PLEASE ANSWER IT IMMEDIATELY A 10 pole, 400 kW, 250 V, dc generator has a lap wound armature with 75 slots each having 12 conductors. The cross-section of each conductor is 2mm x 17.5 mm. If the average length of one turn is 150 cm. Find its armature resistance, assume specific resistance of 2 x 10 ^-6ohm-cm.

Q: Question RF carrier 10 kV at 1 MHz is a amplitude modulated and modulation index is 0.6. peak…

A: This is a problem of amplitude modulation. The solution is given in the next step.

Q: R₁ = 52 દે 1₁ род ↑ Vab Va R₂= гол 4 A

A:

Q: 3. EMG electrodes are placed in a muscle and the following circuit diagram shows their simplified…

A:

Q: Example 12.36. A capacitor of capacitance 10 uF has a loss angle of 10° at 50 Hz. Find (i) power…

A: Given: C =10 μfδ = 10∘f = 50 Hz Find:. Power Factor Angle φcPower Factor cosφc

Q: A semiconductor with a concentration of electrons 3 x 10¹9/m³ At a temperature of 300 K if arsenic…

A:

Q: When a set of electrical drawings is needed to get a permit, the drawings must include A. switch…

A:

Q: For the op-amp shown in the following figure, if R1 = 100 2 and Rf 1 k2, the overall voltage gain is…

A:

Q: Prove the following relationship mathematically between the steps of the solution in detail:

A: It is Given that: Proof of N=NCexp-Eg2kT

Q: For this system The heater is off when Comparator Reference value T Та Error signal (Td-Ta) • TaTd…

A:

Q: 5. Determine the total resistance if each R is 30. O RT M -W

A:

Q: 2. Using source transformation, find ix. 100V (+ 52 M 105 M 12A dix 85 M 452 (64V

A:

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Introduction: The term IoT or Internet of Things refers to a collective network of connected devices…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: We need to find out the zener diode impedance for change in current and change in voltage .

Q: A transformer having 1000 primary turns is connected to a 250 V a.c. supply for a secon- dary…

A: Given a transformer with, Primary turns, N1=1000. Primary supply voltage, V1=250 V. Secondary supply…

Q: The output voltage from an amplifier is 4V. If the voltage gain is 27 dB, calculate the value of the…

A: Voltage = 4V Voltage gain = 27 dB We have to determine the value of the input voltage assuming that…

Q: n = p = n₁ = √N₁N₁ exp(- Ec N₂ 2KT

A: We need to prove the given electron and hole concentration equation for semiconductor .we will use…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given: For a certain zener diode, rated zener voltage, Vz=12 V. Change in zener current, ∆Iz=10 mA.…

Q: 6. Determine Vo using mesh analysis. 30V 24V(± 182 M Il 922² + +- 14 1022 12 122 2052 M 13 +48V

A: According to kvl the sum of voltages in a closed it mesh is equal to zero

Q: 05. If a latching current for the circuit shown in figure is 2 mA. Obtain the value of minimum width…

A: Given circuit: Latching current for the circuit, IL=2 mA.

Q: R R 메디 10 24 B R Q K R K Clock)

A:

Q: A circuit comprises a 50 resistor, a 5 mH inductor and a 0.04µF capacitor. Determine, in the…

A:

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of Voc Calculate…

A: We need to design the clamper circuit and we need to find average value and swing for output voltage…

Q: 3. Find the value of V if the current in the 3 ohm resistor=0. ww www 1 ohm 3 ohm 5V >2 ohm 5 ohm 4…

A: Solution !! Explanation: Taking the mesh currents in the three meshes as I1, I2 and I3, the mesh…

Q: WA (↑ 2 5 lov 15 + VX- 10 SOV

A:

Q: Inverting Op-Amp R₁ R₁ Vo R2 R4 998.48m V R2 R3 9.9844 R1 R4 2.1244 out of phase A(gain) A(gain)…

A:

Q: A dc shunt generator has a critical field resistance of 400 Q at 1200 rpm. Now if the speed of the…

A: Given a dc shunt generator has, Critical field resistance, Rc1=400 Ω. At critical speed, Nc1=1200…

Q: 1. Determine the total resistance and the current along 3 ohms in downward direction. 50V + 65 M 85…

A:

Q: 1. For the motor load, torque -speed curve shown below, solve the following questions. R 2. T (N-m)…

A:

Q: Solve the average power and dc voltage. What will be the average power if we take the 5-ohm bulb…

A:

Q: A transformer works at 6 KVA with a primary voltage of 82 V. If the load voltage is 235 V ,then the…

A: Given: A transformer works at, Rated apparent power, S=6 kVA. Primary voltage, V1=82 V. Secondary…

Q: 1. Consider the circuit element shown below, where v(t) 6 cos(3t). √8 cos(3t-45°) and i(t) (d) Find…

A: Given data, Voltage vt=8cos3t-450. Current, it=6cos3t.

Q: A circuit comprises a 50 resistor, a 5 mH inductor and a 0.04µF capacitor. Determine, in the…

A:

Q: Series Circuit Measured (Provide all necessary pictures/screenshots from the software.) 1. Connect…

A: DC Power Supply (Vs) = 15 V R1 = 10 ohms R2 = 50 ohms R3 = 75 ohms All the resistors are connected…

Q: A force (Ft) per unit charge (Qt) gives the potential difference (V) True O False O

A:

Q: If the message signal has the following shape in the frequency domain (see diagram on next page),…

A: Given: Spectrum of message signal To do: We have to draw the spectrum of i) AM DSBFC ii) AM DSBSC…

Q: 1. Find the value of the currents 11, 12 and 13 flowing clockwise in the first, second and third…

A: The mesh equation can be obtained by applying kirchhoff's voltage law to the meshes and then by…

Q: Two point charges of equal magnitude and opposite sign are called electric dipole True O False O

A: In the given question we need to discuss about the electric dipole moment.

Q: IL 300 mH 101A + 100 Q 60 Ω ww TA 1. Determine the Thevenin equivalent circuit seen by the inductor

A:

Q: The line voltage + 7.9 A||||| RA 2.5 A www 48 Ω RB RC www The current through B is twice as much as…

A:

Q: Please write a discussion of results and a conclusion based on the given tables. Thank you very…

A: Inverting amplifier Inverting amplifier provide the amplified output which will be the out of phase…

Q: THEVENIN'S AND NORTON'S THEOREMS Use Thevenin to find the equivalent circuit at terminals a and b.…

A:

Q: Electrical equipment in an office takes a current of 13A from a 240V supply. Estimate the cost per…

A: We need to find out total electricity consumption and total cost of it .

Q: Q.4 A signal_x(t)= K sinc²(t) + L sinc(2t) is used to form another signal y(t)= K ·[1+x(−Lt+M)]…

A: Please find below the answer.

Q: RF carrier 10 kV at 1 MHz is a amplitude modulated and modulation index is 0.6. peak cvoltage of the…

A: The effective voltage in terms of voltage is different from the peak voltage in that it relates to…

Q: Accuracy of an instrument or device is the difference between the indicated value and actual value.…

A:

Q: In a 4 bus,4×4 Y bus matrix the number of non zero elements are 12. Find the number of transmission…

A: Given a 4×4 Y bus matrix. Number of buses, N = 4. Total number of elements = 4×4=16. Total number of…

Q: A coil has an equivalent circuit of inductance 1.5 H in series with resistance 90 ohm. It is…

A:

Q: A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is…

A: Given a transmission line has, Reactance, X=1 pu. Sending end voltage, Vs=1 pu. Receiving end…

Q: The total resistance of two resistors connected in series is 50 ohms. When connected in parallel,…

A:

Q: If the no load secondary voltage of a 1-phase transformer is 232 V and full load secondary voltage…

A: Given: A single phase transformer has following specifications, No load secondary voltage, V2nl=232…

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.