t = 0 202 İL 10V Vc(t) 1/10 F 10 H Problem 1: For the circuit below, please, find: (a) the initial conditions vo(0), and iz(0) and (b) the differential equation for t>0. Note 1: the switch is open at t>0. Note

Q: In the circuit below, if at time t,, the outputs Q and Q were equal to 0 and 1, respectively, what…

A: Answer: Q=1 and Q=0   Explanation: a. It is not a valid option. the value of Q and Q are inverse…

Q: Q2: The closed loop transfer function of a system is given by G(Z) 1 1+ G(Z) Z2 – Z +1 Find the…

A: Closed loop transfer function of a system given.  Find the location of poles  Damping ratio Natural…

Q: 2) The forward path transfer function is given by G(s) expression for unit step response of the…

A:

Q: Show that the transfer function Z(s)/Y(s) of the following mechanical system is given by k,b, s (ms²…

A:

Q: A discrete time system with input u[k] and output y[k] is described by the difference equation y[k]…

A: A discrete-time system with input u[k] and output y[k] is described by the difference equation:…

Q: Find the complete response of the capacitor v(t) for t > 0 for the circuit. Assume the circuit is at…

A: According to the question, we have find the complete response of the capacitor v(t).

Q: The initial value problem y = 2y – y, tE [0,4], y(0) = 3 has analytic solution y(t) : -e- (a) (1).…

A:

Q: 1. Determine if G(s) is stable, marginally stable or unstable. G(s) (S + 1) (S + 1) (S+ 0.1) S-1 s²…

A:

Q: Consider the RLC circuit with R = 16 2, L = 8 H, C = F, and E(1) = 17 cos 2t V. Determine the…

A:

Q: A 0.1 henry inductor, a 4x10^(-3) farad capacitor, a O ohm resistor, and a voltage source having a…

A:

Q: (3) A second-order system T(s) has two complex conjugate poles located at -2 + j2 and no zero,…

A: The solution is given below

Q: 5. For the following LC circuit shown below, at time t = 0, the amount of charge on the left…

A: Part (a): The initial voltage of the left capacitor is given by:

Q: A single loop RLC electrical circuit can be modelled as a second order system in terms of current.…

A:

Q: An LTI system has an impulse response h(t) = e-3 u(t). (a) Write an expression for h(t) * u(1). (b)…

A: LTI system linear time invariant Impulse response is given. Then step. Input output?  Here we are…

Q: Problem 2 t= 0 30Ω (f) 4 A 45 mH Vc , 20Ω 25 V C Assume that the switch has been in its previous…

A:

Q: If the roots of the characteristics equation z=0.53474t0.5543 rad and sampling time%3D0.5sec., the…

A:

Q: (s +3)(s + 4) The response of the system is given by Y(s) S(s + 2)(25 + 1) Find the initial value of…

A: Given, Response of a system Ys=s+3s+4ss+22s+1

Q: 1-determine if the circuit working in the under damped overdamped or critically damped 2- Find i(t)…

A:

Q: 20 N Sin t 0.5 F @ zero initial state; Req'd , i(t), VR(t), VC(t), Plot the response curve

A:

Q: 492 and 1=0 Q1 of 2) The switch has been closed for a long time. It opens at t=0. i) Find i, (0+)…

A: You have asked multiple independent questions Q1 of 2 and Q 1 b. We are authorized to answer one…

Q: What type of response does the circuit below has? F b 10 2 a 1 = 0 i(t) 100 V 5 2 1 H A Underdamped…

A:

Q: s+1,8 For the system with forward path gain G(s) = and feedback gain H(s) = 5, input s²…

A:

Q: An: In the circuit shown, R = 500 N, L = 0.64 H, C = 1 µF, and 1 = -1 A. The initial voltage drop…

A: given data: R=500 ohm L=0.64H c=1uf I=-1A

Q: ! Required information A discrete-time system is described by the difference equation y[n] – 0.85y[n…

A:

Q: Find the charge and current in an RLC circuit with R = 11 ohms, L = 0.11 H and C = 0.13 F, which is…

A: For an RLC circuit with R=11 Ω, L=0.11 H, C=0.13 F, Vt=12 V; initial charge q0=0.05 C, initial…

Q: lectric Circuit Analysis 2020/2021 Dr. Yaseen H. Tahir EW.: a) A parallel RLC circuit contains a…

A:

Q: The circuit shown in Fig. Qhas input x(t) = 3u(t) V where u(t) represents the unit step function.…

A:

Q: The switch in the circuit shown has been closed for a long time. At t = 0, the switch is opened.…

A: Given  RC circuit  Find the final value of Vc

Q: 13.6 The initial charge on the capacitor in the circuit (b) Iab = [20(s + 2.4)]/[s(s + 3)(s + 6)].…

A:

Q: 3. Consider the given circuit where vs(t) = 12[1+u(t)]V. a) Find the initial conditions i(0-) and…

A:

Q: For the circuit shown, 30 Ω 0.5 F 0.25 H el + v 60u(1) V (+ 20 Ω +) 30u(t) V the generalized…

A:

Q: Consider the given circuit where vs(t) = 12[1+u(t)]V. a) Find the initial conditions i(0-) and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 1. Find the energies of r(t) = u(t) – u(t – 2) and y(t) = u(t) – 2u(t – 1) + u(t – 2), for t e R,…

A: Bartleby has policy to solve Only 1st question and incase if it has subparts then solve only first 3…

Q: 13.6 The initial charge on the capacitor in the circuit shown is zero. a) Find the s-domain Thévenin…

A:

Q: Given the second-order system response below, find the following: 1) The rise time. 2) The settling…

A: Given data, Graph is given as,

Q: (a) 2 + 2y0) = r'(0) %3D (b) + 3ry(1) = rx(t) (c) 3y(t)+2=x(1) dy (d) 2+ y'u) = x(1) %3D dt (2)' (e)…

A: According to our policy we can only answer 3 subparts. For further subparts repost the question with…

Q: 8. Find the charge and current in an RLC circuit with R = 11 ohms, L (0.1 -) H and C (0.01 +) F,…

A:

Q: R(s) C(s) G(s) P8.32 K Given G(s)= (s+1)(s+3)(s+6)2 For this system, create a root locus plot. a.…

A: Referring to the given transfer function, there are four poles present and no of zero are 0. Now,…

Q: Make the equation s(s+1)(s+2)+K=0 in the form of 1+KF(s) and explain the drawing of root-locus…

A: Given equation: s(s+1)(s+2)+k=0

Q: 3. Consider the following second-order differential causal system: ÿ(t)+6ÿ(t)+8y(t) = 2x(t), x(t) =…

A: Natural response:The response of a system without any input is called natural responseForced…

Q: EXAMPLE 1. Use differential equation approach to find Vo(t) for t > 0. Plot the response. SW1 6 kQ 9…

A: Transient analysis  Formulas used:

Q: t= 0 120 20 60 V 4Ω V 50µF 1)3 A Assume that the switch has been in its previous position for a very…

A: We know that when inductors and capacitors are connected in a DC circuit for a long time, they act…

Q: 1. A linear, time invariant system has an impulse response h(t) = e"µ(t). Determine (1;1 >0 its…

A: Given functions are – Laplace transform of both functions are –

Q: Nature of the response (Undamped, Underdamped, Overdamped, Critically damped) S+5 G(s) = (s + 10)²

A:

Q: consider a system described by the following differential equation: y®) – 6j – 8ỷ = 3ü – u, Find the…

A: Given: The system differential equation is y...-6y..-8y.=3u..-u. ...(1) Taking Laplace transform on…

Q: 19/ Sketch the root locus for a system has G(s)=K(s+1) / s(s+2)(s+4)^2 b/ Find the location of pole…

A:

Q: A single loop RLC electrical circuit can be modelled as a second order system in terms of current.…

A: As per the guidelines of Bartleby we have to solve first three sub part of the question.  For rest…

Q: f ? = 50Ω, L = 1.5H, what value of C will cause a sourceless series RLC circuit to be a) overdamped…

A: Given that  R=50 ohmL=1.5H (a)condition for a  series RLC circuit to be overdamped is given by…

Q: 10 N 25 N t = 0 40 mH 10 V 50 Q 3. Obtain the expressions for iL(t) and v(t) in the circuit shown…

A: In this question we will find inductor current and voltage across resistance....

Q: In the circuit shown, R = 500 N, L = 0.64 H, C = 1 µF, and I = -1 A. The initial voltage drop across…

A: As per the guidelines, we supposed to answer one three sub parts at a time so please ask other parts…

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).