Look at the arrangement of the capacitors below.A) Find the equivalent capacitance of the arrangement.B) What is the voltage across each capacitor?V₁ =V₂ =V3 =V4=C) What is the magnitude of the charge stored on each capacitor's plates?Q₁ =Q₂ =Q3Q4=AAV₁ = 10 voltsAB6F4 F6 F4 FBNow imagine that a dielectric with dielectric constant k = 5.0000 is placed insidethe upper left capacitor.D) Find the new equivalent capacitance of this arrangement.AVAB10 volts stillAk=5.0000THE6 FB4F4F

Since you have posted a question with a multiple sub parts, we will solve first three sub - parts…

Look at the arrangement of the capacitors below. A) Find the equivalent capacitance of the arrangement. B) What is the voltage across each capacitor? V₁ = V₂ = V3 = V₁ = C) What is the magnitude of the charge stored on each capacitor's plates? Q₁ = Q₂ = Q3 = Q4= 6F 6 F ра B 4 F 4 F AV = 10 volts AB

Look at the arrangement of the capacitors below. A) Find the equivalent capacitance of the arrangement. B) What is the voltage across each capacitor? V₁ = V₂ = V3 = V₁ = C) What is the magnitude of the charge stored on each capacitor's plates? Q₁ = Q₂ = Q3 = Q4= 6F 6 F ра B 4 F 4 F AV = 10 volts AB

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter8: Capacitance

Section: Chapter Questions

Problem 51P: An air-filled capacitor is made from two flat parallel plates 1.0 mm apart. The inside area of each...

See similar textbooks

Similar questions

Find the equivalent capacitance between points a and b in the combination of capacitors shown in Figure P25.13. Figure P25.13
a. If capacitor B in Figure 27.8 has a charge of 0.5 nC, what is the potential difference between its plates and how much potential energy does it store? b. If capacitor A in Figure 27.8 stores the same amount of potential energy found in part (a), what is the magnitude of the excess charge on its plates? What is the potential difference between its plates? Use the capacitance CA found in Concept Exercise 27.2.
Suppose that the capacitance of a variable capacitor can be manually changed from 100 to 800 pF by turning a dial connected to one set of plates by a shaft, from 0 to 180 . With the dial set at 180 (corresponding to C = 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. (a) What is the charge on the capacitor? (b) What is the voltage across the capacitor when the dial is set to 0°?
Two capacitors, C1 = 18.0 F and C2 = 36.0 F, are connected in series, and a 12.0-V battery is connected across the two capacitors. Find (a) the equivalent capacitance and (b) the energy stored in this equivalent capacitance. (c) Find the energy stored in each individual capacitor. (d) Show that the sum of these two energies is the same as the energy found in part (b). (e) Will this equality always be true, or docs it depend on the number of capacitors and their capacitances? (f) If the same capacitors were connected in parallel, what potential difference would be required across them so that the combination stores the same energy as in part (a)? (g) Which capacitor stores more energy in this situation, C1 or C2?
(i) A battery is attached to several different capacitors connected in parallel. Which of the following statements is true? (a) All capacitors have the same charge, and the equivalent capacitance is greater than the capacitance of any of the capacitors in the group, (b) The capacitor with the largest capacitance carries the smallest charge, (c) The potential difference across each capacitor is the same, and the equivalent capacitance is greater than any of the capacitors in the group. (d) The capacitor with the smallest capacitance carries the largest charge. (e) The potential differences across the capacitors are the same only if the capacitances are the same, (ii) The capacitors are reconnected in series, and the combination is again connected to the battery. From the same choices, choose the one that is true.
A pair of capacitors with capacitances CA = 3.70 F and CB = 6.40 F are connected in a network. What is the equivalent capacitance of the pair of capacitors if they are connected a. in parallel and b. in series?
Three capacitors having capacitances 8.4, 8.4, and 4.2 F are connected in series across a 36.0-V potential difference, (a) What is the total energy stored in all three capacitors? (b) The capacitors are disconnected from the potential difference without allowing them to discharge. They are then reconnected in parallel with each other with the positively charged plates connected together. What is the total energy now stored in the capacitors?
The network of capacitors shown below are all uncharged when a 300-V potential is applied between points A and B with the switch S open, (a) What is the Potential difference VE-VD? (b) What is the potential at point E after the switch is closed? (c) How much charge flows through the switch after it is closed?
A capacitor has parallel plates of area 12 cm2 separated by 2.0 mm. The space between the plates is filled with polystyrene, (a) Find the maximum permissible voltage across the capacitor to avoid dielectric breakdown, (b) When the voltage equals the value found in part (a), find the surface charge density on the surface of the dielectric.
Three capacitors having capacitances of 8.40, 8.40, and 4.20F , respectively, are connected in series across a 36.0-V potential difference. (a) What is the charge on the 4.20F capacitor? (b) The capacitors are disconnected from the potential difference without allowing them to discharge. They are then reconnected in parallel with each other with the positively charged plates connected together. What is the voltage across each capacitor in the parallel combination?
Consider the combination of capacitors in Figure P16.42. (a) Find the equivalent single capacitance of the two capacitors in series and redraw the diagram (called diagram 1) with this equivalent capacitance. (b) In diagram 1, find the equivalent capacitance of the three capacitors in parallel and redraw the diagram as a single battery and single capacitor in a loop. (c) Compute the charge on the single equivalent capacitor. (d) Returning to diagram 1, compute the charge on each individual capacitor. Does the sum agree with the value found in part (c)? (e) What is the charge on the 24.0-F capacitor and on the 8.00-F capacitor? Compute the voltage drop across (f) the 24.0-F capacitor and (g) the 8.00-F capacitor. Figure P16.42
An air-filled capacitor is made from two flat parallel plates 1.0 mm apart. The inside area of each plate is 8.0cm2. (a) What is the capacitance of this set of plates? (b) If the region between the plates is filled with a material whose dielectric constant is 6.0, what is the new capacitance?