4. Catenary Cable (Different Level of Support) The uniform cable weighing 11.25 N/m is suspended from points A and B. The force in the cable at B is known to be 375 N. L. B 3m A 1. 19 3m W=11.25 N/m a. Determine the tension at A. 5. Determine the horizental distance between Aand B. C. Determine the length of the cable. 熱樂

4. Catenary Cable (Different Level of Support) The uniform cable weighing 11.25 N/m is suspended from points A and B. The force in the cable at B is known to be 375 N. L. B 3m A 1. 19 3m W=11.25 N/m a. Determine the tension at A. 5. Determine the horizental distance between Aand B. C. Determine the length of the cable. 熱樂

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A man on the wire singing "Man on a Wire" while practicing for his circus show has reached the center of the rope, creating a dip on the center angled at 63.2 degrees. If the mass of the man is 49.55 kg and the tension force that can be handled by the wire is 449.77N, would the wire break? Show the tension caused by the man hanging on the wire.
A spherical balloon 9.5 m in diameter weighs 1250 N. It is filled with helium weighing 1.65 N/m3 . Determine the maximum load (N) the balloon can lift. γair = 12 N/m3
Which of the following is the dimension of surface tension ? M L-1 T-1 M L T-1 M0 L T-1 M L0 T-2
A submarine is traveling at a depth of ‘95’ kilometers in the ocean, where the gagepressure is 840 Kg(f)/cm2 . The density and bulk modulus of elasticity of water at the top surface of the ocean are 1025 kg/m3 and 24000 kg(f)/cm2 respectively. Find the following:(i) What will be the density of water at the depth of 2.0 kilometers?(ii) What will be specific volume and change of volume at that depth?(iii) What is the pressure at the top surface of the submarine? How much will bechanged in pressure if submarine change direction from North to East?
The diameter of ball which is suspended by a rope in atmosphere is 10cm , what is the tension in the rope if the density of ball is 2000kg/m3 10.2 N 13.6 kN 56.4 N 40.5 kN
A force of P = 850 N is applied to the smaller cylinder of a hydraulic jack (Fig.2). The area a of the small piston is 15 cm2 and the area A of the larger piston is 150 cm2. What load W can be lifted on the larger piston if the pistons are at the same level, The mass density ρ of the liquid in the jack is 103 kg /m3.
The figure below represents the working principle of an industrial pressure gauge. The cylinders and tubing are filled with an oil whose density is 0.780 g/cm3. The sections transverse pistons have an area of 40 cm² and 4000 cm² (a) Calculate, in N, the value of the force F to be applied to the smaller piston of the press shown in the figure, required to balance the load F’ of 4400 kgf on the larger plunger. (1 kgf = 9,80665 N) (b) what must be the relationship between F and F’ for h = 0 m?
1. Samer (ms = 75 kg) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on each side of the seat. (You may assume the seat has negligible mass.) A. Determine the tension in each cable due to Samer sitting on the swing seat. B. Given each cable has a diameter of 1 mm and each cable is exactly 5 m long before Samer sits on the seat, determine the length of each cable when Samer is sitting on the seat. (The cables are made of Aluminum for which Y = 70 GN/m°.) show all work in logical, detailed form and box in numerical answers. Include a diagram wherever possible. On any problem where an FBD is appropriate, it must be included for maximum credit. All numerical results should be stated to 3.00 or 4.000 significant figures and in mks units unless otherwise noted.
A hydraulic press has a ram of 30 cm diameter and a plunger of 2cm diameter. it is used for lifting a weight of 30 kN. How much force is required at the plunger? a) 155.5kN b)466.6kN c) 311.1 kN d) 233.3 kN
First image: How to determine the tension in the cable and the normal force on thesmooth inclined surface given that W = 100 lb?Second image: How to determine the tension when (gravity) g = 9.81 m/s2?
2.2 The hydraulic jack, shown in figure 2, is used to bend a pipe.What force (F2) is exerted on the pipe if F1 is 400N and the density of the oil is 910kg/m3 ?
The forces acting on a 1-m length of a dam is shown in the Figure. The upward ground reaction varies uniformly from an intensity of p1 kN/m to p2 kN/m at B. Determine p1, p2, and the horizontal and vertivcal resistance to sliding.