q9 On which of the following the air density factor used in transmission line corona does not depends?:O a. Air PressureO b. EnvironmentO c. TemperatureO d. Voltage

In this we will find air density factor dependence....

Answered: On which of the following the air…

On which of the following the air density factor used in transmission line corona does not depen O a. Air Pressure O b. Environment O c. Temperature O d. Voltage

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.47P

See similar textbooks

Related questions

Q: 13.) In practice, what would happen to the transmission line voltage when it is heavily loaded and…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: A transmission line has a characteristic impedance of 50 ohm and a line resistance of 0.1 ohm/m. If…

A: Since the transmission line is distortion less, the attenuation constant of the line can be…

Q: e)Draw the single line diagram of AC and DC transmission. Compare both of them and draw conclusion…

Q: Incoming and outgoing lines in a substation are connected to a Busbar. Select one: True False

A: Choose the correct option The given Statment Incoming and outgoing lines in a substation are…

Q: Consider the transmission line circuit shown in the accompanying figure. Compute the incident power,…

A: It is being given that : The length of the line : l=λ2 Generator Voltage : Vg=10 V Generator…

Q: The transmission line has the following data weight of the conductor = 6.5 kg/m, Tension in the…

A: For the given sag condition need to find the distance between the towers

Q: If a transmission line has Zc =200 0 and the line voltage3D400 kV, then its SIL in MW is: Answer:

Q: Find the amplitude of the line voltage at the load in the given circuit

A: Find the amplitude of the line voltage at the load in the given circuit

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span of transmission line is given span =150 m Height is given h = 16 m Ground clearance = 90 %

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: As given in the question transmission line (L) = 150 Height from the bottom is = 10 meter…

Q: While studying the performance of medium transmission linos, only resistance and of the line are…

A: Given About the performance of the medium transmission line

Q: Q) A transmission line of length 0.40A has a characteristic impedance of 100 n and is terminated in…

Q: The transmission line has the following data weight of the conductor = 8.1 kg/m, working tension =…

A: sag in transmission line is given as ,sag(s)= wl28TWhere w is weight , l is length and T is tension

Q: a) Certain measurements made at 5 kHz on a half kilometer long transmission line. The results show…

A: Given, length of transmission line, l = 0.5 km Frequency, f = 5kHz Characteristic impedance, zo=…

Q: A transmission line has a span of length 250 m and the weight of the conductor per metre length is…

A: The solution can be achieved as follows.

Q: :A 502 lossless transmission line of 1.622 length is terminated with (70-j70)Q load. Find: (a) VSWR,…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.…

Q: An antenna having an impedance of Z̟ = (450 - j600)N is connected to a transmission line that have…

A: Given,ZL=(450-j600)ΩZ0=300 Ωlet f=10 MHzSo, λ=vf=3*108107=30mNow,ZL=ZL…

Q: The transmission line has the following data weight of the conductor = 8.9 kg/m, Tension in the…

A: The given tension is, T=1702 kg The weight of the conductor is, W=8.9 kg/m The sag is 5.1 m

Q: Match a load of ZL=120+80j Ω to a Z0=100 Ω transmission line using a shunt single stub if the stub…

Q: For medium transmission line under light load or no load condition the receiving end voltage is…

Q: An overhead transmission line has a span of 260 m. The weight of the conductor is 0.68 kg/m. The…

A: Given an overhead transmission line has, Span, l = 260 m Weight of the conductor, w = 0.68 kg/m…

Q: A long transmission line of 370 N surge impedance is connected to two cables each of surge impedance…

A: According to question we have to calculate the value of junction voltage, current wave and voltage…

Q: What are the factors which governs the performance of transmission line?

A: There are totally 4 parameters which includes Resistance, Inductance, Capacitance and Shunt…

Q: 4. A double-circuit, single-phase transmission line is shown below. Find the inductance per meter of…

Q: In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase…

A: Choose the correct option In the analysis of short transmission line, the lines should be in which…

Q: Current through the line Sending end voltage Sending end power factor Regulation of transmission…

Q: *:Characteristic impedance of a transmission line is reciprocal of admittance of a transmission line…

A: The characteristics impedance is the impedance of the line it would exhibit if the line is of…

Q: Voltage regulation of a transmission line should be O a. as low as possible O b. None of the answers…

Q: What is the input impedance of a 50 Ω short-circuit transmission line of length λ ⁄ 8, in ohms?

Q: The transmission line has the following data weight of the conductor = 8.2 kg/m, Tension in the…

A: Given, Weight of the conductor(w)=8.2 kg/m Tension in the conductor(T)=1765 kg Conductor sag(S)=4.2m…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

A: A given locus diagram is redrawn below, When point N and point B connected, it makes the angle 45o…

Q: 1. Three conductors for a 3-phase 60 Hz transmission line are placed in a horizontal plane with…

A: We will use formula of inductance to find distance between phase conductors.

Q: The inductive reactance of the line conductor is 67 2 per km, then the inductance of the conductor…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: The transmission line has the following data weight of the conductor = 7.9 kg/m, working tension =…

Q: The transmission line has the following data weight of the conductor = 8.2 kg/m, working tension =…

A: sag in transmission line ,sag(s) = wl28T

Q: 05/ A transmission line over a hillside where the angle is (0 = 2.2924°), is supported by two 22 m…

Q: 1. In a transmission line terminated in a load, a rectangular pulse of 30 ns duration is introduced…

Q: The 50 ohm transmission line isterminated with an unknown load. The magnitude of the reflection…

A: Transmission line

Q: Show that VSWR for a transmission line will have values between 1 and infinity.

A: Although expression of standing wave ratio ‘S’

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span is 150 m Height of the tower is 16 m Ground clearance is 95% of the tower of height.

Q: Q1/ What is the cause of low and high voltages in electrical transmission lines from the receiving…

A: Given: Low and high voltage in electrical transmission lines

Q: For the network shown, determine Z; if loss = 12 mA, Yos = 40

A: here network is given that can be converted to small signal AC network for finding the Zin as

Q: A transmission line has a characteristic impedance of 300 N and is terminated in a load of 300 -…

Q: For the given power transfer, a star system is associated with larger line currents and a delta…

A: Given statement, For the given power transfer a star system is associated with large line currents…

Q: Question # 3 90 A 20.5-m lossless transmission line is terminated by a load which is located at P on…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: Consider the diagram shown in Figure below

Q: Company Y would like to have a new installation transmission line to open a small new city consist…

A: Given Vr=132 kV Po=300 MW cos (ϕr)=0.85 f=50Hz

Q: A transmission line has a span of 150m between level supports of 18 meter height. The ground…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

On which of the following the air density factor used in transmission line corona does not depends?:
O a. Air Pressure
O b. Environment
O c. Temperature
O d. Voltage

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The transmission line has the following dataweight of the conductor = 8.2 kg/m, working tension = 1765 kg, and the conductor sag = 4.2 meter, then the distance between the towers is ....................
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
Q..transmission line,,
Assuming the wire in Question 1 is solid and used in a single phase transmission line separated at 0.5 m from each other, what is the total inductance of the line in mH/km?
Determine the load voltage for the transmission line shown below.
the air-filled two-wire line has a characteristic impedance of 50 Ω and is operated at f = 3GHz .the load is ZL= 100 +j40Ω . for the line above, calculation ZL on the chart the line impedance 2.5 cm from the load , the admittance, the VSWR on the line, and distance from the load to the first voltage minimum and maximum.
A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90 mm and the distance between the conductors and phase is 40 cm and 9 m, respectively. What is the inductance of the line per phase? A. 2 μH/m B. 4 μH/m c. 1 μH/m D 3 μH/m
A single-phase transmission line is composed of two solid round conductors having aradius of 0.45cm each. If the conductors are spaced 3.5m, calculatea. the value of the inductance per conductorb. the inductance of the line
3-phase line has conductors 4 cm in diameter spaced equilaterally 2 m apart. If the dielectric strength of air is 29 kV (max) per cm, find the disruptive critical voltage for the line. Take air density factor =0.952 and irregularity factor mo = 0.9.
q12/ choose the correct answer The transmission line has the following dataweight of the conductor = 4.1 kg/m, working tension = 1342 kg, and the conductor sag = 2.7 meter, then the distance between the towers is .................... a- 59.46 M b- 344.74 M c- 84.08 M d- 72.82 M
a single-phase transmission line has two parallel conductors, 1.5 meters apart. the radius of each conductor is 0.3 cm. calculate the inductance per meter of the line.
In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase connection? A. STAR B. CONSTELLATION C. MESH D. DELTA