Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank is accelerated along its length on a horizontal truck at a constant value of 2.5 m/s?, determine pressure at the bottom of the tank at front and rear edges (in kN/m²). (take y=9.8 kN/m³ for water)

Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank is accelerated along its length on a horizontal truck at a constant value of 2.5 m/s?, determine pressure at the bottom of the tank at front and rear edges (in kN/m²). (take y=9.8 kN/m³ for water)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: 3) If the pressure in pipe A is decreased by 25 kPa, and the pressure in B increased by 10 kPa. 4)…

Q: 2. A vertical, triangular gate with water on one side is shown in Figure. Determine the total…

A: To find: The total resultant force acting on the gate and location of the center of pressure. Given:…

Q: 1. A vertical parabolic plate whose height is 2 meters is submerged in a certain liquid (s.g. =…

Q: In a stationary fluid, The pressure head at same depth inside the fluid with decrease in density of…

A: Pascal's law (moreover Pascal's guideline or the rule of transmission of fluid-pressure) may be a…

Q: 2. A vertical, triangular gate with water on one side is shown in Figure. Determine the total…

A: Given:Width of the traingular gate, b=2 mheight of the triangular gate, h=3 m

Q: The curved surface given in the figure is defined by y = 3 x−−√x . Determine the horizontal force…

Q: EX 4: Derive an expression for the capillary- height change h, as shown, for a fluid of surface…

A: Let Y= surface tension of the liquid θ=Angle of contact between liquid and plates Weight of the…

Q: In the hydraulic jack shown, a force of 100 N is exerted on the small piston. Determine the upward…

A: It is very basic question of fluid mechanics. Used concept is Pascal law .

Q: Q4/ A4-m-long curved gate is located in the side of a reservoir containing water as shown in Fig.…

Q: If it is known that the air velocity in the duct is 750 ft/s, usethe mercury manometer measurement…

Q: The closed tank shown, which is full of liquid, is accelerated downward at 23 g and to the right at…

A: To find out the pressure gradient -∇⇀ P-Sg K⇀=Sa⇀ -(∂P∂xi⏞+∂P∂yj⏞+∂P∂zk⏞ ) -Sgk⇀…

Q: A closed cylinder of diameter 30 cm and height 20 cm is completely filled with water. Calculate the…

Q: A 3-m-diameter, 7-m-long cylindrical tank is completely filled with water. The tank is pulled by a…

A: Consider the diagram shown below for the cylindrical tank.

Q: A fish tank that contains 60 cm high water is moved in the cabin of elevator. Determine the pressure…

Q: Q4. Balloons are often filled with helium gas (Figure 4) because it weighs only about one-seventh of…

Q: The truck carries an open rectangular container that is 3.9m wide, 3.0m deep and 5.0m long, contains…

A: Givenwidth of the tank w=3.9mdepth of the tank d=3mlength of the tank L=5mdensity of oil…

Q: A Sluice gate is a device that is fitted in a sluice or fluid canal to operate and control the fluid…

A: We need to calculate the hydrostatic force acting on the sluice gate

Q: bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The…

Q: 24: A manometer of the shape shown in the figure has limb A filled with water and the limb B with…

Q: An open settling tank shown in the figure contains a liquid suspension. Determine the resultant…

A: Consider the small element of dy along the y-direction in the profile. θ=600

Q: An open tank 2 m x 4 m rectangular horizontal section has a negligible weight and contains water to…

A: New unbalanced force will be equal to (mass)*(new acceleration) To find new acceleration, we will…

Q: The hydraulic lift in a car repair shop has an output diameter of 30 cm and is to lift cars up to…

Q: A fish tank that contains 60 cm high water is moved in the cabin of elevator. Determine the pressure…

Q: A long solid cylinder of radius 0.8 m hinged at point A is used as an automatic gate, as shown in…

Q: H.W.2/: The bottom quarter of a vertical cylindrical tank of total height 0.4 m and diameter 0.3 m…

A: Radius = R = D/2 = 0.3/2 = 0.15 m

Q: The distance between the centers of the two arms of a U-tube open to the atmosphere is 30 cm, and…

Q: Find the location of resultant force( F)of the water on the triangular gate and the force(P)…

A: The force on a plate that is fully submerged in water can be evaluated using the formula given below…

Q: Consider two water tanks filled with water. The first tank is 8 m high and is stationary, while the…

A: Given: The height of the first tank is H=8 m. The height of the second tank is h=2 m. The…

Q: long, 2m deep and 3 m wide contains oil of relative density 0.9 to a depth of 0.9 m. If the tank is…

Q: SS 3-35 An open tank is filled with water to the depth indicated. Atmospheric pressure acts on all…

Q: The density of a floating body can be determined by tying weights to the body until both the body…

Q: The apparatus constructed by Eugenijus Umezius and Timothy Gasperich is hown in the figure. When…

A: Given Data⇒ h=8 cm=0.08 m h=9 cm=0.09 m

Q: A U-tube is made up of two capillaries with bores of 0.0039 ft and 0.0078 ft. A liquid with a…

A: Answer: The density of the liquid is 943.2875 kg/m3.

Q: open deep specific gravity 0.85 to a depth of 1.4 m. If the tank is accelerated along its length on…

Q: Balloons are often filled with helium gas because it weights only about one seventh of what air…

A: The volume of the balloon can be determined as,

Q: vessel cylindrical in shape and closed at the top and bottom is 300 mm in diameter, 1 m long and…

Q: The maximum diameter that a capillary tube can have to ensure that a capillary rise of at least 6 mm…

A: Given, Capillary rise = h = 6 mm = 0.006 m Surface tension = σ = 0.08 N/m Density = ρ = 900 kg/m3…

Q: Balloons are often filled with helium gas because it weighs only about one-seventh of what air…

A: Given data: The expression for buoyancy force, Fb = ρairgVballon. The diameter of balloon, d = 12…

Q: Open tank (4.5 m long. 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this…

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

A: Given, S = 0.8 L x B x H = 4 x 3 x 3 h = 1.5 m ax = 2.5 m/s2

Q: A 30-cm-diameter, 10-cm-high vertical cylindrical vessel equipped with a vertical tube at the edge…

A: Write the given information.

Q: What is the difference between the total pressure of an aircraft flying at sea level, and an…

A: Solution: The diagram representing the given situation is shown below:

Q: 35. An open tank 5m long, 2m deep and 3 m wide contains oil of relative density 0.9 to a depth of…

A: Given -L = 5 m , d = 2m , w = 3m , ax = 3m/s2S.G = 0.9 →δ= 1000 x 0.9 = 900 kg/m3

Q: In the figure, the water level in a 1.8 m high and 0.9 diameter cylindrical tank is 1.4 m. If this…

A: Given data: Height of the water in the tank (h1) = 1.4 m Height of the tank (h2) =1.8 m Radius of…

Q: The open tank filled with a liquid in full as shown in the figure below has the height of h = 6.00…

A: Height of water, h=6.00 mInclined angle of the wall, θ=45.00oThe width of the wall, w=20.00 mThe…

Q: 47. Determine the absolute pressure required to push the column of water to 2m height. Assume…

Question

100%

Need Solution through 15min

Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S=0.8) to height
1.5 m. If this tank is accelerated along its length on a horizontal truck at a constant
value of 2.5 m/s², determine pressure at the bottom of the tank at front and rear
edges (in kN/m²). (take y-9.8 kN/m³ for water)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Open tank (4.5 m long, 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this tank is accelerated along its length on a horizontal truck at a constant value of 3.5 m/s, determine pressure at the bottom of the tank at front and rear edges (in kN/m). (take y=9.8 kN/m for water)
The water in a 25-m-deep reservoir is kept inside by a 90-m-wide wall whose cross section is an equilateral triangle. Determine (a) the total force (hydrostatic + atmospheric) acting on the inner surface of the wall and its line of action and (b) the magnitude of the horizontal component of this force. Take Patm = 100 kPa.
A tank of water 4 m deep receives a constant upwardacceleration a z . Determine ( a ) the gage pressure at the tankbottom if a z = 5 m 2 /s and ( b ) the value of a z that causes thegage pressure at the tank bottom to be 1 atm.
A closed tank rectangular in plane with vertical sides is 1.8m deep and contains water to a depth of 1.2m. Air is pumped into the space above the water until the air pressure is 35kN/m2. If the length of one wall of the tank is 3m, determine the resultant force on this wall and the height of the centre of pressure above the base
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m^3.
A water tank, open at the top, consists of a right circular cylinder and a right circular cone, as shown. If the altitude of the cylinder is three times its radius, and the altitude of the cone is two times the same radius, find the altitude of the cylinder (1 gal=231 cu. in.).
For the tank of water shown below, the radius of the circular surface is R=1.0 m, h=1.0m, and the length of the tank is w=2.0 m. Determine (3) the magnitude of the vertical force force exerted on the whole curved surfaces_________kN
For the tank of water shown below, the radius of the circular surface is R=1.0 m, h=1.0m, and the length of the tank is w=2.0 m. Determine (1) the correct expression of the area magnitude whose volume weight is equivalent to the vertical force exerted on the whole curved surfaces_________
An open tank containing water is accelerated vertically at 5.8 If the motion is downward with positive acceleration, determine the pressure (kPa) 1.85 m below the surface.
Q4: The hydraulic lift in a car repair shop has an output diameter of 30 cm and is to lift cars up to 2000 kg. Determine the fluid gage pressure that must be maintained in the reservoir.
A gasoline line is connected to the pressure gage through a double-U manometer, as shown in the figure. If the reading of the pressure gage is 370 kPa, determine the gage pressure of the gasoline line.6)
How long will it take the water surface in the tank shown to drop from h = 3 m to h = 50 cm?