Micro-hardness profiles were obtained for the tool steel, the weld zone and stainless steel. Figure 2 shows the dents on the (1) tool steel, (2) diffusion zone and (3) stainless steel. The dents on the stainless steel are larger than those on the tool steel. Do you agree or disagree with this statement? Discuss this statement and justify your answer. Base on your understanding, which hardness method used in here ? Figure 2

Micro-hardness profiles were obtained for the tool steel, the weld zone and stainless steel. Figure 2 shows the dents on the (1) tool steel, (2) diffusion zone and (3) stainless steel. The dents on the stainless steel are larger than those on the tool steel. Do you agree or disagree with this statement? Discuss this statement and justify your answer. Base on your understanding, which hardness method used in here ? Figure 2

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

13. Outline (with the aid of any diagrams as appropriate) the principles of protecting metals from the effects of corrosion by electrochemical means. 14. Describe the phenomenon of creep in metals. Referring to the features of a graph of strain versus time, outline the general creep characteristics, 15.For minimising (1) dislocation creep and (ii) diffusion creep, state in each case whether a metal with a small grain size or a large grain size would be the most suitable, giving reasons for your answers.16. Outline (with the aid of any diagrams as appropriate) the use of plasticisers and stabilisers in polymeric materials. 17. By referring to the general characteristics of stress-strain plots of PMMA (perspex), explain how and why viscoelasticity influences fast and slow rates of load application. 18. Explain, with sketched examples, the principles of designing injection-moulded polymer products to minimise sink marks.
The needle form of mullite offering substantial increasing in structural strength and heat resistance? (Provided that the answer is scientific brief)
When is Strain hardening used? How is it performed?
Explain the reason for the quenching cracking that may occur when hardening some parts. Describe the alternative methods applied to prevent this situation by showing them on a single figure.
what is this equation mean? what will the equation show when the material collapse? And would will the way to be prevented?
When making hardness measurements, whether by nanoindentation or by conventional indentation testing, what will be the effect of making an indent very close to a preexisting indent? Why?
Discuss the trend for the hardness number of each metal with different indentation locations and explain what caused this trend.
Note: Answer Should be not so long. Need straight forward Answer. By considering a circular hole in a thin elastic sheet, explain (with the aid of any diagrams as appropriate) how a stress concentration can magnify stress. Also Explain the principles of designing alloys for oxidation resistance.
When does the mean stress level affect fatigue crack propagation rates in metal alloys?
There are differences in the mechanical behavior of resulting material from (1) tempering martensite at 600 degrees centigrade and (2) tempering martensite 300 degrees centigrade, mention two differences and explain why the differences occur in each
(b) For the same bar, if the engineering strains are 0.05 and 0.10 at engineering stresses of 200 and 220 MPa respectively, what would be the work hardening exponent of pure aluminium?
Why is the theoretical strength of materials higher than the observed strength?