olution is: .K. c) 144727.5 J.mol.K A concentration cell is constructed by placing identical Ni electrodes in two Ni²* solutions. If the concentrations of the two Ni2+ solutions are 1.0M and 0.002M, what is the potential of the cell? a) 1.04 Volt b) 0.08 Volt c) 0.50 Volt That is the

olution is: .K. c) 144727.5 J.mol.K A concentration cell is constructed by placing identical Ni electrodes in two Ni²* solutions. If the concentrations of the two Ni2+ solutions are 1.0M and 0.002M, what is the potential of the cell? a) 1.04 Volt b) 0.08 Volt c) 0.50 Volt That is the

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter21: Potentiometry

Section: Chapter Questions

Problem 21.16QAP

See similar textbooks

Related questions

Q: (a) What is salt-bridge? Why is it used? Explain its working principle giving an example. (b) Define…

A: A salt bridge is a laboratory device used to complete circuitry of electrochemical cell by providing…

Q: A solution containing vanadium (chemical symbol V) in an unknown oxidation state was electrolyzed…

Q: Cr2O7 2- (aq) + 14H+ 6e- ---> Cr3+(aq) + 7H2O(l) Ered = 1.33V Cu2+(aq) + 2e- --> Cu(s) ?°red =…

A: For the given cell reaction the reduction potential of the electrodes is as follows: Cr2O7 2- (aq) +…

Q: To 20,0 ml of 0,0500 mol/l solution of iron (III) chloride – 12,50 ml of the solution of stannous…

Q: An electroplating solution is made up of nickel(II) sulfate. How much time in minutes (DON'T INCLUDE…

A: Given, Mass of Nickel (W) = 0.500 g Current (C) = 3.00 A Time (t) = ? minute

Q: Calculate the potential developed by a voltaic cell using the following reaction if all dissolved…

A: Calculate the potential developed by a voltaic cell using the following reaction if all dissolved…

Q: Write the net cell equation for the electrochemical cell. Phases are optional. Do not include the…

Q: Write the net cell equation for this electrochemical cell. Phases are optional. Do not include the…

A: In this electrochemical cell of cobalt metal acts as a anode and silver metal is acts as a cathode.…

Q: A galvanic cell is prepared according to the redox reaction shown below. A voltmeter connected to…

A: The question is based on the concept of electrochemistry. the electrode which has higher reduction…

Q: Consider the voltaic cell H+(aq, ?? M)|H2(g, 1 atm)||Cu(s)|Cu2+(aq. 0.1 M). The measured Ecell for…

A: Given that, the voltaic cell H+(aq, ?? M)|H2(g, 1 atm)||Cu(s)|Cu2+(aq. 0.1 M). So, [Cu2+] = 0.1 M,…

Q: A corrosion cell consists of copper(Cu) as sheet area is 250cm2 and the density of the current…

A: A corrosion cell consist of copper as sheet area 250cm2 and the density of current Passing through…

Q: A voltaic cell is constructed with two hydrogen electrodes. Electrode 1 has PH2=1.00 atm and an…

A: Answer: As the current flows from electrode 1 to electrode 2, we can say that electrode 1 is the…

Q: A voltaic cell is constructed with two Zn+-Zn electrodes. The two cell compartments have [Zn+]= 1.9…

A: The emf of the given concentration cell is approximately 0.063 volt

Q: A cell consisting of a saturated calomel electrode and a lead ion electrode developed a potential of…

Q: A galvanic cell was prepared by immersing an anode and a cathode of the same material (of A type) in…

Q: A voltaic cell is constructed with two Zn2+ - Zn electrodes. The two half-cells have 3Zn2+4 = 1.8 M…

Q: the standard cell potential for a Ag-AgBr cell assuming 298K where the average cell voltage is…

A: The cell potential can be obtained by the following relation: E=E0-RTnFlnProductReactant…

Q: A cell is prepared by dipping a copper rod in 0.01 M CuSO4 solution and zinc rod in 0.02 M of ZnSO4…

A: Given : E°Zn+2/Zn = -0.76 V E°Cu+2/Cu = 0.34 V [CuSO4] = 0.01 M [ZnSO4] = 0.02 M

Q: A solution containing vanadium (chemical symbol V) in an unknown oxidation state was electrolyzed…

Q: A Ag/Fe voltaic cell has an E° of V. If you change the concentration of the solution in each cell to…

A: The observed potential of any specified cell may or may not be identical to its standard potential.…

Q: At 25 ∘C,25 ∘C, a titration of 15.00 mL of a 0.0320 M AgNO3 solution with a 0.0160 M NaI solution is…

Q: The F concentration of a solution was determined by measurements with a liquid-membrane electrode.…

A: Given, The initial potential is = 0.5021 volt Volume of sample is = 25 mL. Final potential is =…

Q: A voltaic cell consists of a standard hydrogen electrode and a second half-cell in which a magnesium…

A: Electrochemical cell : It is a kind of arrangement which produce electrical energy from chemical…

Q: Question attached

A: The SHE (Standard Hydrogen Electrode) is one of the reference electrodes used in the electrochemical…

Q: The moving boundary method was applied to a solution of GdCl3 33.27 mmol/L at 25°C using LiCl. Using…

A: In the moving boundary method, the speed of displacement of the boundary is measured between two…

Q: The free energy change for the following reaction at 25 °C, when [Ni2+] = 1.12 M and [Cd2+] =…

A: The cell potential of the given reaction is calculated using Nernst equation as,

Q: A galvanic cell was constructed with a nickel electrode that was dipped into 1.8 M NISO4 solution…

Q: Write the net cell equation for this electrochemical cell. Phases are optional. Do not include the…

A: Given: The net cell Reaction Cu(s)∣∣Cu2+(aq, 0.0155 M)‖ ‖Ag+(aq, 2.50 M)∣∣Ag(s)…

Q: A galvanic cell using Mg|Mg2+ and Cu|Cu2+ half-cells operates under standard-state conditions at…

Q: The standard reduction potentials are +0.80 V for Ag+ and -0.76 V for electrode is where the Zn2+.…

A: Reduction is a process in which there is gain of electrons and oxidation is a process in which there…

Q: Regarding voltaic/galvanic cells: What process occurs at the cathode in a voltaic cell? a. What…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A galvanic cell is constructed using zinc metal, silver metal, Zn(NO3)2 0.1 M solution, Ag(NO3) 0.3…

A: In this question, we have to find out the correct answer of given problem by the help of the…

Q: A voltaic cell designed to measure (Cu**] is constructed of a standard hydrogen electrode and a…

A: A voltaic cell is an electrochemical cell in which spontaneous redox reaction occur which produces…

Q: A galvanic cell was constructed with a nickel electrode that was dipped into 1.2 M NISO4 solution…

Q: Consider an electrochemical cell based on the following cell diagram ven that the standerd cell emf…

Q: A certain half-reaction has a standard reduction potential Ered=-0.10 V. An engineer proposes using…

A: The EMF of an electrochemical cell is given by: where E˚cathode is the standard reduction potential…

Q: Which electrode will be positive what voltage with a faulty meter show assume it's positive lead is

A: Given:Left half of galvanic cell of M(NO3)2 =4.00 MRight half of galvanic cell of M(NO3)2 =40.0…

Q: Im not sure how to plug in my calculated values to get the theoretical non-standard cell potential…

Q: If the Standard Potential cell for the following AgI/Ag and I/I Was -0.152vand o, suv respectillery.…

Q: Tollowing uld resuit for any CE aised from 25 °C to 100 °C? . The cell potential would not change at…

A: To discuss the Effect of temperature on the cell potential

Q: A concentration cell is constructed based on the half-reaction below (M represents a generic metal).…

A: A concentration cell has E∘ value zero and Ecell can be calculated using Nernst equation.…

Q: The concentration of NO3- in a water sample is determined by a one-point standard addition using a…

Q: A voltaic cell is made by placing an iron electrode in a compartment in which the Fe2+ concentration…

Q: 5. A student-produced a plot of Ecei vs. In[Cu2-] which had an equation of y = -0.0977x + 0.0057.…

Q: A solution containing vanadium (chemical symbol V) in an unknown oxidation state was electrolyzed…

Q: Consider the following voltaic cell: (a) Which electrode is the cathode?(b) What is the standard…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3 sub-parts. Please resubmit the…

Q: The F- concentration of a solution was determined by measurements with a liquid-membrane electrode.…

A: Given information, Electrode system potential when immersed in 25.0 mL of sample = 0.5021 V…

Question

100%

Please explain

olution is:
.K.
c) 144727.5 J.mol.K
A concentration cell is constructed by placing identical Ni electrodes in two Ni²* solutions. If the
concentrations of the two Ni2+ solutions are 1.0M and 0.002M, what is the potential of the cell?
a) 1.04 Volt
b) 0.08 Volt
c) 0.50 Volt
That is the

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A metallurgist wants to gold-plate an object with a surface area of 17.21 in2. The gold plating must be 0.00200 in. thick (assume uniform thickness). (a) How many grams of gold (d=10.5g/cm3) are required? (b) How many minutes will it take to plate the object from a solution of AuCN using a current of 7.00 A? Assume 100% efficiency.
a Calculate G for the following cell reaction: Tl(s)Tl+(aq)Pb2+(aq)Pb(s) The Gf for Tl+(aq) is 32.4 kJ/mol. b From G, calculate the standard cell potential for the cell reaction and from this, determine the standard potential for Tl2+(aq)+eTl(s).
Consider a voltaic cell in which the following reaction occurs. Zn(s)+Sn2+(aq)Zn2+(aq)+Sn(s) (a) Calculate E° for the cell. (b) When the cell operates, what happens to the concentration of Zn2+? The concentration of Sn2+? (c) When the cell voltage drops to zero, what is the ratio of the concentration of Zn2+ to that of Sn2+? (d) If the concentration of both cations is 1.0 M originally, what are the concentrations when the voltage drops to zero?
Consider a concentration cell that has both electrodes made of some metal M. Solution A in one compartment of the cell contains 1.0 M M2+. Solution B in the other cell compartment has a volume of 1.00 L. At the beginning of the experiment 0.0100 mole of M(NO3)2 and 0.0100 mole of Na2SO4 are dissolved in solution B (ignore volume changes), where the reaction M2+(aq)+SO42(aq)MSO4(s) occurs. For this reaction equilibrium is rapidly established, whereupon the cell potential is found to be 0.44 V at 25C. Assume that the process M2++2eM has a standard reduction potential of 0.31 V and that no other redox process occurs in the cell. Calculate the value of Ksp for MSO4(s) at 25C.
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Zn|Zn2+(0.50M)Cd2+(0.020M)|Cd (b) Cu|Cu2+(0.0010M)H+(0.010M)|H2(1.00atm)|Pt
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Cu|Cu+(0.80M)Hg22+(0.10M)|Hg|Pt (b) Cr|Cr3+(0.615M)Ni2+(0.228M)|Ni
The saturated calomel electrode. abbreviated SCE. is often used as a reference electrode in making electrochemica1 measurements. The SCE is composed of mercury in contact with a saturated solution of calomel (Hg2Cl2). The electrolyte solution is saturated KCI. is +0.242 V relative to the standard hydrogen electrode. Calculate the potential for each of the following galvanic cells containing a saturated calomel electrode and the given half-cell components at standard conditions. In each case. indicate whether the SCE is the cathode or the anode. Standard reduction potentials are found in Table 17.1. a. Cu2++2eCu b. Fe3++e-Fe2+ c. AgCl+e-Ag+Cl- d. Al3++3eAl e. Ni2++2eNi
The measurement of pH using a glass electrode obeys the Nernst equation. The typical response of a pH meter at 25 00C is given by the equation where contains the potential of the reference electrode and all other potentials that arise in the cell that are not related to the hydrogen ion concentration. Assume that = 0.250 V and that a. What is the uncertainty in the values of pH and [H+] if the uncertainty in the measured potential is 1 m V ( 0.001 V)? b. To what precision must the potential be measured for the uncertainty in pH to be 0.02 pH unit?