Increasing the temperature of this voltaic cell would increase the voltage:a.one which has a ∆G<0b.a concentration cellc.an electrolytic celld.one whose E° is slightly negative

Answered: ncreasing the temperature of this…

Science

Physics

ncreasing the temperature of this voltaic cell would increase the voltage:

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 14CQ: The current I is measured through a sample of an ohmic material as a voltage V is applied, (a) What...

See similar textbooks

Related questions

Q: Earth’s lower atmosphere contains negative and positive ions that are produced by radioactive…

A: a) The expression for the required magnitude of the current density is,

Q: Problem 4: Suppose you have a pocket calculator through which 2.5 C of charge passes in 4.5 h? What…

Q: Problem 1: A cell phone battery uses chemistry to create a charge separation between the terminals…

A: Given: Q = capacity of the battery To be determined: N = Number of free electrons content by the…

Q: An electrolyzer passes electric current through water, dissociating some of the water molecules and…

A: Diameter of tube (d) = 6.85 cmRadius of tube (r) = d2=6.85 cm2= 3.425 cm = 0.03425 m Current (i) =…

Q: A current of 1.5 x 103 A passes through an electrolytic cell for 6 mins. How many moles of electrons…

Q: Suppose you have a pocket calculator through which 2.75 C of charge passes in 3.25 h? What is the…

A: Given information, 2.75 C of charge passes in 3.25 h. The current produced is the rate of flow of…

Q: It is the current that can electrocute a person. Why is it that in a power station we often read…

A: 1. OHM's LAW: V=IR Potential is directly proportional to current for a given resistance. Current:…

Q: :LEE'S DISC Aim: To determine the thermal conductivity of a bad conductor by the Lee's method. What…

A: Concept used: Heat flows from higher to lower temperature.

Q: 24.) Which of the following statements correctly explain why resistance increases with increasing…

Q: 19) Which of the following statement is true? wwm a. Thermal ionization is observable at room…

A: Required : True statement.

Q: How can one use the setup to charge a battery? How does changing the starting amounts of each metal…

A: Rechargeable batteries are the storage batteries which store the chemical energy and convert into…

Q: Electroplating uses electrolysis to coat one metal with another. In a copper-plating bath, copper…

Q: The following graph represents the charge-discharge profile of a Li-ion battery in the 1st and 50th…

Q: What current flows through a 2.54–cm–diameter rod of pure silicon that is 23.0 cm long, when 1150 V…

A: Write the given values of the problem- Length of the rod- L=23 cm L=0.23 m Diameter of the rod (d)…

Q: Q4) Attempt to answer ONE branch only: a) If the electron concentration increase along the x-axis of…

A: We can use the formula, J=eDn(dn(x)/dx)

Q: Question 4. (a) If a battery with a 0.100 1 internal renistance supplies 15.0 W of total power with…

A: The terminal voltage of a battery is ∆V=ε-IR…

Q: Solve the following problems involving the relationship of current, charges, and time from this…

Q: Electroconvulsive therapy is a last-line treatment for certain mental disorders. In this treatment,…

Q: A current of I = 25A is drawn from a 100-V battery for 30 seconds. By how much is the chemical…

Q: 10. An aluminum wire (resistivity at 20°C of 2.65x10-8 2m, temperature coefficient of 0.00429/°C) is…

Q: A tungsten wire is used to determine the melting point of lead. A battery of 6.00 V is attached to…

Q: You have a 1.50 cm diameter sphere that you would like to have plated with chromium metal. How long…

A: Given: The diameter is d=1.50 cm. The thickness is t=50 micron. The current is I=0.75 A. Also, The…

Q: A tungsten wire is used to determine the melting point of indium. The resistance of the tungsten…

Q: block

A: The relation between the heat transfer and the temperature change for a specific material is given…

Q: 3: What is the equivalent resister of the network shown? A: 5 25L 22 В: 2 a С: 3 D: 6

A: Given data: Three resistors are connected in series R1 = 1 Ω, R2 = 2 Ω and R3 = 2 Ω Required: The…

Q: The following table gives the lengths of three copper rods, their diameters, and the potential…

A: Electric Field E=VL

Q: 2. Suppose your phone's battery has a capacity of 2500 mAh and a potential difference of 3.7 V. What…

A: Given that - Potential difference Time Capacity of the phone's battery To Find - We have to…

Q: Which wire has a bigger cross-sectional area? 7. Which wire allows greater current? A. 12-gauge…

A: two available copper wires are :A = 12 gauge copper wire having a length of 1 meterB = 18 gauge…

Q: Q2/Choice the correct answer 1. The energy storage capacity of a cell is determined by the:…

A: 1. The energy storage capacity of a cell is determined by Answer : (c) Amount of material available…

Q: Q6/ A length of copper wire with a cross sectional area of 1 mm2 carries a current of 0.4 A. The…

A: Mobility μ is defined as the magnitude of drift velocity per unit electric field.

Q: Q18 A capacitor is connected to batteries by Nichrome wires and allowed to charge completely. Then…

A: Diagram of the situation.

Q: Calculate the resistance of a resistor that has a voltage (potential difference) of 8V across it…

A: Given that, Voltage = 8 V Current = 2 A

Q: Which of the following statements is TRUE about the element shown? -7 A a. It absorbs 1.4 W of…

A: Given data: Voltage difference (V) = -5 V Current (I) = -7 A

Q: 3. Consider a square aluminum wire with conductivity 3.5 x A V m wire is 2 x 10-2Y, what is the…

Q: Pencil "lead" is actually mostly graphite (Carbon). You need a 4 Ohm resistor but only have 0.7 mm…

Q: geological core sample is taken at a coal mine. The sample is a cylinder 20.7 feet long and 5.25…

Q: er of free electrons by ionizing silicon atoms. The electrons flow to an electrode on the surface of…

A: We know that the formula of the current is given as I = npqmsma…

Q: Q5. Explain Ohm's law for Ohmic materials.

A: Which material obey the Ohm's law, are called ohmic material.

Q: Incandescent light bulbs are filled with an inert gas to lengthen the filament life. With the…

A: The temperature T=20C The pressure =115kPa The temperature rises at 70C To find the pressure at…

Q: Using hand-drawn schematic diagrams, show curves that illustrate the temperature dependence of the…

A: The Graph is giiven below:

Q: The yoltage of 500 mV was applied to the 0.2cm² carbon electrode in the voltammetric setup. The…

A: Since current drops 5 % of its initial value, the final current will be; i=5100i0=0.05i0 Time to…

Q: A Nichrome heater dissipates 504 W when the applied potential difference is 110 V and the wire…

Q: Find and write down your reference to the value of the work function for Sodium, Zinc, Copper,…

A: The work function (or workfunction) is defined as the minimum amount of thermodynamic work (i.e.…

Question

Increasing the temperature of this voltaic cell would increase the voltage:

a.	one which has a ∆G<0
b.	a concentration cell
c.	an electrolytic cell
d.	one whose E° is slightly negative

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The current I is measured through a sample of an ohmic material as a voltage V is applied, (a) What is the current when the voltage is doubled to 2V (assume the change in temperature of the material is negligible)? (b) What is the voltage applied is the current measured is 0.27 (assume the change in temperature of the material is negligible)? What will happen to the current if the material if the voltage remains constant, but the temperature of the material increases significantly?
A close analogy exists between the flow of energy by heat because of a temperature difference (see Section 19.6) and the flow of electric charge because of a potential difference. In a metal, energy dQ and electrical charge dq are both transported by free electrons. Consequently, a good electrical conductor is usually a good thermal conductor as well. Consider a thin conducting slab of thickness dx, area A, and electrical conductivity , with a potential difference dV between opposite faces. (a) Show that the current I = dq/dt is given by the equation on the left: ChargeconductionThermalconductiondqdt=A|dVdx|dQdt=kA|dTdx| In the analogous thermal conduction equation on the right (Eq. 19.17), the rate dQ/dt of energy flow by heat (in SI units of joules per second) is due to a temperature gradient dT/dx in a material of thermal conductivity k. (b) State analogous rules relating the direction of the electric current to the change in potential and relating the direction of energy flow to the change in temperature.
Does a photovoltaic cell obey Ohm’s Law? Explain briefly
30.) An insulator is a material in which electrons are not able to move easily. a. true b. false
12. The thermoelectric voltage relies on the junction and the environment temperatures. o True o False
Incandescent light bulbs are filled with an inert gas to lengthen the filament life. With the current off ( at T = 20C), the gas inside the light bulb has a pressure of 115kPa. When the bulb is burning, the temperature rises to 70C, what is the pressure at the higher temperature?
6. What current flows through a 2.54–cm–diameter rod of pure silicon that is 23.0 cm long, when 1150 V is applied to it? (Such a rod may be used to make nuclear–particle detectors, for example.) This is not and will not be graded
Charging by Conduction , the process (?) How (?) Give a examples
How can one use the setup to charge a battery? How does changing the starting amounts of each metal affect the speed of charging/discharging? Why do commercial rechargeable batteries wear out eventually after recharging many times?
#1: High voltage power lines are not covered with an insulating outer cover. A) What is the reasoning behind not putting on a protective insulating coating? B) Why are small birds not harmed when they land on these exposed high voltage wires?
A new material is found to be superconducting below 77 K. How much resistance will a 75 mm long sample of this material have if it is at a temperature of 69.3 K while connected to a 6.4 V AC-power supply? R = How much thermal energy will it generate?Thermal energy generated =
A tungsten wire is used to determine the melting point of indium. The resistance of the tungsten wire is 2.788 Ω at 20 degrees Celsius and increases to 5.636 Ω as the indium starts to melt. αtungsten= 4.50 x 10-3 (degrees Celsius)-1. What is the melting temperature of indium in degrees Celsius?