be achieved in the separation in both columns? d. Which of the two columns has the better overall column efficiency?

Left graph is column A; Right graph column B. 0.006 012 0.10 O ON 004 0.001 0.02 00 02 04 0.6 1.0 20 40 100 1, em/s , ems a. What is the optimum flow rate for the separation in both columns? b. What is the minimum height that can be achieved in the separation in both columns. c. What is the maximum number of plates that can be achieved in the separation in both columns? d. Which of the two columns has the better overall column efficiency?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.23QAP

See similar textbooks

Similar questions

Chemistry Column 25 m length and 0.2 mm I.D. has efficiency is 100,000 theoretical plates; Flow rate is 1 mL/min. Calculate the peak width for component with retention factor 2. Which data acquisition sampling rate should be used for proper quantification of this component? Explain. (For accurate integration peak should have at least
Suppose that the sample size was 3.0 mg, the column dimensions were 1.00 m length 3 4.0 mm diameter, and the flow rate was 7.0 mL/min. What size column and what flow rate should be used to obtain the same quality of separation of 27.0 mg of sample?
How the 2D Thin layer Chromatography separation processes are worked? Please shortly wtite at your own words. Answer should be to the point (5-6 lines maximum).
which of the folowing(s) is/are true ? 1 split ratio in GC is a ratio of sample passed to column to amount of mobile phashe 2 column resolution decreases with increasing column lenght 3 decreasing the tube diameter ,increases the resolution
Retention time is the time taken for the mobile phase to reach the detector. True False
Compare Chromatographic and Spectroscopic methods for pharmaceutical analysis? Please answer at your own easy words. Answer should be to the point.
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
Please help me I am looking forward of a list (3 sources of error and explain it)
Should you increase the diameter or length of the chromatography colum for increasing throughput?
A young researcher was evaluating a standard method for determining the methylmercury content in blue fin tuna using high performance liquid chromatography (HPLC). She determined the standard deviation (?)(s) for the method to be 0.440.44 ppb and assumed that ?s was a good approximation of ?σ . As a test, she used this method to evaluate the methylmercury content in a National Institutes of Standards and Technology (NIST) standard and determined the unknown amount to be within 0.210.21 ppb (?)(μ) of the known mean with 99% probability. How many replicate measurements of the NIST standard did the researcher perform?
An HPLC method was developed for the separation and determination of ibuprofen in blood samples. A 3.00 mL blood sample dissolved in 70.00 mL solvent was prepared and 10.0 mL was injected into the HPLC. Standard ibuprofen solutions were also run.Calculate the ibuprofen present in the 3.00 mL blood sample The following data were obtained. Table po itoo: Ibuprofen concentration, mg/ml0.50 1.0 2.0 3.0 Blood sample Peak area (Right column)5.29.617.419.911.4
Does the amount of radiation (cpm) increase or decrease as the distance between the sorce and the sensor increases? Explain