PART E #2 A simple circuit is constructed such that 249.1 Volts is measured across a resistor. The current flowing through the resistor is 6.31 Amperes. What is the magnitude of resistance of the resistor? Round off your answer to a whole number with NO decimal digit. ( Example 34, 5, 120) Answer:

PART E #2 A simple circuit is constructed such that 249.1 Volts is measured across a resistor. The current flowing through the resistor is 6.31 Amperes. What is the magnitude of resistance of the resistor? Round off your answer to a whole number with NO decimal digit. ( Example 34, 5, 120) Answer:

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Similar questions

A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
Consider the circuit below, (a) What is the initial current through resistor R2? when the switch is closed? (b) What is die current through resistor R2 when the capacitor is fully charged, long after die switch is closed? (c) What happens if the switch is opened after it has been closed for some rime? (d) If the switch has been closed for a time period long enough for the capacitor to become fully charged, and then the switch is opened, how long before the current through resistor R1 reaches half of its initial value?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Considering the same circuit, only with the switch thrown from b to a at time t = 0 after having been in position b for a long time. DATA: Vb = 12 V, C = 10 µF, R = 20 Ω.a.) What is the curnent through the resistor just BEFORE the switch is thrown?b.) What is the current through the resistor just AFTER the switch is thrown?c.) What is the charge across the capacitor just BEFORE the switch is thrown?d.) What is the charge on the capacitor just AFTER the switch is thrown?e.) What is the charge on the capacitor at at time t = 0.3 msec after the switch is thrown?
Hi, I have a question regarding electromagnetism. The question is as follows: An aluminum rod has a resistance of 1.590 Ω at 20.0°C. Calculate the resistance of the rod at 102°C by accounting for the changes in both the resistivity and the dimensions of the rod. The coefficient of linear expansion for aluminum is 24.0 ✕ 10-6 (°C)−1.
The figure below shows a capacitor, with capacitance C = 35.0 µF, and a resistor, with resistance R, = 57.5 kΩ, connected in series to a battery, with = 31.0 V.The circuit has a switch, which is initially open. a) What is the circuit's time constant (in s)? b)After the switch is closed for one time constant, how much charge (in C) is on the capacitor?
A coffee maker is rated at 1200 W, a toaster at 1100 W,and a waffle maker at 1400 W. The three appliances are connectedin parallel to a common 120 - V household circuit. (a)What is the current in each appliance when operating independently?(b) What total current is delivered to the applianceswhen all are operating simultaneously? (c) Is a 15 - Acircuit breaker sufficient in this situation? Explain.
Consider his circuit, which has C = 0.50 F and L = 0.20 H. With the switchopen, the capacitor is charged up using a 2V battery. The battery is then removed. Then,at time t=0, the switch is closed. a) What is the earliest time, after t=0, when the capacitor has no charge on it? m
A man wishes to vacuum his car with a canister vacuumcleaner marked 535 W at 120. V. The car is parked far fromthe building, so he uses an extension cord 15.0 m long toplug the cleaner into a 120. - V source. Assume the cleaner hasconstant resistance. (a) If the resistance of each of the twoconductors of the extension cord is 0.900 Ω, what is the actualpower delivered to the cleaner? (b) If, instead, the power is tobe at least 525 W, what must be the diameter of each of twoidentical copper conductors in the cord the young man buys?(c) Repeat part (b) if the power is to be at least 532 W. Suggestion:A symbolic solution can simplify the calculations.
An electrician wishes to cut a copper wire (ρ=1.72×10-8 Ωm) that has 10Ω of resistance. The wire has a radius of 0.625mm. Approximately what length of wire has a resistance equal to the maximum 10Ω ? The length of the copper wire having a resistance of 10Ω is = ? m b) Calculate the gravitational force between the earth and the moon, if the mass of the earth is 5.98×1024 kg and the mass of the moon is 7.36 ×1022 kg. The mean distance between the earth and the moon is 3.85 ×108 m and the universal gravitational constant G = 6.67 ×10-11 Nm2/kg2. The gravitational force between the earth and the moon is= ? N
The compressor on an air conditioner draws89.1 A when it starts up. The start-up time isabout 0.243 s.How much charge passes a cross-sectionalarea of the circuit in this time?Answer in units of C.
A portable CD player uses a current of 7.5 mA at a potential difference of 3.5 V. (a) How much energy does the player use in 35 s?(b) Suppose the player has a mass of 0.65 kg. For what lengthof time could the player operate on the energy required to lift itthrough a height of 1.0 m?