P 6: Two soil of same cross sectional and length, a constant head test is performed on the soils as shown in fig below if the k of soil 2 is 4-timek of soil 1, find the • the total heads (ht) at points A, B, C, • the hydraulic gradient (i) for both soils, • the flow rate q in cm3/sec. Answer: ht(B) = 98 cm 30cm 40cm Soil 1 90 cm 40cm Soil 2 C Datum 20сm B.

P 6: Two soil of same cross sectional and length, a constant head test is performed on the soils as shown in fig below if the k of soil 2 is 4-timek of soil 1, find the • the total heads (ht) at points A, B, C, • the hydraulic gradient (i) for both soils, • the flow rate q in cm3/sec. Answer: ht(B) = 98 cm 30cm 40cm Soil 1 90 cm 40cm Soil 2 C Datum 20сm B.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.6P

See similar textbooks

Similar questions

Refer to the figure. If H1 = 1.94 m, H2 = 2.37 m, h = 1.c m, e =0.49, Gs = 2.67,area of the tank = 0.64 m2, and hydraulic conductivity of the sand (k) = 0.3d cm/sec. What is the upward seepage force per unit volume of soil?
GIVEN THE FOLLOWING FOR A FULLY SATURATED SOIL: n=0.28 and Gs = 2.5 FIND THE WATER CONTENT. USE yw = 9.81 KN/(m^3). Use soil Mechanics
For a sandy soil with Gs 2.68, calculate the critical hydraulic gradient that willcause boiling or quick condition for e 0.38, 0.48, 0.6, 0.7, and 0.8. Plot thevariation of icr with the void ratio.
A soil sample 15 cm in diameter is placed In a tube 2 m long. A constant supply of water is allowed toflow into one end of the soil at A and the outflow at B is collected by a beaker. The average amount ofwater collected is 2 cubic centimeter every 5 seconds. The tube is inclined and has a head differenceof 2.5 m. Determine the following 1. Hydraulic Gradiant. 2. Flowrate in cm/s. 3. Discharge Velocity in cm/s. 4. Seepage velocity in cm/s if porosity is 0.420. 5. Hydraulic Conductivity.
Illustrated laboratory setup includes a column of homogenous soil with a square cross-section area of 25 cm2. A constant head difference is applied for the setup. Assume continuous, steady-state flow in a fully saturated medium, and all head loss occurs in the soil. Points A, B, and C are located as shown in the figure. The saturated unit weight of sand is 18 kN/m3. a) Determine the elevation, pressure and total head at Points A and B.b) Determine the hydraulic gradient.c) Determine the total amount of flow per minute if k = 10 cm/mind) Show the direction and calculate the seepage force acting on plane x-x.e) Calculate the effective stress along the plane parallel to the direction of flow assuming that the total stress along that direction is 25 kPa at Point C.
Given: velocity of flow = 0.0375 m/s coefficient =0.05 m/s porosity p =48% slope S = 3/4 The soil porosity in the area where the 46-cm diameter well is 48%, find the discharge of the groundwater. Given the discharge Q get in Question #1, transmissibility T in Question#2, slope S = 3/4; find the aquifer width X.
Given: velocity of flow = 0.0375 m/s coefficient =0.05 m/s porosity p =48% slope S = 3/4 The soil porosity in the area where the 46-cm diameter well is 48%, find the discharge of the groundwater. Given the coefficient =0.05 m/s and porosity p =48%, find the transmissibility (T) in m/s per unit m, if the aquifer width is 1.2 m. Given the discharge Q get in Question #1, transmissibility T in Question#2, slope S = 3/4; find the aquifer width X.
A soil profi le consists of a clay layer underlain by a sandlayer, as shown in Figure P7.17. If a tube is inserted intothe bottom sand layer and the water level rises to 1 mabove the ground surface, determine the vertical effective stresses and porewater pressures at A, B, and C. IfKo is 0.5, determine the lateral effective and lateral totalstresses at A, B, and C. What is the value of the porewater pressure at A to cause the vertical effective stressthere to be zero?
A soil sample 10 cm in diameter is placed in a tube 1.2 m long. A constant supply of water is allowed to flow into one end of the soil at A and the outflow at B is collected by a beaker. The average amount of water collected is 2 cm3 for every 10 seconds. Determine the hydraulic gradient. Ans: 0.667
Q:5 a)Find out the flow rate from a soil when hydraulic conductivity is 2.5x10^-3 cm/sec while the length of soil sample is 11 cm, dia of soil sample is 5 cm, change in head observed is 3 cm.
A clay layer 5 m thick has double drainage. It was consolidated under a load of 127.5 kN/m2. The load is increased to 197.5 kN/m2. The coefficient of volume compressibility is 5.79 × 10^–4 m2/Kn and value of k = 1.6 × 10^–8 m/min. Find settlement in cm at 50% consolidation. a.25.78 b.10.32 c.32.56 d.20.27
How to solve this question? A soil has a dry density of 1.84 g/cm3 and void ratio of 0.45. Calculate the factor of safety against quick sand condition if the hydraulic gradient is given as 0.46.